[Federal Register Volume 75, Number 192 (Tuesday, October 5, 2010)]
[Proposed Rules]
[Page 61361]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: C1-2010-22353]


 ========================================================================
 Proposed Rules
                                                 Federal Register
 ________________________________________________________________________
 
 This section of the FEDERAL REGISTER contains notices to the public of 
 the proposed issuance of rules and regulations. The purpose of these 
 notices is to give interested persons an opportunity to participate in 
 the rule making prior to the adoption of the final rules.
 
 ========================================================================
 

  Federal Register / Vol. 75, No. 192 / Tuesday, October 5, 2010 / 
Proposed Rules  

[[Page 61361]]



DEPARTMENT OF ENERGY

10 CFR Part 429

[Docket No. EERE-2010-BT-CE-0014]
RIN 1904-AC24


Energy Conservation Program: Certification, Compliance, and 
Enforcement for Consumer Products and Commercial and Industrial 
Equipment

Correction

    In proposed rule document 2010-22353 beginning on page 56796 in the 
issue of Thursday, September 16, 2010 make the following correction:


Sec. 429.9  [Corrected]

    On page 56816, in Sec. 429.9(c), in the first column, 
Sec. 429.9(c)(9) through (10) is being printed in its entirety:
    (9)(i) For each basic model of direct heating equipment (not 
including furnaces) a sample of sufficient size shall be tested to 
insure that-
    (A) Any represented value of estimated annual operating cost, 
energy consumption or other measure of energy consumption of a basic 
model for which consumers would favor lower values shall be no less 
than the higher of:
    (1) The mean of the sample, or
    (2) The upper 97\1/2\ percent confidence limit of the true mean 
divided by 1.05, and
    (B) Any represented value of the fuel utilization efficiency or 
other measure of energy consumption of a basic model for which 
consumers would favor higher values shall be no greater than the lower 
of:
    (1) The mean of the sample or
    (2) The lower 97\1/2\ percent confidence limit of the true mean 
divided by 0.95.
    (ii) In calculating the measures of energy consumption for each 
unit tested, use the design heating requirement corresponding to the 
mean of the capacities of the units of the sample.
    (10) For each basic model of conventional cooking tops, 
conventional ovens and microwave ovens a sample of sufficient size 
shall be tested to insure that-
    (i) Any represented value of estimated annual operating cost, 
energy consumption or other measure of energy consumption of a basic 
model for which consumers would favor lower values shall be no less 
than the higher of:
    (A) The mean of the sample, or
    (B) The upper 97\1/2\ percent confidence limit of the true mean 
divided by 1.05, and
    (ii) Any represented value of the energy factor or other measure of 
energy consumption of a basic model for which consumers would favor 
higher values shall be no greater than the lower of:
    (A) The mean of the sample, or
    (B) The lower 97\1/2\ percent confidence limit of the true mean 
divided by 0.95.

[FR Doc. C1-2010-22353 Filed 10-4-10; 8:45 am]
BILLING CODE 1505-01-D