[Federal Register Volume 83, Number 144 (Thursday, July 26, 2018)]
[Rules and Regulations]
[Pages 35421-35422]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2018-15876]



 ========================================================================
 Rules and Regulations
                                                 Federal Register
 ________________________________________________________________________
 
 This section of the FEDERAL REGISTER contains regulatory documents 
 having general applicability and legal effect, most of which are keyed 
 to and codified in the Code of Federal Regulations, which is published 
 under 50 titles pursuant to 44 U.S.C. 1510.
 
 The Code of Federal Regulations is sold by the Superintendent of Documents. 
 
 ========================================================================
 

  Federal Register / Vol. 83, No. 144 / Thursday, July 26, 2018 / Rules 
and Regulations  

[[Page 35421]]



DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2018-0224; Product Identifier 2018-NE-01-AD; Amendment 
39-19332; AD 2018-14-12]
RIN 2120-AA64


Airworthiness Directives; General Electric Company Turbofan 
Engines

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for all 
General Electric Company (GE) GEnx-1B engines. This AD was prompted by 
a report of a center vent tube (CVT) failure leading to a loss of oil 
pressure and subsequent in-flight engine shutdown. This AD requires 
removal of an affected extension duct and replacing it with a part 
eligible for installation. We are issuing this AD to address the unsafe 
condition on these products.

DATES: This AD is effective August 30, 2018.

ADDRESSES: For service information identified in this final rule, 
contact General Electric Company, GE Aviation, Room 285, 1 Neumann Way, 
Cincinnati, OH 45215; phone: 513-552-3272; email: 
[email protected]. You may view this service information at 
the FAA, Engine and Propeller Standards Branch, 1200 District Avenue, 
Burlington, MA. For information on the availability of this material at 
the FAA, call 781-238-7759. It is also available on the internet at 
http://www.regulations.gov by searching for and locating Docket No. 
FAA-2018-0224.

Examining the AD Docket

    You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-
0224; or in person at Docket Operations between 9 a.m. and 5 p.m., 
Monday through Friday, except Federal holidays. The AD docket contains 
this final rule, the regulatory evaluation, any comments received, and 
other information. The address for Docket Operations (phone: 800-647-
5527) is U.S. Department of Transportation, Docket Operations, M-30, 
West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, 
Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Herman Mak, Aerospace Engineer, ECO 
Branch, FAA, 1200 District Ave., Burlington, MA 01803; phone: 781-238-
7147; fax: 781-238-7199; email: [email protected].

SUPPLEMENTARY INFORMATION:

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 by adding an AD that would apply to all GE GEnx-1B engines. The 
NPRM published in the Federal Register on April 30, 2018 (83 FR 18747). 
The NPRM was prompted by a report of a CVT failure leading to a loss of 
oil pressure and subsequent in-flight engine shutdown. During the 
event, the CVT failed due to oil leaking into the fan mid shaft, 
resulting in coking on the seal assembly and overpressurization of the 
CVT. The NPRM proposed to require removal of an affected extension duct 
and replacing it with a part eligible for installation. We are issuing 
this AD to address the unsafe condition on these products.

Comments

    We gave the public the opportunity to participate in developing 
this final rule. We have considered the comments received. The Air Line 
Pilots Association and United Airlines supported the NPRM.

Conclusion

    We reviewed the relevant data, considered the comments received, 
and determined that air safety and the public interest require adopting 
this final rule as proposed.

Related Service Information

    We reviewed GE GEnx-1B Service Bulletin (SB) 72-0331 R01, dated 
August 21, 2017. The SB describes procedures for replacing air/oil 
extension ducts, P/N 2332M85P01 or 2331M25G03, with an extension duct 
eligible for installation.

Costs of Compliance

    We estimate that this AD affects 97 engines installed on airplanes 
of U.S. registry.
    We estimate the following costs to comply with this AD:

                                                 Estimated Costs
----------------------------------------------------------------------------------------------------------------
                                                                                     Cost per      Cost on U.S.
                Action                         Labor cost           Parts cost        product        operators
----------------------------------------------------------------------------------------------------------------
Replacement of Extension Duct.........  4 work-hours x $85 per           $16,270         $16,610      $1,611,170
                                         hour = $340.
----------------------------------------------------------------------------------------------------------------

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. Subtitle VII: Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
Subtitle VII, Part A, Subpart III, Section 44701: ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on

[[Page 35422]]

products identified in this rulemaking action.
    This AD is issued in accordance with authority delegated by the 
Executive Director, Aircraft Certification Service, as authorized by 
FAA Order 8000.51C. In accordance with that order, issuance of ADs is 
normally a function of the Compliance and Airworthiness Division, but 
during this transition period, the Executive Director has delegated the 
authority to issue ADs applicable to engines, propellers, and 
associated appliances to the Manager, Engine and Propeller Standards 
Branch, Policy and Innovation Division.

Regulatory Findings

    This AD will not have federalism implications under Executive Order 
13132. This AD will not have a substantial direct effect on the States, 
on the relationship between the national government and the States, or 
on the distribution of power and responsibilities among the various 
levels of government.
    For the reasons discussed above, I certify that this AD:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866,
    (2) Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979),
    (3) Will not affect intrastate aviation in Alaska, and
    (4) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

2018-14-12 General Electric Company: Amendment 39-19332; Docket No. 
FAA-2018-0224; Product Identifier 2018-NE-01-AD.

(a) Effective Date

    This AD is effective August 30, 2018.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to General Electric Company (GE) GEnx-1B64, -
1B64/P1, -1B64/P2, -1B67, -1B67/P1, -1B67/P2, -1B70, -1B70/75/P1, -
1B70/75/P2, -1B70/P1, -1B70/P2, -1B70C/P1, -1B70C/P2, -1B74/75/P1, 
and -1B74/75/P2 engines with air/oil extension duct, part number (P/
N) 2332M85P01 or 2331M25G03, installed.

(d) Subject

    Joint Aircraft System Component (JASC) Code 7250, Turbine 
Section.

(e) Unsafe Condition

    This AD was prompted by reports of a center vent tube (CVT) 
failure. We are issuing this AD to prevent failure of the CVT. The 
unsafe condition, if not addressed, could result in failure of one 
or more engines, loss of thrust control, and loss of the airplane.

(f) Compliance

    Comply with this AD within the compliance times specified, 
unless already done.

(g) Required Action

    At the next engine shop visit after the effective date of this 
AD, remove air/oil extension ducts, P/N 2332M85P01 or 2331M25G03, 
and replace with a part eligible for installation.

(h) Definition

    For the purpose of this AD, an ``engine shop visit'' is the 
induction of an engine into the shop for maintenance involving the 
separation of pairs of major mating engine case flanges, except for 
the following situations, which do not constitute an engine shop 
visit:
    (1) Separation of engine flanges solely for the purposes of 
transportation of the engine without subsequent maintenance.
    (2) Separation of engine flanges solely for the purpose of 
replacing the fan or propulsor without subsequent maintenance.

(i) Installation Prohibition

    After the effective date of this AD, do not install an air/oil 
extension duct, P/N 2332M85P01 or 2331M25G03, into a fan mid shaft 
assembly.

(j) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, ECO Branch, FAA, has the authority to approve 
AMOCs for this AD if requested using the procedures found in 14 CFR 
39.19. In accordance with 14 CFR 39.19, send your request to your 
principal inspector or local Flight Standards District Office, as 
appropriate. If sending information directly to the manager of the 
certification office, send it to the attention of the person 
identified in paragraph (k) of this AD. You may email your request 
to: [email protected].
    (2) Before using any approved AMOC, notify your appropriate 
principal inspector, or lacking a principal inspector, the manager 
of the local flight standards district office/certificate holding 
district office.

(k) Related Information

    For more information about this AD, contact Herman Mak, 
Aerospace Engineer, ECO Branch, FAA, 1200 District Ave., Burlington, 
MA 01803; phone: 781-238-7147; fax: 781-238-7199; email: 
[email protected].

(l) Material Incorporated by Reference

    None.

    Issued in Burlington, Massachusetts, on July 19, 2018.
Karen M. Grant,
Acting Manager, Engine and Propeller Standards Branch, Aircraft 
Certification Service.
[FR Doc. 2018-15876 Filed 7-25-18; 8:45 am]
BILLING CODE 4910-13-P