[Federal Register Volume 73, Number 124 (Thursday, June 26, 2008)]
[Notices]
[Pages 36375-36376]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E8-14431]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket No. NHTSA-2008-0117]


Notice of Receipt of Petition for Decision That Nonconforming 
2006 Lamborghini Gallardo Roadster Passenger Cars Manufactured Between 
January 1, 2006 and August 31, 2006 Are Eligible for Importation

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Notice of receipt of petition for decision that nonconforming 
2006 Lamborghini Gallardo roadster passenger cars manufactured between 
January 1, 2006 and August 31, 2006 are eligible for importation.

-----------------------------------------------------------------------

SUMMARY: This document announces receipt by the National Highway 
Traffic Safety Administration (NHTSA) of a petition for a decision that 
2006 Lamborghini Gallardo roadster passenger cars manufactured between 
January 1, 2006 and August 31, 2006 that were not originally 
manufactured to comply with all applicable Federal motor vehicle safety 
standards (FMVSS) are eligible for importation into the United States 
because (1) they are substantially similar to vehicles that were 
originally manufactured for sale in the United States and that were 
certified by their manufacturer as complying with the safety standards 
(the U.S.-certified version of the 2006 Lamborghini Gallardo roadster 
passenger cars manufactured between January 1, 2006 and August 31, 
2006,) and (2) they are capable of being readily altered to conform to 
the standards.

DATES: The closing date for comments on the petition is July 28, 2008.

ADDRESSES: Comments should refer to the docket and notice numbers above 
and be submitted by any of the following methods:
     Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting 
comments.
     Mail: Docket Management Facility: U.S. Department of 
Transportation, 1200 New Jersey Avenue, SE., West Building Ground 
Floor, Room W12-140, Washington, DC 20590-0001
     Hand Delivery or Courier: West Building Ground Floor, Room 
W12-140, 1200 New Jersey Avenue, SE., between 9 a.m. and 5 p.m. ET, 
Monday through Friday, except Federal holidays.
     Fax: 202-493-2251.
    Instructions: Comments must be written in the English language, and 
be no greater than 15 pages in length, although there is no limit to 
the length of necessary attachments to the comments. If comments are 
submitted in hard copy form, please ensure that two copies are 
provided. If you wish to receive confirmation that your comments were 
received, please enclose a stamped, self-addressed postcard with the 
comments. Note that all comments received will be posted without change 
to http://www.regulations.gov, including any personal information 
provided. Please see the Privacy Act heading below.
    Privacy Act: Anyone is able to search the electronic form of all 
comments received into any of our dockets by the name of the individual 
submitting the comment (or signing the comment, if submitted on behalf 
of an association, business, labor union, etc.). You may review DOT's 
complete Privacy Act Statement in the Federal Register published on 
April 11, 2000 (65 FR 19477-78) or you may visit http://DocketInfo.dot.gov.
    How To Read Comments Submitted to the Docket: You may read the 
comments received by Docket Management at the address and times given 
above. You may also see the comments on the Internet. To read the 
comments on the Internet, take the following steps:
    (1) Go to the Federal Docket Management System (FDMS) Web page 
http://www.regulations.gov.
    (2) On that page, click on ``Advanced Docket Search.''
    (3) On the next page select ``NATIONAL HIGHWAY TRAFFIC SAFETY 
ADMINISTRATION'' from the drop-down menu in the Agency field and enter 
the Docket ID number shown at the heading of this document.
    (4) After entering that information, click on ``submit.''
    (5) The next page contains docket summary information for the 
docket you selected. Click on the comments you wish to see. You may 
download the comments. Please note that even after the comment closing 
date, we will continue to file relevant information in the Docket as it 
becomes available. Further, some people may submit late comments. 
Accordingly, we recommend that you periodically search the Docket for 
new material.

FOR FURTHER INFORMATION CONTACT: Coleman Sachs, Office of Vehicle 
Safety Compliance, NHTSA (202-366-3151).

SUPPLEMENTARY INFORMATION:

Background

    Under 49 U.S.C. 30141(a)(1)(A), a motor vehicle that was not 
originally manufactured to conform to all applicable FMVSS shall be 
refused admission into the United States unless NHTSA has decided that 
the motor vehicle is substantially similar to a motor vehicle 
originally manufactured for importation into and sale in the United 
States, certified under 49 U.S.C. Sec.  30115, and of the same model 
year as the model of the motor vehicle to be compared, and is capable 
of being readily altered to conform to all applicable FMVSS.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    Automobile Concepts, Inc. (``AMC''), of North Miami, Florida 
(Registered Importer 01-278) has petitioned NHTSA to decide whether 
nonconforming 2006 Lamborghini Gallardo roadster passenger cars 
manufactured between January 1, 2006 and August 31, 2006 are eligible 
for importation into the United States. The vehicles which AMC believes 
are substantially similar are 2006 Lamborghini Gallardo roadster 
passenger cars manufactured between January 1, 2006 and August 31, 2006 
that were manufactured for sale in the United States and certified by 
their manufacturer as conforming to all applicable FMVSS.

[[Page 36376]]

    The petitioner claims that it compared non-U.S. certified 2006 
Lamborghini Gallardo roadster passenger cars manufactured between 
January 1, 2006 and August 31, 2006 to their U.S.-certified 
counterparts, and found the vehicles to be substantially similar with 
respect to compliance with most FMVSS.
    AMC submitted information with its petition intended to demonstrate 
that non-U.S. certified 2006 Lamborghini Gallardo roadster passenger 
cars manufactured between January 1, 2006 and August 31, 2006, as 
originally manufactured, conform to many FMVSS in the same manner as 
their U.S. certified counterparts, or are capable of being readily 
altered to conform to those standards.
    Specifically, the petitioner claims that non-U.S. certified 2006 
Lamborghini Gallardo roadster passenger cars manufactured between 
January 1, 2006 and August 31, 2006 are identical to their U.S. 
certified counterparts with respect to compliance with Standard Nos. 
102 Transmission Shift Lever Sequence, Starter Interlock, and 
Transmission Braking Effect, 103 Windshield Defrosting and Defogging 
Systems, 104 Windshield Wiping and Washing Systems, 106 Brake Hoses, 
109 New Pneumatic Tires, 113 Hood Latch System, 116 Motor Vehicle Brake 
Fluids, 118 Power-Operated Window, Partition, and Roof Panel Systems, 
124 Accelerator Control Systems, 135 Passenger Car Brake Systems, 201 
Occupant Protection in Interior Impact, 202 Head Restraints, 204 
Steering Control Rearward Displacement, 205 Glazing Materials, 206 Door 
Locks and Door Retention Components, 207 Seating Systems, 212 
Windshield Mounting, 214 Side Impact Protection, 216 Roof Crush 
Resistance, 219 Windshield Zone Intrusion, 225 Child Restraint 
Anchorage Systems, and 302 Flammability of Interior Materials.
    In addition, the petitioner claims that the vehicles comply with 
the Bumper Standard found in 49 CFR Part 581.
    The petitioner also contends that the vehicles are capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: installation of a U.S.-
model instrument cluster and associated hardware and software, or 
modification of the existing instrument cluster to meet the 
requirements of this standard.
    Standard No. 108 Lamps, Reflective Devices and Associated 
Equipment: inspection of all vehicles and installation, on vehicles 
that are not already so equipped, of U.S.-model components to meet the 
requirements of this standard.
    Standard No. 110 Tire Selection and Rims: installation of a tire 
information placard.
    Standard No. 111 Rearview Mirrors: installation of a U.S.-model 
passenger side rearview mirror, or inscription of the required warning 
statement on the face of that mirror.
    Standard No. 114 Theft Protection: installation of a supplemental 
key warning buzzer, or installation of U.S.-version software to meet 
the requirements of this standard.
    Standard No. 208 Occupant Crash Protection: inspection of all 
vehicles and replacement of any non U.S.-model seat belts, air bag 
control units, air bags, and sensors with U.S.-model components on 
vehicles that are not already so equipped; and (b) installation of 
U.S.-version software to ensure that the seat belt warning system meets 
the requirements of this standard.
    The petitioner states that the crash protection system used in 
these vehicles consists of dual front airbags and combination lap and 
shoulder belts at the front outboard seating positions. The seat belt 
systems are described as being self-tensioning, and capable of being 
released by means of a single red push-button.
    Standard No. 209 Seat Belt Assemblies: inspection of all vehicles 
and replacement of any non U.S.-model seat belts with U.S.-certified 
model seat belts.
    Standard No. 210 Seat Belt Assembly Anchorages: inspection of all 
vehicles and replacement of any non U.S.-model seat belts anchorage 
components with U.S.-model components.
    Standard No. 301 Fuel System Integrity: inspection of all vehicles 
and replacement of any non U.S.-model fuel system components with U.S.-
model components.
    The petitioner additionally states that a vehicle identification 
plate must be affixed to the vehicles near the left windshield post to 
meet the requirements of 49 CFR Part 565.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above addresses both before and after 
that date. To the extent possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8.

    Issued on: June 20, 2008.
Jeffrey Giuseppe,
Acting Director, Office of Vehicle Safety Compliance.
[FR Doc. E8-14431 Filed 6-25-08; 8:45 am]
BILLING CODE 4910-59-P