[Federal Register Volume 80, Number 233 (Friday, December 4, 2015)]
[Rules and Regulations]
[Page 75817]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2015-30379]


-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

40 CFR Part 63

[EPA-HQ-OAR-2013-0290 and EPA-HQ-OAR-2013-0291; FRL-9939-35-OAR]
RIN 2060-AP69


NESHAP for Brick and Structural Clay Products Manufacturing; and 
NESHAP for Clay Ceramics Manufacturing: Correction

AGENCY: Environmental Protection Agency (EPA).

ACTION: Final rule; correction.

-----------------------------------------------------------------------

SUMMARY: The Environmental Protection Agency (EPA) published a final 
rule in the Federal Register on October 26, 2015, titled NESHAP for 
Brick and Structural Clay Products Manufacturing; and NESHAP for Clay 
Ceramics Manufacturing. These amendments make two technical corrections 
to the published regulation.

DATES: This action is effective December 28, 2015.

FOR FURTHER INFORMATION CONTACT: Ms. Sharon Nizich, Sector Policies and 
Programs Division (D243-04), Office of Air Quality Planning and 
Standards, U.S. Environmental Protection Agency, Research Triangle 
Park, North Carolina 27711, telephone number: (919) 541-2825; facsimile 
number: (919) 541-5450; email address: [email protected]. For 
information about the applicability of the national emission standards 
for hazardous air pollutants, contact Mr. Patrick Yellin, Monitoring, 
Assistance and Media Programs Division (2227A), Office of Enforcement 
and Compliance Assurance, U.S. Environmental Protection Agency, 1200 
Pennsylvania Avenue, Washington, DC 20460; telephone number (202) 564-
2970; email address [email protected].

SUPPLEMENTARY INFORMATION: The EPA published a document in the Federal 
Register of October 26, 2015 (80 FR 65470). There were two errors 
included in the final rule. First, the reference to the IBR method 
(ASTM D6348-03) was incorrect. The incorrect IBR method reference 
included in the Federal Register was paragraph (h)(75). The correct 
reference is paragraph (h)(76). Second, there was a typographical error 
in 40 CFR 63.8605(c) referencing a requirement of a non-existing 
section. The incorrect non-existing reference is 40 CFR 63.8630(e). The 
correct reference is 40 CFR 63.8630(c).

Correction

    In rule FR Doc. 2015-25724 published on October 26, 2015 (80 FR 
65470), make the following corrections:


Sec.  63.14  [Corrected]

0
1. On page 65520:
0
a. In the second column, correct amendatory instruction number 2.b. to 
read ``Revising paragraph (h)(76);''.
0
b. In the second column, redesignate paragraph (h)(75) as paragraph 
(h)(76).


Sec.  63.8605  [Corrected]

0
2. On page 65549, second column, in paragraph (c), fifth line, remove 
``Sec.  63.8630(e).'' and add ``Sec.  63.8630(c).'' in its place.

    Dated: November 18, 2015.
Janet G. McCabe,
Acting Assistant Administrator, Office of Air and Radiation.
[FR Doc. 2015-30379 Filed 12-3-15; 8:45 am]
BILLING CODE 6560-50-P