[Federal Register Volume 81, Number 149 (Wednesday, August 3, 2016)]
[Notices]
[Pages 51267-51268]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2016-18306]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket No. NHTSA-2016-0072; Notice 1]


Cooper Tire & Rubber Company, Receipt of Petition for Decision of 
Inconsequential Noncompliance

AGENCY: National Highway Traffic Safety Administration (NHTSA), 
Department of Transportation (DOT).

ACTION: Receipt of petition.

-----------------------------------------------------------------------

SUMMARY: Cooper Tire & Rubber Company (Cooper), has determined that 
certain Mastercraft and Big O tires do not fully comply with paragraph 
S5.5(f) of Federal Motor Vehicle Safety Standard (FMVSS) No. 139, New 
Pneumatic Radial Tires for Light Vehicles. Cooper filed a report dated 
May 24, 2016, pursuant to 49 CFR part 573, Defect and Noncompliance 
Responsibility and Reports. Cooper then petitioned NHTSA under 49 CFR 
part 556 for a decision that the subject noncompliance is 
inconsequential as it relates to motor vehicle safety.

DATES: The closing date for comments on the petition is September 2, 
2016.

ADDRESSES: Interested persons are invited to submit written data, 
views, and arguments on this petition. Comments must refer to the 
docket and notice number cited in the title of this notice and be 
submitted by any of the following methods:
     Mail: Send comments by mail addressed to U.S. Department 
of Transportation, Docket Operations, M-30, West Building Ground Floor, 
Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
     Hand Deliver: Deliver comments by hand to U.S. Department 
of Transportation, Docket Operations, M-30, West Building Ground Floor, 
Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590. The 
Docket Section is open on weekdays from 10 a.m. to 5 p.m. except 
Federal Holidays.
     Electronically: Submit comments electronically by logging 
onto the Federal Docket Management System (FDMS) Web site at http://www.regulations.gov/. Follow the online instructions for submitting 
comments.
     Comments may also be faxed to (202) 493-2251.
    Comments must be written in the English language, and be no greater 
than 15 pages in length, although there is no limit to the length of 
necessary attachments to the comments. If comments are submitted in 
hard copy form, please ensure that two copies are provided. If you wish 
to receive confirmation that comments you have submitted by mail were 
received, please enclose a stamped, self-addressed postcard with the 
comments. Note that all comments received will be posted without change 
to http://www.regulations.gov, including any personal information 
provided.
    The petition, supporting materials, and all comments received 
before the close of business on the closing date indicated above will 
be filed in the docket and will be considered. All comments and 
supporting materials received after the closing date will also be filed 
and will be considered to the extent possible.
    When the petition is granted or denied, notice of the decision will 
also

[[Page 51268]]

be published in the Federal Register pursuant to the authority 
indicated at the end of this notice.
    All documents submitted to the docket may be viewed by anyone at 
the address and times given above. The documents may also be viewed on 
the Internet at http://www.regulations.gov by following the online 
instructions for accessing the dockets. The docket ID number for this 
petition is shown in the heading of this notice.
    DOT's complete Privacy Act Statement is available for review in a 
Federal Register notice published on April 11, 2000, (65 FR 19477-78).

SUPPLEMENTARY INFORMATION: 
    I. Overview: Pursuant to 49 U.S.C. 30118(d) and 30120(h) and their 
implementing regulations at 49 CFR part 556, Cooper submitted a 
petition for an exemption from the notification and remedy requirements 
of 49 U.S.C. Chapter 301 on the basis that this noncompliance is 
inconsequential as it relates to motor vehicle safety.
    This notice of receipt of Cooper's petition is published under 49 
U.S.C. 30118 and 30120 and does not represent any agency decision or 
other exercise of judgment concerning the merits of the petition.
    II. Tires Involved: Affected are 22,188 of the following tubeless 
radial tires manufactured between January 10, 2016, and April 30, 2016:
     Mastercraft LSR Grand Touring size 215/60R16.
     Mastercraft LSR Grand Touring size 225/60R16.
     Big O Legacy Tour Plus size 215/60R16.
     Big O Legacy Tour Plus size 225/60R16.
    III. Noncompliance: Cooper explains that due to a mold error, the 
number of tread plies indicated on the sidewall of the subject tires 
does not match the actual number of plies in the tire construction. The 
tires are marked ``TREAD 1 PLY NYLON + 2 PLY STEEL + 2 PLY POLYESTER'' 
whereas the correct marking should be: ``TREAD 1 PLY NYLON + 2PLY STEEL 
+ 1 PLY POLYESTER.'' As a consequence, these tires do not meet the 
requirements specified in paragraph S5.5(f) of FMVSS No. 139.
    IV. Rule Text: Paragraph S5.5(f) of FMVSS No. 139 states, in 
pertinent part:

    S5.5 Tire Markings. Except as specified in paragraph (a) through 
(i) of S5.5, each tire must be marked on each sidewall with the 
information specified in S5.5(a) through (d) and on one sidewall 
with the information specified in S5.5(e) through (i) according to 
the phase-in schedule specified in S7 of this standard . . .
    (f) The actual number of plies in the sidewall, and the actual 
number of plies in the tread area, if different.

    V. Summary of Cooper's Petition: Cooper described the subject 
noncompliance and stated its belief that the noncompliance is 
inconsequential as it relates motor vehicle safety and is unlikely to 
have an adverse impact on motor vehicle safety.
    In support of its petition, Cooper submitted the following 
information pertaining to the subject noncompliance:
    (a) Cooper states that the mislabeled number of plies indicated on 
the sidewalls has no impact on the operational performance or 
durability of the subject tires or on the safety of vehicles on which 
those tires are mounted. Cooper states that while the subject tires do 
not indicate the correct number of plies in the tread on the outboard 
side, they meet all other performance requirements under the Federal 
Motor Vehicle Safety Standards. Cooper notes that the number of plies 
in the tread does not impact the performance or operation of a tire and 
does not create a safety concern to either the operator of the vehicle 
on which the tires are mounted, or the safety of personnel in the tire 
repair, retread and recycle industry.
    (b) Cooper also states that the subject tires were built as 
designed and meet or exceed all performance requirements and testing 
requirements specified under FMVSS No. 139. Cooper states that the 
subject tires completed all Cooper Tire internal compliance testing 
criteria, including passing shipping certification testing in January 
2016. In addition, the 215/60R16, Mastercraft LRS Grand Touring, serial 
week 1116, passed all surveillance testing conducted in early March 
2016.
    (c) Cooper's states that the stamping deviation occurred as a 
result of an administrative error when incorrect information was 
entered into Cooper Tire's electronic specification system at the 
corporate level. That system communicates information to the mold 
management system which in turn generates the construction stamping 
pocket plate. The electronic specification system incorrectly listed 
the specific tire sizes and brands as two-ply, when the tires were 
actually designed with an HPL construction or as having a single ply in 
the tread. The incorrect construction information was then engraved in 
the pocket plate and then installed in the affected molds.
    (d) Cooper states that it is not aware of any crashes, injuries, 
customer complaints, or field reports associated with the mislabeling.
    Cooper states that the mislabeling has been corrected at the 
corporate level and the pocket plates of the molds have been replaced, 
therefore, no additional tires will be manufactured or sold with the 
noncompliance. Cooper also states that it has conducted training with 
tire engineers at the corporate level responsible for inputting 
information into the electronic specification system on the importance 
of the information they are submitting.
    Cooper observed that NHTSA has previously granted inconsequential 
noncompliance petitions regarding noncompliances that are similar to 
the subject noncompliance.
    Cooper concluded by expressing the belief that the subject 
noncompliance is inconsequential as it relates to motor vehicle safety, 
and that its petition to be exempted from providing notification of the 
noncompliance, as required by 49 U.S.C. 30118, and a remedy for the 
noncompliance, as required by 49 U.S.C. 30120, should be granted.
    NHTSA notes that the statutory provisions (49 U.S.C. 30118(d) and 
30120(h)) that permit manufacturers to file petitions for a 
determination of inconsequentiality allow NHTSA to exempt manufacturers 
only from the duties found in sections 30118 and 30120, respectively, 
to notify owners, purchasers, and dealers of a defect or noncompliance 
and to remedy the defect or noncompliance. Therefore, any decision on 
this petition only applies to the subject tires that Cooper no longer 
controlled at the time it determined that the noncompliance existed. 
However, any decision on this petition does not relieve equipment 
distributors and dealers of the prohibitions on the sale, offer for 
sale, or introduction or delivery for introduction into interstate 
commerce of the noncompliant tires under their control after Cooper 
notified them that the subject noncompliance existed.

    Authority: 49 U.S.C. 30118, 30120: delegations of authority at 
49 CFR 1.95 and 501.8.

Jeffrey M. Giuseppe,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 2016-18306 Filed 8-2-16; 8:45 am]
 BILLING CODE 4910-59-P