[Federal Register Volume 80, Number 19 (Thursday, January 29, 2015)]
[Proposed Rules]
[Pages 4810-4811]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2015-01556]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2015-0132; Directorate Identifier 2014-CE-038-AD]
RIN 2120-AA64


Airworthiness Directives; PILATUS Aircraft Ltd. Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: We propose to adopt a new airworthiness directive (AD) for 
PILATUS Aircraft Ltd. Model PC-7 airplanes. This proposed AD results 
from mandatory continuing airworthiness information (MCAI) originated 
by an aviation authority of another country to identify and correct an 
unsafe condition on an aviation product. The MCAI describes the unsafe 
condition as the potential for a spring on the compressor clutch plate 
to shear the oil cooler inlet-hose due to the close routing of these 
parts without a protective cover. We are issuing this proposed AD to 
require actions to address the unsafe condition on these products.

DATES: We must receive comments on this proposed AD by March 16, 2015.

ADDRESSES: You may send comments by any of the following methods:
     Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
     Fax: (202) 493-2251.
     Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590.
     Hand Delivery: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., 
Monday through Friday, except Federal holidays.
    For service information identified in this NPRM, contact PILATUS 
AIRCRAFT LTD., Customer Technical Support (MCC), P.O. Box 992, CH-6371 
Stans, Switzerland; phone: +41 (0)41 619 67 74; fax: +41 (0)41 619 67 
73; email: aircraft.com">Techsupport@pilatus-aircraft.com; internet: http://
www.pilatus-aircraft.com. You may view this service information at the 
FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 
64106. For information on the availability of this material at the FAA, 
call (816) 329-4148.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0132; or in person at the Docket Management Facility between 9 a.m. and 
5 p.m., Monday through Friday, except Federal holidays. The AD docket 
contains this proposed AD, the regulatory evaluation, any comments 
received, and other information. The street address for the Docket 
Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments 
will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Doug Rudolph, Aerospace Engineer, FAA, 
Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 
64106; telephone: (816) 329-4059; fax: (816) 329-4090; email: 
[email protected].

SUPPLEMENTARY INFORMATION:

Comments Invited

    We invite you to send any written relevant data, views, or 
arguments about this proposed AD. Send your comments to an address 
listed under the ADDRESSES section. Include ``Docket No. FAA-2015-0132; 
Directorate Identifier 2014-CE-038-AD'' at the beginning of your 
comments. We specifically invite comments on the overall regulatory, 
economic, environmental, and energy aspects of this proposed AD. We 
will consider all comments received by the closing date and may amend 
this proposed AD because of those comments.
    We will post all comments we receive, without change, to http://regulations.gov, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this proposed AD.

Discussion

    The Federal Office of Civil Aviation (FOCA), which is the aviation 
authority for Switzerland, has issued AD HB-2014-008, dated December 9, 
2014 (referred to after this as ``the MCAI''), to correct an unsafe 
condition for PILATUS Aircraft Ltd. Model PC-7 airplanes and was based 
on mandatory continuing airworthiness information originated by an 
aviation authority of another country. The MCAI states:

This Airworthiness Directive (AD) is prompted due to an unprotected 
routing of the oil cooler inlet-hose close to the air conditioning 
compressor clutch plate.
If a spring on the compressor clutch plate shears it could lead to a 
damage of the oil hose and the engine oil can spill into the engine 
bay.
In order to correct and control the situation, this AD requires the 
installation of a cover assembly which will be mounted on the 
attachment points of the compressor.

You may examine the MCAI on the Internet at http://www.regulations.gov 
by searching for and locating Docket No. FAA-2015-0132.

Relevant Service Information

    PILATUS Aircraft Ltd. has issued PILATUS PC-7 Service Bulletin No: 
21-012, dated November 4, 2014. The actions described in this service 
information are intended to correct the unsafe condition identified in 
the MCAI. The PILATUS PC-7 Service Bulletin No: 21-012, dated November 
4, 2014, describes procedures for installing a cover assembly to the 
compressor to protect the engine oil hose.

FAA's Determination and Requirements of the Proposed AD

    This product has been approved by the aviation authority of another 
country, and is approved for operation in the United States. Pursuant 
to our bilateral agreement with this State of Design Authority, they 
have notified us of the unsafe condition described in the MCAI and 
service information referenced above. We are proposing this AD because 
we evaluated all information and determined the unsafe condition exists 
and is likely to exist or develop on other products of the same type 
design.

Costs of Compliance

    We estimate that this proposed AD will affect 10 products of U.S. 
registry. We also estimate that it would take about 6 work-hours per 
product to comply with the basic requirements of this proposed AD. The 
average labor rate is $85 per work-hour. Required parts would cost 
about $1,250 per product.
    Based on these figures, we estimate the cost of the proposed AD on 
U.S. operators to be $17,600, or $1,760 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue

[[Page 4811]]

rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this proposed AD would not have federalism 
implications under Executive Order 13132. This proposed AD would not 
have a substantial direct effect on the States, on the relationship 
between the national Government and the States, or on the distribution 
of power and responsibilities among the various levels of government.
    For the reasons discussed above, I certify this proposed 
regulation:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866,
    (2) Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979),
    (3) Will not affect intrastate aviation in Alaska, and
    (4) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

The Proposed Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

PILATUS Aircraft Ltd.: Docket No. FAA-2015-0132; Directorate 
Identifier 2014-CE-038-AD.

(a) Comments Due Date

    We must receive comments by March 16, 2015.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to PILATUS Aircraft Ltd. Model PC-7 airplanes, 
all serial numbers, that
    (1) have not incorporated the actions of any version of PILATUS 
PC-7 Service Bulletin No: 21-006, which allows for the installation 
of a different air conditioning compressor mounted at a different 
location and thus making the unsafe condition nonexistent; and
    (2) are certificated in any category.

(d) Subject

    Air Transport Association of America (ATA) Code 21: Air 
Conditioning.

(e) Reason

    This AD was prompted by mandatory continuing airworthiness 
information (MCAI) originated by an aviation authority of another 
country to identify and correct an unsafe condition on an aviation 
product. The MCAI describes the unsafe condition as the potential 
for a spring on the compressor clutch plate to shear the oil cooler 
inlet-hose due to the close routing of these parts without a 
protective cover. We are issuing this AD to correct the unprotected 
routing of the oil cooler inlet-hose, which could lead to damage of 
the oil hose resulting in an engine oil spill into the engine bay.

(f) Actions and Compliance

    Unless already done, within the next 120 days after the 
effective date of this AD, install a cover assembly on the 
attachment points of the compressor following the Accomplishment 
Instructions in PILATUS PC-7 Service Bulletin No: 21-012, dated 
November 4, 2014.

(g) Other FAA AD Provisions

    The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
Standards Office, FAA, has the authority to approve AMOCs for this 
AD, if requested using the procedures found in 14 CFR 39.19. Send 
information to ATTN: Doug Rudolph, Aerospace Engineer, FAA, Small 
Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 
64106; telephone: (816) 329-4059; fax: (816) 329-4090; email: 
[email protected]. Before using any approved AMOC on any airplane 
to which the AMOC applies, notify your appropriate principal 
inspector (PI) in the FAA Flight Standards District Office (FSDO), 
or lacking a PI, your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, a federal agency may not conduct or sponsor, and a person 
is not required to respond to, nor shall a person be subject to a 
penalty for failure to comply with a collection of information 
subject to the requirements of the Paperwork Reduction Act unless 
that collection of information displays a current valid OMB Control 
Number. The OMB Control Number for this information collection is 
2120-0056. Public reporting for this collection of information is 
estimated to be approximately 5 minutes per response, including the 
time for reviewing instructions, completing and reviewing the 
collection of information. All responses to this collection of 
information are mandatory. Comments concerning the accuracy of this 
burden and suggestions for reducing the burden should be directed to 
the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: 
Information Collection Clearance Officer, AES-200.

(h) Related Information

    Refer to MCAI Federal Office of Civil Aviation (FOCA) AD HB-
2014-008, dated December 9, 2014; and any version of PILATUS PC-7 
Service Bulletin No: 21-006, for related information. You may 
examine the MCAI on the Internet at http://www.regulations.gov by 
searching for and locating Docket No. FAA-2015-0132. For service 
information related to this AD, contact PILATUS AIRCRAFT LTD., 
Customer Technical Support (MCC), P.O. Box 992, CH-6371 Stans, 
Switzerland; phone: +41 (0)41 619 67 74; fax: +41 (0)41 619 67 73; 
email: aircraft.com">Techsupport@pilatus-aircraft.com; internet: http://
www.pilatus-aircraft.com. You may review this referenced service 
information at the FAA, Small Airplane Directorate, 901 Locust, 
Kansas City, Missouri 64106. For information on the availability of 
this material at the FAA, call (816) 329-4148.


    Issued in Kansas City, Missouri, on January 20, 2015.
Robert Busto,
Acting Manager, Small Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 2015-01556 Filed 1-28-15; 8:45 am]
BILLING CODE 4910-13-P