[Federal Register Volume 80, Number 82 (Wednesday, April 29, 2015)]
[Proposed Rules]
[Pages 23739-23741]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2015-09793]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2015-0932; Directorate Identifier 2014-NM-205-AD]
RIN 2120-AA64


Airworthiness Directives; The Boeing Company Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: We propose to adopt a new airworthiness directive (AD) for 
certain The Boeing Company Model 747-8 series airplanes. This proposed 
AD was prompted by a report of improperly installed outboard stowage 
bin modules in the passenger compartment found during maintenance. 
Further investigation revealed that certain attachment bracket bushings 
were missing or had moved out of the holes. This proposed AD would 
require installing a spacer on the end of each quick-release pin that 
attaches the outboard stowage bin module to the lateral support tie 
rods of the main deck passenger compartment. We are proposing this AD 
to prevent detachment of the quick-release pin, which could result in 
separation of the lateral support tie rod and subsequent detachment of 
the module and consequent injuries to passengers or flightcrew.

DATES: We must receive comments on this proposed AD by June 15, 2015.

ADDRESSES: You may send comments, using the procedures found in 14 CFR 
11.43 and 11.45, by any of the following methods:
     Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
     Fax: 202-493-2251.
     Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590.
     Hand Delivery: Deliver to Mail address above between 9 
a.m. and 5 p.m., Monday through Friday, except Federal holidays.
    For service information identified in this proposed AD, contact 
Boeing Commercial Airplanes, Attention: Data & Services Management, 
P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-
5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service information 
at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., 
Renton, WA. For information on the availability of this material at the 
FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0932.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0932; or in person at the Docket Management Facility between 9 a.m. and 
5 p.m., Monday through Friday, except Federal holidays. The AD docket 
contains this proposed AD, the regulatory evaluation, any comments 
received, and other information. The street address for the Docket 
Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will 
be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Stanley Chen, Aerospace Engineer, 
Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle 
Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-
3356; phone: 425-917-6585; fax: 425-917-6590; email: 
[email protected].

SUPPLEMENTARY INFORMATION: 

Comments Invited

    We invite you to send any written relevant data, views, or 
arguments about this proposal. Send your comments to an address listed 
under the ADDRESSES section. Include ``Docket No. FAA-2015-0932; 
Directorate Identifier 2014-NM-205-AD'' at the beginning of your 
comments. We specifically invite comments on the overall regulatory, 
economic, environmental, and energy aspects of this proposed AD. We 
will consider all comments received by the closing date and may amend 
this proposed AD because of those comments.
    We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this proposed AD.

Discussion

    We have received a report of improperly installed outboard stowage 
bin modules in the passenger compartment found during maintenance. 
Further investigation revealed that certain attachment bracket bushings 
of the outboard stowage bin module were missing or had moved out of the 
holes, and pins were installed incorrectly. These bushings were 
designed to prevent disengagement of the quick release pins; however, 
migration of the bushings deters this. It was determined that the 
interference fit of the bushings in the attachment brackets was 
incorrect. Subsequently, installation of the quick release pins during 
production has caused bushings to migrate or detach. This condition, if 
not corrected, could result in separation of the lateral support tie 
rod, detachment of the outboard stowage bin module, and consequent 
injuries to passengers or flightcrew.

Related Service Information Under 1 CFR Part 51

    We reviewed Boeing Special Attention Service Bulletin 747-25-3649, 
dated July 24, 2014. The service information describes procedures for 
installing a spacer on the end of each quick-release pin that attaches 
the outboard stowage bin module to the lateral support tie rods of the 
main deck passenger compartment. Refer to this service information for 
information on the procedures and compliance times. This service 
information is reasonably available; see ADDRESSES for ways to access 
this service information.

FAA's Determination

    We are proposing this AD because we evaluated all the relevant 
information and determined the unsafe condition described previously is 
likely to exist or develop in other products of the same type design.

Proposed AD Requirements

    This proposed AD would require accomplishing the actions specified 
in the service information identified previously.

Explanation of ``RC'' Steps in Service Information

    The FAA worked in conjunction with industry, under the 
Airworthiness Directives Implementation Aviation Rulemaking Committee, 
to enhance the AD system. One enhancement was a

[[Page 23740]]

new process for annotating which steps in the service information are 
required for compliance with an AD. Differentiating these steps from 
other tasks in the service information is expected to improve an 
owner's/operator's understanding of crucial AD requirements and help 
provide consistent judgment in AD compliance. The actions specified in 
the service information described previously include steps that are 
labeled as RC (required for compliance) because these steps have a 
direct effect on detecting, preventing, resolving, or eliminating an 
identified unsafe condition.
    Steps that are identified as RC in any service information must be 
done to comply with the proposed AD. However, steps that are not 
identified as RC are recommended. Those steps that are not identified 
as RC may be deviated from using accepted methods in accordance with 
the operator's maintenance or inspection program without obtaining 
approval of an alternative method of compliance (AMOC), provided the 
steps identified as RC can be done and the airplane can be put back in 
a serviceable condition. Any substitutions or changes to steps 
identified as RC will require approval of an AMOC.

Costs of Compliance

    We estimate that this proposed AD affects 2 airplanes of U.S. 
registry.
    We estimate the following costs to comply with this proposed AD:

                                                 Estimated Costs
----------------------------------------------------------------------------------------------------------------
                                                                                                Cost on U.S.
           Action                 Labor cost           Parts cost       Cost per  product         operators
----------------------------------------------------------------------------------------------------------------
Spacer installations.......  Up to 12 work-hours                  $0  $85 per spacer......  Up to $2,040.
                              X $85 per hour = Up
                              to $1,020.
----------------------------------------------------------------------------------------------------------------

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. Subtitle VII: Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
Subtitle VII, Part A, Subpart III, Section 44701: ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this proposed AD would not have federalism 
implications under Executive Order 13132. This proposed AD would not 
have a substantial direct effect on the States, on the relationship 
between the national Government and the States, or on the distribution 
of power and responsibilities among the various levels of government.
    For the reasons discussed above, I certify this proposed 
regulation:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866,
    (2) Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979),
    (3) Will not affect intrastate aviation in Alaska, and
    (4) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

The Proposed Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

The Boeing Company: Docket No. FAA-2015-0932; Directorate Identifier 
2014-NM-205-AD.

(a) Comments Due Date

    We must receive comments by June 15, 2015.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to The Boeing Company Model 747-8 series 
airplanes, certificated in any category, as identified in Boeing 
Special Attention Service Bulletin 747-25-3649, dated July 24, 2014.

(d) Subject

    Air Transport Association (ATA) of America Code 25, Equipment/
Furnishings.

(e) Unsafe Condition

    This AD was prompted by a report of improperly installed 
outboard stowage bin modules in the passenger compartment found 
during maintenance. Further investigation revealed that certain 
attachment bracket bushings were missing or had moved out of the 
holes. We are issuing this AD to prevent detachment of the quick-
release pin, which could result in separation of the lateral support 
tie rod and subsequent detachment of the module and consequent 
injuries to passengers or flightcrew.

(f) Compliance

    Comply with this AD within the compliance times specified, 
unless already done.

(g) Installation

    Within 36 months after the effective date of this AD: Install a 
spacer on the end of each quick-release pin that attaches the 
outboard stowage bin module to the lateral support tie rods of the 
main deck passenger compartment, in accordance with the 
Accomplishment Instructions of Boeing Special Attention Service 
Bulletin 747-25-3649, dated July 24, 2014.

(h) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Seattle Aircraft Certification Office (ACO), 
FAA, has the authority to approve AMOCs for this AD, if requested 
using the procedures found in 14 CFR 39.19. In accordance with 14 
CFR 39.19, send your request to your principal inspector or local 
Flight Standards District Office, as appropriate. If sending 
information directly to the manager of the ACO, send it to the 
attention of the person identified in paragraph (i)(1) of this AD. 
Information may be emailed to: [email protected].
    (2) Before using any approved AMOC, notify your appropriate 
principal inspector, or lacking a principal inspector, the manager 
of the local flight standards district office/certificate holding 
district office.
    (3) If any service information contains steps that are 
identified as RC (Required for

[[Page 23741]]

Compliance), those steps must be done to comply with this AD; any 
steps that are not identified as RC are recommended. Those steps 
that are not identified as RC may be deviated from using accepted 
methods in accordance with the operator's maintenance or inspection 
program without obtaining approval of an AMOC provided the steps 
identified as RC can be done and the airplane can be put back in a 
serviceable condition. Any substitutions or changes to steps 
identified as RC require approval of an AMOC.

(i) Related Information

    (1) For more information about this AD, contact Stanley Chen, 
Aerospace Engineer, Cabin Safety and Environmental Systems Branch, 
ANM-150S, FAA, Seattle Aircraft Certification Office, 1601 Lind 
Avenue SW., Renton, WA 98057-3356; phone: 425-917-6585; fax: 425-
917-6590; email: [email protected].
    (2) For service information identified in this AD, contact 
Boeing Commercial Airplanes, Attention: Data & Services Management, 
P. O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-
5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service 
information at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue SW., Renton, WA. For information on the availability of this 
material at the FAA, call 425-227-1221.

    Issued in Renton, Washington, on April 13, 2015.
Michael Kaszycki,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 2015-09793 Filed 4-28-15; 8:45 am]
 BILLING CODE 4910-13-P