[Federal Register Volume 85, Number 195 (Wednesday, October 7, 2020)]
[Notices]
[Pages 63330-63331]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2020-22200]


-----------------------------------------------------------------------

OFFICE OF THE UNITED STATES TRADE REPRESENTATIVE


Notice of Product Exclusion Extension Amendment: China's Acts, 
Policies, and Practices Related to Technology Transfer, Intellectual 
Property, and Innovation

AGENCY: Office of the United States Trade Representative.

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: On August 20, 2019, at the direction of the President, the 
U.S. Trade Representative determined to modify the action being taken 
in the Section 301 investigation of China's acts, policies, and 
practices related to technology transfer, intellectual property, and 
innovation by imposing additional duties of 10 percent ad valorem on 
goods of China with an annual trade value of approximately $300 
billion. The additional duties on products in List 1, which is set out 
in Annex A of that action, became effective on September 1, 2019. On 
August 30, 2019, at the direction of the President, the U.S. Trade 
Representative determined to increase the rate of the additional duty 
applicable to the tariff subheadings covered by the action announced in 
the August 20 notice from 10 to 15 percent. On January 22, 2020, the 
U.S. Trade Representative determined to reduce the rate from 15 to 7.5 
percent. The U.S. Trade Representative initiated a product exclusion 
process in October 2019, and has granted eight sets of exclusions under 
the $300 billion action. On June 26, July 17, and August 11, 2020, the 
U.S. Trade Representative invited the public to comment on whether to 
extend particular granted exclusions. On September 2, 2020, the U.S. 
Trade Representative announced a determination to extend certain 
previously granted exclusions. This notice announces the U.S. Trade 
Representative's determination to make one technical amendment to a 
previously granted exclusion extension.

DATES: The amendment announced in this notice applies as of September 
1, 2019, and continues through December 31, 2020. This notice does not 
further extend the period for product exclusion extensions. U.S. 
Customs and Border Protection will issue instructions on entry guidance 
and implementation.

FOR FURTHER INFORMATION CONTACT: For general questions about this 
notice, contact Associate General Counsel Philip Butler, Assistant 
General Counsel Megan Grimball, or Director of Industrial Goods Justin 
Hoffmann at (202) 395-5725. For specific questions on customs 
classification or implementation of the product exclusions identified 
in the Annex to this notice, contact [email protected].

SUPPLEMENTARY INFORMATION: 

A. Background

    For background on the proceedings in this investigation, please see 
prior notices including: 82 FR 40213 (August 24, 2017), 83 FR 14906 
(April 6, 2018), 83 FR 28710 (June 20, 2018), 83 FR 33608 (July 17, 
2018), 83 FR 38760 (August 7, 2018), 83 FR 40823 (August 16, 2018), 83 
FR 47974 (September 21, 2018), 83 FR 49153 (September 28, 2018), 84 FR 
20459 (May 9, 2019), 84 FR 43304 (August 20, 2019), 84 FR 45821 (August 
30, 2019), 84 FR 57144 (October 24, 2019), 84 FR 69447 (December 18, 
2019), 85 FR 3741 (January 22, 2020), 85 FR 13970 (March 10, 2020), 85 
FR 15244 (March 17, 2020), 85 FR 17936 (March 31, 2020), 85 FR 32098 
(May 28, 2020), 85 FR 35975 (June 12, 2020), 85 FR 38482 (June 26, 
2020), 85 FR 41658 (July 10, 2020), 85 FR 43639 (July 17, 2020), 85 FR 
44563 (July 23, 2020), 85 FR 48595 (August 11, 2020), and 85 FR 54616 
(September 2, 2020).
    In a notice published on August 20, 2019 (84 FR 43304 (August 20 
notice)), the U.S. Trade Representative, at the direction of the 
President, announced a determination to modify the action being taken 
in the Section 301 investigation by imposing an additional 10 percent 
ad valorem duty on goods of China classified in 3,805 full and partial 
subheadings of the Harmonized Tariff Schedule of the United States 
(HTSUS), with an approximate annual trade value of $300 billion. The 
August 20 notice contains two separate lists of tariff subheadings, 
with two different effective dates. List 1, which is set out in Annex A 
of the August 20 notice, went into effect September 1, 2019. List 2, 
which is set out in Annex C of the August 20 notice, was scheduled to 
take effect on December 15, 2019.
    On August 30, 2019, the U.S. Trade Representative, at the direction 
of the President, determined to modify the action being taken in the 
investigation by increasing the rate of additional duty from 10 to 15 
percent ad valorem on the goods of China specified in Annex A (List 1) 
and Annex C (List 2) of the August 20 notice. See 84 FR 45821. On 
October 24, 2019, the U.S. Trade Representative established a process 
by which U.S. stakeholders could request exclusion of particular 
products classified within an eight-digit HTSUS subheading covered by 
List 1 of the $300 billion action from the additional

[[Page 63331]]

duties. See 84 FR 57144 (October 24 notice). Subsequently, the U.S. 
Trade Representative announced a determination to suspend until further 
notice the additional duties on products set out in Annex C (List 2) of 
the August 20 notice. See 84 FR 69447 (December 18, 2019). The U.S. 
Trade Representative later determined to further modify the action 
being taken by reducing the additional duties for the products covered 
in Annex A of the August 20 notice (List 1) from 15 percent to 7.5 
percent. See 85 FR 3741 (January 22, 2020).
    The U.S. Trade Representative issued a notice setting out the 
process for product exclusions and opened a public docket. In March 
2020, the U.S. Trade Representative announced three sets of exclusions. 
See 85 FR 13970; 85 FR 15244; 85 FR 17936. Additional sets of 
exclusions were published in May, June, July, and August 2020. See 85 
FR 28693; 85 FR 32098; 85 FR 35975; 85 FR 41658; 85 FR 44563; 85 FR 
48627. The exclusions the U.S. Trade Representative granted under the 
$300 billion action expired on September 1, 2020. See 85 FR 13970.
    On June 26, July 23, and August 11, 2020, the U.S. Trade 
Representative invited the public to comment on whether to extend by up 
to 12 months, particular exclusions granted under the $300 billion 
action. See 85 FR 38482; 85 FR 43639; 85 FR 48595. On September 2, 
2020, the U.S. Trade Representative announced a determination to extend 
certain previously granted exclusions. See 85 FR 54616.

B. Technical Amendments to an Exclusion Extension

    The Annex makes one technical amendment to U.S. note 20(jjj)(53) to 
subchapter III of chapter 99 of the HTSUS, as set out in the Annex of 
the notice published at 85 FR 54616 (September 2, 2020).

Annex

    Effective with respect to goods entered for consumption, or 
withdrawn from warehouse for consumption, on or after 12:01 a.m. 
eastern daylight time on September 1, 2019, note 20(jjj)(53) to 
Subchapter III of chapter 99 of the Harmonized Tariff Schedule of 
the United States (HTSUS), is modified by deleting ``Bright C1060 
galvanized round wire, containing by weight 0.6 percent or more of 
carbon, measuring at least 0.034 mm but not more than 0.044 mm in 
diameter'' and inserting ``Bright C1060 round wire, plated or coated 
with zinc, containing by weight 0.6 percent or more of carbon, with 
a diameter measuring 0.034 mm or more but less than 1 mm'' in lieu 
thereof.

Joseph Barloon,
General Counsel, Office of the United States Trade Representative.

Annex

    A. Effective with respect to goods entered for consumption, or 
withdrawn from warehouse for consumption, on or after 12:01 a.m. 
eastern daylight time on September 1, 2019, note 20(jjj)(53) to 
Subchapter III of chapter 99 of the Harmonized Tariff Schedule of 
the United States (HTSUS), is modified by deleting ``Bright C1060 
galvanized round wire, containing by weight 0.6 percent or more of 
carbon, measuring at least 0.034 mm but not more than 0.044 mm in 
diameter'' and inserting ``Bright C1060 round wire, plated or coated 
with zinc, containing by weight 0.6 percent or more of carbon, with 
a diameter measuring 0.034 mm or more but less than 1 mm'' in lieu 
thereof.

[FR Doc. 2020-22200 Filed 10-6-20; 8:45 am]
BILLING CODE 3290-F1-P