[Federal Register Volume 79, Number 227 (Tuesday, November 25, 2014)]
[Notices]
[Pages 70265-70267]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2014-27887]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration


Petition for Exemption From the Federal Vehicle Theft Prevention 
Standard; Mazda Motor Corporation

AGENCY: National Highway Traffic Safety Administration (NHTSA), 
Department of Transportation (DOT).

ACTION: Grant of petition for exemption.

-----------------------------------------------------------------------

SUMMARY: This document grants in full the Mazda Motor Corporation's 
(Mazda) petition for an exemption of the (confidential) vehicle line in 
accordance with 49 CFR part 543, Exemption from Vehicle Theft 
Prevention Standard. This petition is granted because the agency has 
determined that the antitheft device to be placed on the line as 
standard equipment is likely to be as effective in reducing and 
deterring motor vehicle theft as compliance with the parts-marking 
requirements of 49 CFR part 541, Federal Motor Vehicle Theft Prevention 
Standard (Theft Prevention Standard). Mazda also requested confidential 
treatment for specific information in its petition. The agency will 
address Mazda's request for confidential treatment by separate letter.

DATES: The exemption granted by this notice is effective beginning with 
the 2016 model year (MY).

FOR FURTHER INFORMATION CONTACT: Ms. Deborah Mazyck, Office of 
International Policy, Fuel Economy and Consumer Programs, NHTSA, W43-
443, 1200 New Jersey Avenue SE., Washington, DC 20590. Ms. Mazyck's 
phone number is (202) 366-4139. Her fax number is (202) 493-2990.

SUPPLEMENTARY INFORMATION: In a petition dated August 1, 2014, Mazda 
requested an exemption from the parts-marking requirements of the Theft 
Prevention Standard for the Mazda (confidential) vehicle line beginning 
with MY 2016. The petition requested an exemption from parts-marking 
pursuant to 49 CFR part 543, Exemption from Vehicle Theft Prevention 
Standard, based on the installation of an antitheft device as standard 
equipment for the entire vehicle line.
    Under 49 CFR 543.5(a), a manufacturer may petition NHTSA to grant 
an exemption for one vehicle line per model year. In its petition, 
Mazda provided a detailed description and diagram of the identity, 
design, and location of the components of the antitheft device for the 
(confidential) vehicle line. Mazda stated that its MY 2016 
(confidential) vehicle line will be equipped with a passive, 
transponder based, electronic engine immobilizer antitheft device as 
standard equipment. Key components of its antitheft device will include 
a powertrain control module (PCM), immobilizer control module, security 
indicator light, coil antenna, transmitter with transponder key 
(transponder key), low frequency (LF) antenna, radio frequency (RF) 
antenna and low frequency unit (LFU). The device will not provide any 
visible or audible indication of unauthorized vehicle entry (i.e., 
flashing lights or horn alarm) as standard equipment. Mazda's 
submission is considered a complete petition as required by 49 CFR 
543.7, in that it meets the general requirements contained in Sec.  
543.5 and the specific content requirements of Sec.  543.6.
    The integration of the set/unset device (transponder key) into the 
immobilizer system prevents any inadvertent actuation of the system. 
Mazda stated that the antitheft device is deactivated when the ignition 
is initially engaged by pressing the ``Engine Start'' pushbutton while 
simultaneously depressing the brake pedal. Activation of the device 
occurs when the operator disengages the ignition by pressing the 
``Engine Start'' pushbutton when the vehicle is parked.
    Mazda further stated that there are two methods of initiating the 
antitheft device operation process. The first process is used when the 
transponder key can be detected. Specifically, the immobilizer control 
unit sends a signal to the transponder key using its LF antenna to 
request a transponder code. The transponder code is then sent through 
the RF receiver back to the immobilizer control unit to authenticate 
the code and determine its validity. The second process is used when 
the transponder key cannot be detected by the immobilizer control unit 
(i.e., discharged battery). For this process, communication between the 
transponder key and the immobilizer control unit begins when the 
transponder key is passed over the coil antenna located in the ``Engine 
Start'' pushbutton. The immobilizer control module then communicates 
with the transponder key to determine key validity. Mazda stated that 
if the code from the transponder key matches with the code from the 
immobilizer control module by either process, the immobilizer control 
module compares its code with the code from the PCM when the ``Engine 
Start'' pushbutton is pressed and the brake pedal is depressed 
simultaneously. Mazda stated that the vehicle's engine can only be 
started if the code from the immobilizer control module matches the 
code previously programmed into the PCM. If the codes do not match, the 
engine will not start.
    Mazda also stated that the immobilizer device incorporates a light-
emitting diode (LED) indicator which provides information on the status 
of the antitheft device. Specifically, when the ignition is initially 
engaged, the LED illuminates continuously for 3 seconds to indicate the 
``unset'' state of the system. When the ignition is disengaged, a 
flashing LED indicates the ``set'' state of the device, providing a 
visual confirmation that the vehicle is protected by the immobilizer 
device.
    In addressing the specific content requirements of Sec.  543.6, 
Mazda provided information on the reliability and durability of its 
proposed device. To ensure reliability and durability of the device, 
Mazda conducted tests based on its own specified standards. Mazda 
provided a detailed list of the tests conducted (i.e., electromagnetic

[[Page 70266]]

radiation, electric conduction, and climatic, mechanical and chemical 
environments) and believes that the device is reliable and durable 
since it complied with its own specified requirements for each test. 
Mazda also stated that its device is extremely reliable and durable 
because it does not have any moving parts, and that any attempt to 
slam-pull the ignition will have no effect on a thief's ability to 
start the vehicle without the correct code being transmitted to the 
electronic control modules.
    In support of its belief that its antitheft device will be as 
effective as compliance with the parts-marking requirements in reducing 
and deterring vehicle theft, Mazda also compared its device to other 
similar devices previously granted exemptions by the agency. Mazda 
stated that its antitheft device has features similar to the Ford Motor 
Company's (Ford) Passive Anti-Theft System (PATS). The PATS antitheft 
device was previously approved for exemption from the requirements of 
Part 541 and installed on the Mazda Tribute, (manufactured by Ford), 
the Ford Focus, the Ford Five Hundred and the Ford Taurus X vehicle 
lines. The agency granted in full the petition for the Mazda Tribute 
vehicle line beginning with model year 2010, (see 73 FR 40447, July 14, 
2008), the Ford Focus vehicle line beginning with model year 2006, (see 
71 FR 7824, February 14, 2006), the Ford Five Hundred beginning with 
model year 2007 (see 71 FR 52206, September 1, 2006), and the Ford 
Taurus X vehicle line beginning with model year 2008, (see 72 FR 20400, 
April 24, 2007). The agency notes the average theft rate for the Mazda 
Tribute and Ford Focus vehicle lines using three MYs' data (2010-
preliminary 2012) are 1.560 and 0.14216 respectively. Current theft 
rate data is not available for the Ford Five Hundred and the Taurus X 
vehicle lines because they are no longer being produced.
    Mazda also provided data on the effectiveness of other similar 
antitheft devices installed on vehicle lines in support of its belief 
that its device will be at least as effective as those comparable 
devices. Specifically, Mazda stated that its device was installed on 
certain MY 1996
    Ford vehicles as standard equipment, (i.e., all Ford Mustang GT, 
Cobra, Taurus LX, SHO and Sable LS models). In MY 1997, Mazda installed 
its immobilizer device on the entire Ford Mustang vehicle line as 
standard equipment. When comparing 1995 model year Mustang vehicle 
thefts (without immobilizers) with MY 1997 Mustangs vehicle thefts 
(with immobilizers), Mazda referenced the National Crime Information 
Center's theft information which showed that there was a 70% reduction 
in theft experienced when comparing MY 1997 Mustang vehicle thefts 
(with immobilizers) to MY 1995 Mustang vehicle thefts (without 
immobilizers). Mazda also stated that the Highway Loss Data Institute's 
(HLDI) September 1997 Theft Loss Bulletin reported an overall theft 
loss decrease of approximately 50% for both the Ford Mustang and Taurus 
models upon installation of an antitheft immobilization device. The 
agency notes that current theft rate data for MYs 2010 through 
preliminary 2012 are 2.2392, 1.7365 and 2.2115 respectively for the 
Ford Mustang vehicle line. Additionally, Mazda referenced a July 2000 
HLDI news release which reported that when comparing theft loss data 
before and after equipping vehicle with passive immobilizer devices, 
the data showed an average theft reduction of approximately 50% for 
vehicle with immobilizer devices.
    Mazda stated that it believes that since its device is functionally 
equivalent to other comparable manufacturer's devices that have already 
been granted parts-marking exemptions by the agency, along with the 
evidence of reduced theft rates for vehicle lines equipped with similar 
devices and advanced technology of transponder electronic security, the 
Mazda immobilizer device will have the potential to achieve the level 
of effectiveness equivalent to those vehicle already exempted by the 
agency. The agency agrees that the device is substantially similar to 
devices installed on other vehicle lines for which the agency has 
already granted exemptions.
    Based on the supporting evidence submitted by Mazda on its device, 
the agency believes that the antitheft device for the (confidential) 
vehicle line is likely to be as effective in reducing and deterring 
motor vehicle theft as compliance with the parts-marking requirements 
of the Theft Prevention Standard (49 CFR 541).
    Pursuant to 49 U.S.C. 33106 and 49 CFR 543.7 (b), the agency grants 
a petition for exemption from the parts-marking requirements of Part 
541 either in whole or in part, if it determines that, based upon 
substantial evidence, the standard equipment antitheft device is likely 
to be as effective in reducing and deterring motor vehicle theft as 
compliance with the parts-marking requirements of Part 541. The agency 
finds that Mazda has provided adequate reasons for its belief that the 
antitheft device for the Mazda (confidential) vehicle line is likely to 
be as effective in reducing and deterring motor vehicle theft as 
compliance with the parts-marking requirements of the Theft Prevention 
Standard (49 CFR part 541). This conclusion is based on the information 
Mazda provided about its device.
    The agency concludes that the device will provide the four of the 
five types of performance listed in Sec.  543.6(a)(3): Promoting 
activation; preventing defeat or circumvention of the device by 
unauthorized persons; preventing operation of the vehicle by 
unauthorized entrants; and ensuring the reliability and durability of 
the device.
    For the foregoing reasons, the agency hereby grants in full Mazda's 
petition for exemption for the Mazda (confidential) vehicle line from 
the parts-marking requirements of 49 CFR part 541. The agency notes 
that 49 CFR part 541, Appendix A-1, identifies those lines that are 
exempted from the Theft Prevention Standard for a given model year. 49 
CFR part 543.7(f) contains publication requirements incident to the 
disposition of all Part 543 petitions. Advanced listing, including the 
release of future product nameplates, the beginning model year for 
which the petition is granted and a general description of the 
antitheft device is necessary in order to notify law enforcement 
agencies of new vehicle lines exempted from the parts-marking 
requirements of the Theft Prevention Standard.
    If Mazda decides not to use the exemption for this line, it must 
formally notify the agency. If such a decision is made, the line must 
be fully marked according to the requirements under 49 CFR parts 541.5 
and 541.6 (marking of major component parts and replacement parts).
    NHTSA notes that if Mazda wishes in the future to modify the device 
on which this exemption is based, the company may have to submit a 
petition to modify the exemption. Part 543.7(d) states that a Part 543 
exemption applies only to vehicles that belong to a line exempted under 
this part and equipped with the antitheft device on which the line's 
exemption is based. Further, Part 543.9(c)(2) provides for the 
submission of petitions ``to modify an exemption to permit the use of 
an antitheft device similar to but differing from the one specified in 
that exemption.''
    The agency wishes to minimize the administrative burden that Part 
543.9(c)(2) could place on exempted vehicle manufacturers and itself. 
The agency did not intend in drafting Part 543 to require the 
submission of a

[[Page 70267]]

modification petition for every change to the components or design of 
an antitheft device. The significance of many such changes could be de 
minimis. Therefore, NHTSA suggests that if the manufacturer 
contemplates making any changes, the effects of which might be 
characterized as de minimis, it should consult the agency before 
preparing and submitting a petition to modify.
    Under authority delegated in 49 CFR 1.95

R. Ryan Posten,
Associate Administrator for Rulemaking.
[FR Doc. 2014-27887 Filed 11-24-14; 8:45 am]
BILLING CODE 4910-59-P