[Federal Register Volume 85, Number 89 (Thursday, May 7, 2020)]
[Notices]
[Page 27221]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2020-09704]
=======================================================================
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[FRL-10009-16-ORD]
Ambient Air Monitoring Reference and Equivalent Methods;
Designation of One New Equivalent Method
AGENCY: Environmental Protection Agency (EPA).
ACTION: Notice of the designation of a new equivalent method for
monitoring ambient air quality.
-----------------------------------------------------------------------
SUMMARY: Notice is hereby given that the Environmental Protection
Agency (EPA) has designated one new equivalent method for measuring
concentrations of nitrogen dioxide (NO2) in ambient air.
FOR FURTHER INFORMATION CONTACT: Robert Vanderpool, Air Methods and
Characterization Division (MD-D205-03), Center for Environmental
Measurements and Modeling, U.S. EPA, Research Triangle Park, North
Carolina 27711. Phone: 919-541-7877. Email: [email protected].
SUPPLEMENTARY INFORMATION: In accordance with regulations at 40 CFR
part 53, the EPA evaluates various methods for monitoring the
concentrations of those ambient air pollutants for which EPA has
established National Ambient Air Quality Standards (NAAQS) as set forth
in 40 CFR part 50. Monitoring methods that are determined to meet
specific requirements for adequacy are designated by the EPA as either
reference or equivalent methods (as applicable), thereby permitting
their use under 40 CFR part 58 by States and other agencies for
determining compliance with the NAAQS. A list of all reference or
equivalent methods that have been previously designated by EPA may be
found at http://www.epa.gov/ttn/amtic/criteria.html.
The EPA hereby announces the designation of one new equivalent
method for measuring concentrations of NO2 in ambient air.
This designation is made under the provisions of 40 CFR part 53, as
amended on October 26, 2015(80 FR 65291-65468).
The new equivalent method for NO2 is an automated method
(analyzer) utilizing the measurement principle based on cavity-
attenuated phase-shift (CAPS) spectroscopy. This newly designated
equivalent method is identified as follows:
EQNA-0320-256, ``Teledyne Advanced Pollution Instrumentation, Model
N500 Cavity-Attenuated Phase-Shift (CAPS) spectroscopy Nitrogen Oxides
Analyzer'', operated on any full scale range between 0-0.5 ppm, at any
operating temperature from 0 [deg]C to 40 [deg]C, with a sample
particulate filter and in accordance with the Model N500 CAPS
NOX Analyzer User Manual, and with or without any of the
following options: Zero/Span valves, internal Zero/Span permeation oven
(IZS), Analog Output expansion board, Digital I/O expansion board,
external communication and data monitoring interfaces; and the
NumaViewTM software. Note 2 applies to the Teledyne Advanced
Pollution Instrumentation, Model N500.
This application for an equivalent method determination for this
NO2 method was received by the Office of Research and
Development on January 21, 2020. This analyzer is commercially
available from the applicant, Teledyne API, 9970 Carroll Canyon Road,
San Diego, CA 92131.
A representative test analyzer was tested in accordance with the
applicable test procedures specified in 40 CFR part 53, as amended on
October 26, 2015. After reviewing the results of those tests and other
information submitted by the applicant, EPA has determined, in
accordance with part 53, that this method should be designated as an
equivalent method.
As a designated equivalent method, this method is acceptable for
use by states and other air monitoring agencies under the requirements
of 40 CFR part 58, Ambient Air Quality Surveillance. For such purposes,
this method must be used in strict accordance with the operation or
instruction manual associated with the method and subject to any
specifications and limitations (e.g., configuration or operational
settings) specified in the designated method description (see the
identification of the method above).
Use of the method also should be in general accordance with the
guidance and recommendations of applicable sections of the ``Quality
Assurance Handbook for Air Pollution Measurement Systems, Volume I,''
EPA/600/R-94/038a and ``Quality Assurance Handbook for Air Pollution
Measurement Systems, Volume II, Ambient Air Quality Monitoring
Program,'' EPA-454/B-13-003, (both available at http://www.epa.gov/ttn/amtic/qalist.html). Provisions concerning modification of such methods
by users are specified under Section 2.8 (Modifications of Methods by
Users) of Appendix C to 40 CFR part 58.
Consistent or repeated noncompliance with any of these conditions
should be reported to: Director, Air Methods and Characterization
Division (MD-D205-03), Center for Environmental Measurements and
Modeling, U.S. Environmental Protection Agency, Research Triangle Park,
North Carolina 27711.
Designation of this equivalent method is intended to assist the
States in establishing and operating their air quality surveillance
systems under 40 CFR part 58. Questions concerning the commercial
availability or technical aspects of the method should be directed to
the applicant.
Dated: May 1, 2020.
Timothy Watkins,
Director, Center for Environmental Measurements and Modeling.
[FR Doc. 2020-09704 Filed 5-6-20; 8:45 am]
BILLING CODE 6560-50-P