[Federal Register Volume 74, Number 228 (Monday, November 30, 2009)]
[Rules and Regulations]
[Pages 62485-62487]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E9-28305]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2009-0886 Directorate Identifier 2009-CE-045-AD; 
Amendment 39-16109; AD 2009-24-15]
RIN 2120-AA64


Airworthiness Directives; SOCATA Model TBM 700 Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
products listed above. This AD results from mandatory continuing 
airworthiness information (MCAI) issued by an aviation authority of 
another country to identify and correct an unsafe condition on an 
aviation product. The MCAI describes the unsafe condition as:

    It was noticed on assembly line an elongation of bolts 
connecting power leads on R700 and R701 shunts. An incorrect 
tightening torque value is likely to be the cause of the elongation.
    This condition, if left uncorrected could lead to heating, 
electrical arcing or smokes and could result in an in-flight loss of 
electrical power.

We are issuing this AD to require actions to correct the unsafe 
condition on these products.

DATES: This AD becomes effective January 4, 2010.
    On January 4, 2010, the Director of the Federal Register approved 
the incorporation by reference of certain publications listed in this 
AD.

ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov or in person at Document Management Facility, U.S. 
Department of Transportation, Docket Operations, M-30, West Building 
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 
20590.

FOR FURTHER INFORMATION CONTACT: Albert Mercado, Aerospace Engineer, 
FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, 
Missouri 64106; telephone: (816) 329-4119; fax: (816) 329-4090.

SUPPLEMENTARY INFORMATION:

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would apply to the specified products. 
That NPRM was published in the Federal Register on September 28, 2009 
(74 FR 49345). That NPRM proposed to correct an unsafe condition for 
the specified products. The MCAI states:

    It was noticed on assembly line an elongation of bolts 
connecting power leads on R700 and R701 shunts. An incorrect 
tightening torque value is likely to be the cause of the elongation.
    This condition, if left uncorrected could lead to heating, 
electrical arcing or smokes and could result in an in-flight loss of 
electrical power.
    For the reason described above, this Airworthiness Directive 
(AD) mandates the replacement of the power lead bolts on R700 and 
R701 shunts.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We have considered the comment received.

Comment Issue: Costs of Compliance

    Ms. Catherine H[eacute]rau, SOCATA, states the cost of the required 
parts (4 bolts) is $10, not $50. Consequently, the cost of the proposed 
AD on U.S. operators is $2,350 or $50 per product.
    We agree with the commenter, and we are changing the costs of 
compliance in the final rule AD action to reflect the more accurate 
estimated costs.

Conclusion

    We reviewed the available data, including the comment received, and 
determined that air safety and the public interest require adopting the 
AD as proposed.

[[Page 62486]]

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have required different actions in this AD from those 
in the MCAI in order to follow FAA policies. Any such differences are 
highlighted in a NOTE within the AD.

Costs of Compliance

    We estimate that this AD will affect 47 products of U.S. registry. 
We also estimate that it will take about 0.5 work-hour per product to 
comply with the basic requirements of this AD. The average labor rate 
is $80 per work-hour. Required parts will cost about $10 per product. 
Where the service information lists required parts costs that are 
covered under warranty, we have assumed that there will be no charge or 
a lower charge for these parts. As we do not control warranty coverage 
for affected parties, some parties may incur costs higher than 
estimated here.
    Based on these figures, we estimate the cost of this AD to the U.S. 
operators to be $2,350 or $50 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify this AD:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866;
    (2) Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and
    (3) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this AD and placed it in the AD Docket.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains the NPRM, the regulatory evaluation, 
any comments received, and other information. The street address for 
the Docket Office (telephone (800) 647-5527) is in the ADDRESSES 
section. Comments will be available in the AD docket shortly after 
receipt.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator, 
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

2009-24-15 SOCATA: Amendment 39-16109; Docket No. FAA-2009-0886; 
Directorate Identifier 2009-CE-045-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective January 
4, 2010.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to TBM 700 airplanes, serial numbers 434 
through 502, and serial numbers 504 and 505, certificated in any 
category.

Subject

    (d) Air Transport Association of America (ATA) Code 24: Electric 
Power.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:
    It was noticed on assembly line an elongation of bolts 
connecting power leads on R700 and R701 shunts. An incorrect 
tightening torque value is likely to be the cause of the elongation.
    This condition, if left uncorrected could lead to heating, 
electrical arcing or smokes and could result in an in-flight loss of 
electrical power.
    For the reason described above, this Airworthiness Directive 
(AD) mandates the replacement of the power lead bolts on R700 and 
R701 shunts.

Actions and Compliance

    (f) Unless already done, within the next 100 hours time-in-
service after January 4, 2010 (the effective date of this AD), or 
within the next 12 months after January 4, 2010 (the effective date 
of this AD), whichever occurs first, replace the bolts of shunts 
R700 and R701 following DAHER-SOCATA Mandatory Service Bulletin SB 
70-169, dated May 2009.

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
Standards Office, FAA, has the authority to approve AMOCs for this 
AD, if requested using the procedures found in 14 CFR 39.19. Send 
information to Attn: Albert Mercado, Aerospace Engineer, FAA, Small 
Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 
64106; telephone: (816) 329-4119; fax: (816) 329-4090. Before using 
any approved AMOC on any airplane to which the AMOC applies, notify 
your appropriate principal inspector (PI) in the FAA Flight 
Standards District Office (FSDO), or lacking a PI, your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act (44 
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has 
approved the information collection requirements and has assigned 
OMB Control Number 2120-0056.

[[Page 62487]]

Related Information

    (h) Refer to MCAI EASA AD No.: 2009-0174, dated August 11, 2009; 
and DAHER-SOCATA Mandatory Service Bulletin SB 70-169, dated May 
2009, for related information.

Material Incorporated by Reference

    (i) You must use DAHER-SOCATA Mandatory Service Bulletin SB 70-
169, dated May 2009, to do the actions required by this AD, unless 
the AD specifies otherwise.
    (1) The Director of the Federal Register approved the 
incorporation by reference of this service information under 5 
U.S.C. 552(a) and 1 CFR part 51.
    (2) For service information identified in this AD, contact 
SOCATA, 65921--TARBES Cedex 9, France; telephone: +33 6 07 32 62 24; 
or SOCATA NORTH AMERICA, INC., North Perry Airport, 7501 South 
Airport Rd., Pembroke Pines, Florida 33023; telephone: (954) 893-
1400; fax: (954) 964-4141; Internet: http://mysocata.com.
    (3) You may review copies of the service information 
incorporated by reference for this AD at the FAA, Central Region, 
Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 
64106. For information on the availability of this material at the 
Central Region, call (816) 329-3768.
    (4) You may also review copies of the service information 
incorporated by reference for this AD at the National Archives and 
Records Administration (NARA). For information on the availability 
of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

    Issued in Kansas City, Missouri, on November 19, 2009.
Patrick R. Mullen,
Acting Manager, Small Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. E9-28305 Filed 11-27-09; 8:45 am]
BILLING CODE 4910-13-P