[Federal Register Volume 77, Number 163 (Wednesday, August 22, 2012)]
[Notices]
[Pages 50722-50723]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2012-20639]
[[Page 50722]]
-----------------------------------------------------------------------
NUCLEAR REGULATORY COMMISSION
[NRC-2012-0195]
Software Unit Testing for Digital Computer Software Used in
Safety Systems of Nuclear Power Plants
AGENCY: Nuclear Regulatory Commission.
ACTION: Draft regulatory guide; request for comment.
-----------------------------------------------------------------------
SUMMARY: The U.S. Nuclear Regulatory Commission (NRC or the Commission)
is issuing for public comment draft regulatory guide (DG), DG-1208,
``Software Unit Testing for Digital Computer Software used in Safety
Systems of Nuclear Power Plants.'' The DG-1208 is proposed Revision 1
of RG 1.171, dated September 1997. This revision endorses, with
clarifications, the enhanced consensus practices for testing of
computer software as described in the American National Standards
Institute and Institute of Electrical and Electronics Engineers (ANSI/
IEEE) Standard 1008-1987, ``IEEE Standard for Software Unit Testing.''
DATES: Submit comments by November 23, 2012. Comments received after
this date will be considered if it is practical to do so, but the NRC
is able to ensure consideration only for comments received on or before
this date. Although a time limit is given, comments and suggestions in
connection with items for inclusion in guides currently being developed
or improvements in all published guides are encouraged at any time.
ADDRESSES: You may access information and comment submissions related
to this document, which the NRC possesses and are publicly available,
by searching on http://www.regulations.gov under Docket ID NRC-2012-
0195. You may submit comments by any of the following methods:
Federal Rulemaking Web Site: Go to http://www.regulations.gov and search for Docket ID NRC-2012-0195. Address
questions about NRC dockets to Carol Gallagher; telephone: 301-492-
3668; email: [email protected].
Mail comments to: Cindy Bladey, Chief, Rules,
Announcements, and Directives Branch (RADB), Office of Administration,
Mail Stop: TWB-05-B01M, U.S. Nuclear Regulatory Commission, Washington,
DC 20555-0001.
Fax comments to: RADB at 301-492-3446.
For additional direction on accessing information and submitting
comments, see ``Accessing Information and Submitting Comments'' in the
SUPPLEMENTARY INFORMATION section of this document.
FOR FURTHER INFORMATION CONTACT: Karl Sturzebecher, Office of Nuclear
Regulatory Research, U.S. Nuclear Regulatory Commission, Washington, DC
20555-0001; telephone: 301-251-7494 or email [email protected].
SUPPLEMENTARY INFORMATION:
I. Accessing Information and Submitting Comments
A. Accessing Information
Please refer to Docket ID NRC-2012-0195 when contacting the NRC
about the availability of information regarding this document. You may
access information related to this document, which the NRC possesses
and are publicly available, by any of the following methods:
Federal Rulemaking Web Site: Go to http://www.regulations.gov and search for Docket ID NRC-2012-0195.
NRC's Agencywide Documents Access and Management System
(ADAMS): You may access publicly available documents online in the NRC
Library at http://www.nrc.gov/reading-rm/adams.html. To begin the
search, select ``ADAMS Public Documents'' and then select ``Begin Web-
based ADAMS Search.'' For problems with ADAMS, please contact the NRC's
Public Document Room (PDR) reference staff at 1-800-397-4209, 301-415-
4737, or by email to [email protected]. The draft regulatory guide
is available electronically under ADAMS Accession Number ML103120751.
The regulatory analysis may be found in ADAMS under Accession Number
ML103120752.
Regulatory guides are not copyrighted, and NRC approval is not
required to reproduce them.
NRC's PDR: You may examine and purchase copies of public
documents at the NRC's PDR, Room O1-F21, One White Flint North, 11555
Rockville Pike, Rockville, Maryland 20852.
B. Submitting Comments
Please include Docket ID NRC-2012-0195 in the subject line of your
comment submission, in order to ensure that the NRC is able to make
your comment submission available to the public in this docket.
The NRC cautions you not to include identifying or contact
information in comment submissions that you do not want to be publicly
disclosed. The NRC posts all comment submissions at http://www.regulations.gov as well as enters the comment submissions into
ADAMS. The NRC does not edit comment submissions to remove identifying
or contact information.
If you are requesting or aggregating comments from other persons
for submission to the NRC, then you should inform those persons not to
include identifying or contact information in their comment submissions
that they do not want to be publicly disclosed. Your request should
state that the NRC will not edit comment submissions to remove such
information before making the comment submissions available to the
public or entering the comment submissions into ADAMS.
II. Further Information
The NRC is issuing for public comment a draft guide in the NRC's
``Regulatory Guide'' series. This series was developed to describe and
make available to the public such information as methods that are
acceptable to the NRC staff for implementing specific parts of the
NRC's regulations, techniques that the staff uses in evaluating
specific problems or postulated accidents, and data that the staff
needs in its review of applications for permits and licenses.
The draft regulatory guide entitled ``Software Unit Testing for
Digital Computer Software Used in Safety Systems of Nuclear Power
Plants'' is temporarily identified by its task number, DG-1208. The DG-
1208 is proposed Revision 1 of Regulatory Guide 1.171, ``Software Unit
Testing for Digital Computer Software Used in Safety Systems of Nuclear
Power Plants'' dated September 1997.
This RG endorses ANSI/IEEE Std. 1008-1987, ``IEEE Standard for
Software Unit Testing,'' issued in 1987 with the exceptions stated in
the regulatory positions. ANSI/IEEE Std. 1008-1987 describes methods
acceptable to the NRC staff for use in complying with the NRC's
regulations with respect to software testing for digital computer
software used in the safety systems of nuclear power plants. In
particular, the methods are consistent with part 50 of Title 10 of the
Code of Federal Regulations (10 CFR), ``Domestic Licensing of
Production and Utilization Facilities,'' Appendix A, ``General Design
Criteria for Nuclear Power Plants,'' General Design Criterion 1,
``Quality Standards and Records,'' which requires, in part, that a
quality assurance program be established and implemented to provide
adequate assurance that systems and components important to safety will
satisfactorily perform their safety functions.
This DG is part of a series of 6 complimentary guides addressing
the
[[Page 50723]]
issue of digital software in power plant applications. The following is
a complete list of all 6 of the DGs:
DG-1267 is proposed revision 2 of RG 1.168,
``Verification, Validation, Reviews, and Audits for Digital Computer
Software used in Safety Systems of Nuclear Power Plants.'' DG-1267 is
available in ADAMS at Accession number ML103160431,
DG-1206 is proposed revision 1 of RG 1.169,
``Configuration Management Plans for Digital Computer Software used in
Safety Systems of Nuclear Power Plants.'' DG-1206 is available in ADAMS
at Accession number ML103200044.
DG-1207 is proposed revision 1 of RG 1.170, ``Software
Unit Testing for Digital Computer Software Used in Safety Systems of
Nuclear Power Plants.'' DG-1207 is available in ADAMS at Accession
number ML083370243.
DG-1208 is proposed revision 1 if RG 1.171, ``Software
Unit Testing for Digital Computer Software used in Safety Systems of
Nuclear Power Plants.'' DG-1208 is available in ADAMS at Accession
number ML103120751.
DG-1209 is proposed revision 1 of RG 1.172, ``Software
Requirement Specifications for Digital Computer Software and Complex
Electronics used in Safety Systems of Nuclear Power Plants.'' DG-1209
is available in ADAMS at Accession number ML103080963.
DG-1210 is proposed revision 1 of RG 1.173, ``Developing
Software Life-Cycle Processes for Digital Computer Software used in
Safety Systems of Nuclear Power Plants.'' DG-1210 is available in ADAMS
at Accession number ML103120727.
Dated at Rockville, Maryland, this 9th day of August, 2012.
For the Nuclear Regulatory Commission.
Thomas H. Boyce,
Chief, Regulatory Guide Development Branch, Division of Engineering,
Office of Nuclear Regulatory Research.
[FR Doc. 2012-20639 Filed 8-21-12; 8:45 am]
BILLING CODE 7590-01-P