[Federal Register Volume 75, Number 204 (Friday, October 22, 2010)]
[Rules and Regulations]
[Pages 65222-65224]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2010-26565]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2010-0611; Directorate Identifier 2009-SW-18-AD; 
Amendment 39-16487; AD 2010-22-08]
RIN 2120-AA64


Airworthiness Directives; Eurocopter France Model AS 350 B, BA, 
B1, B2, B3, and D, and Model AS355 E, F, F1, F2, and N Helicopters

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
Eurocopter France Model AS 350 B, BA, B1, B2, B3, and D, and Model 
AS355 E, F, F1, F2, and N helicopters, with certain main rotor servo-
controls and tail rotor servo-controls. This AD requires replacing all 
servo-controls that are identified in the Applicability section of this 
AD. This AD is prompted by an internal review conducted by the 
manufacturer which revealed that some main and tail rotor servo-
controls do not conform to the approved design. The actions specified 
by this AD are intended to prevent the distributor slide valve jamming 
in its sleeve, leading to reduced controllability of the rotors and 
subsequent loss of control of the helicopter.

DATES: Effective November 26, 2010.

ADDRESSES: You may get the service information identified in this AD 
from American Eurocopter Corporation, 2701 Forum Drive, Grand Prairie, 
Texas 75053-4005, telephone (972) 641-3460, fax (972) 641-3527.
    Examining the Docket: You may examine the docket that contains this 
AD, any comments, and other information on the Internet at http://www.regulations.gov or at the Docket Operations office, West Building 
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, 
DC.

FOR FURTHER INFORMATION CONTACT: J. R. Holton, Aviation Safety 
Engineer, FAA, Rotorcraft Directorate, Regulations and Guidance Group, 
ASW-111, 2601 Meacham Blvd., Fort Worth, Texas 76137, telephone (817) 
222-4964, fax (817) 222-5961.

SUPPLEMENTARY INFORMATION:

Discussion

    We issued a Notice of Proposed Rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would apply to the Eurocopter France 
Model AS 350 B, BA, B1, B2, B3, and D, and Model AS355 E, F, F1, F2, 
and N helicopters on June 9, 2010. That NPRM was published in the 
Federal Register on June 16, 2010 (75 FR 34062). That NPRM proposed to 
require replacing all servo-controls that are identified in the 
Applicability section of the proposed AD. The NPRM was prompted by an 
internal review conducted by the manufacturer which revealed that some 
main and tail rotor servo-controls do not conform to the approved 
design. The actions specified by the NPRM are intended to prevent the 
distributor slide valve jamming in its sleeve, leading to reduced 
controllability of the rotors and subsequent loss of control of the 
helicopter.
    The European Aviation Safety Agency (EASA), which is the Technical 
Agent

[[Page 65223]]

for the Member States of the European Community, has issued EASA 
Emergency AD No. 2007-0141-E, dated May 21, 2007, to correct an unsafe 
condition for certain Eurocopter France Model AS 350 B, BA, BB, B1, B2, 
B3, and D, and Model AS355 E, F, F1, F2, and N helicopters. EASA 
advises that ``an internal review revealed that some main and tail 
rotor servo-controls do not conform to the approved design. This 
results in a greater play in the input lever bearing which could lead 
to off-centered lever/distributor slide valve. If not corrected, this 
condition could jam the distributor slide valve in its sleeve, 
contributing to reduced controllability of the rotors.''

Related Service Information

    Eurocopter has issued Emergency Alert Service Bulletin (EASB) No. 
01.00.58, applicable to Model AS 350 B, BA, BB, B1, B2, B3, and D 
helicopters, and EASB No. 01.00.53, applicable to Model AS355 E, F, F1, 
F2, and N helicopters, both Revision 1 and both dated April 19, 2007, 
``to preclude the risk of jamming of the distributor slide valve in its 
sleeve, due to excessive play in the bearing of the servo-control input 
lever.'' Both EASB 01.00.58 and 01.00.53, along with 01.00.22 and 
01.00.23 for various military model helicopters are contained in the 
same EASB document. The EASA classified these EASBs as mandatory and 
issued EASA Emergency AD No. 2007-0141-E, dated May 21, 2007, to ensure 
the continued airworthiness of these helicopters.

FAA's Evaluation and Unsafe Condition Determination

    These products have been approved by the aviation authority of 
France and are approved for operation in the United States. Pursuant to 
our bilateral agreement with France, EASA, their technical 
representative, has notified us of the unsafe condition described in 
the EASA AD. We are issuing this AD because we evaluated all 
information provided by EASA and determined the unsafe condition exists 
and is likely to exist or develop on other products of these same type 
designs. This AD requires replacing all servo-controls with serial 
numbers that are in the Applicability section of this AD.

Differences Between This AD and the EASA AD

    This AD does not require returning servo-controls to the 
manufacturer for return to conformity. This AD does not require 
inspecting for the existence of ``hard points'' in the flight controls 
since this is accomplished during normal pre-flight run-up control 
checks.

Comments

    By publishing the NPRM, we gave the public an opportunity to 
participate in developing this AD. However, we received no comment on 
the NPRM or on our determination of the cost to the public. Therefore, 
based on our review and evaluation of the available data, we have 
determined that air safety and the public interest require adopting the 
AD as proposed, with one minor correction. Note 1 of the NPRM did not 
contain the revision level and dates of the EASB; this AD corrects that 
oversight. We have determined that this change neither increases the 
economic burden on any operator nor increases the scope of the AD.

Costs of Compliance

    We estimate that this AD will affect about 56 helicopters of U.S. 
registry. We also estimate that it will take about 1.5 work-hours per 
helicopter to replace a servo-control identified in the Applicability 
section of this AD. The average labor rate is $85 per work-hour. 
Required parts will cost about $16,500 per helicopter. Based on these 
figures, we estimate that the cost of this AD on U.S. operators is 
$931,140 for the entire fleet, or $16,628 per helicopter.

Regulatory Findings

    We have determined that this AD will not have federalism 
implications under Executive Order 13132. This AD will not have a 
substantial direct effect on the States, on the relationship between 
the national Government and the States, or on the distribution of power 
and responsibilities among the various levels of government.
    For the reasons discussed above, I certify that the regulation:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared an economic evaluation of the estimated costs to comply 
with this AD. See the AD docket to examine the economic evaluation.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. Subtitle VII, Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
subtitle VII, part A, subpart III, section 44701, ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

0
Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority:  49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. Section 39.13 is amended by adding a new airworthiness directive to 
read as follows:

2010-22-08 Eurocopter France: Amendment 39-16487; Docket No. FAA-
2010-0611; Directorate Identifier 2009-SW-18-AD.

    Applicability: Model AS 350 B, BA, B1, B2, B3, and D, and Model 
AS355 E, F, F1, F2, and N helicopters, with a main rotor or tail 
rotor servo-control identified in Table 1, installed, certificated 
in any category.

                                                     Table 1
----------------------------------------------------------------------------------------------------------------
               Component                              Part No. (P/N)                     Serial No. (S/N)
----------------------------------------------------------------------------------------------------------------
Main rotor servo-control...............  P/N SC5083.............................  S/N 270M, 272M, 409M, 423M,
                                                                                   452M, or 1573.

[[Page 65224]]

 
                                         P/N SC5083-1...........................  S/N 2902 through 2921,
                                                                                   inclusive.
                                         P/N 5084...............................  S/N 30, 84, 104, 186, 438,
                                                                                   575, or 695.
                                         P/N 5084-1.............................  S/N 1462 through 1481,
                                                                                   inclusive.
Tail rotor servo-control...............  P/N SC5072.............................  S/N 222M, 306M, or 309.
----------------------------------------------------------------------------------------------------------------

    Compliance: Required, as indicated.
    To prevent the distributor slide valve jamming in its sleeve, 
leading to reduced controllability of the rotors and subsequent loss 
of control of the helicopter, accomplish the following:
    (a) Within the next 50 hours time-in-service (TIS), or when a 
``hard point'' is detected in the flight controls, whichever occurs 
earlier, replace each installed servo control that has a serial 
number listed in Table 1 of this AD, with an airworthy servo 
control.

    Note 1:  Eurocopter EASB No. 01.00.58 and No. 01.00.53, both 
Revision 1, and dated April 19, 2007, which are not incorporated by 
reference, contain additional information about the subject of this 
AD.

    (b) To request a different method of compliance or a different 
compliance time for this AD, follow the procedures in 14 CFR 39.19. 
Contact the Manager, Safety Management Group, Rotorcraft 
Directorate, FAA, ATTN: J. R. Holton, Aviation Safety Engineer, 
Regulations and Policy Group, ASW-111, 2601 Meacham Blvd., Fort 
Worth, Texas 76137, telephone (817) 222-4964, fax (817) 222-5961, 
for information about previously approved alternative methods of 
compliance.
    (c) The Joint Aircraft System/Component (JASC) Code is 6730: 
Rotorcraft Servo System.
    (d) This amendment becomes effective on November 26, 2010.

    Note 2:  The subject of this AD is addressed in European 
Aviation Safety Agency (France) Emergency AD No. 2007-0141-E, dated 
May 21, 2007.


    Issued in Fort Worth, Texas, on October 12, 2010.
Kim Smith,
Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 2010-26565 Filed 10-21-10; 8:45 am]
BILLING CODE 4910-13-P