[Federal Register Volume 73, Number 72 (Monday, April 14, 2008)]
[Rules and Regulations]
[Pages 19967-19968]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E8-7167]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2008-0175; Directorate Identifier 2007-CE-105-AD;
Amendment 39-15455; AD 2008-08-03]
RIN 2120-AA64
Airworthiness Directives; Pacific Aerospace Limited Model 750XL
Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for the
products listed above. This AD results from mandatory continuing
airworthiness information (MCAI) issued by an aviation authority of
another country to identify and correct an unsafe condition on an
aviation product. The MCAI describes the unsafe condition as:
To prevent electrical malfunction from causing damage to the
wiring that may result in arcing or fire, accomplish Pacific
Aerospace Service Bulletin PACSB/XL/008.
We are issuing this AD to require actions to correct the unsafe
condition on these products.
DATES: This AD becomes effective May 19, 2008.
On May 19, 2008, the Director of the Federal Register approved the
incorporation by reference of certain publications listed in this AD.
ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov or in person at Document Management Facility, U.S.
Department of Transportation, Docket Operations, M-30, West Building
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC
20590.
FOR FURTHER INFORMATION CONTACT: Karl Schletzbaum, Aerospace Engineer,
FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR
part 39 to include an AD that would apply to the specified products.
That NPRM was published in the Federal Register on February, 15, 2008
(73 FR 8831). That NPRM proposed to correct an unsafe condition for the
specified products. The MCAI states:
To prevent electrical malfunction from causing damage to the
wiring that may result in arcing or fire, accomplish Pacific
Aerospace Service Bulletin PACSB/XL/008.
The MCAI requires the addition and replacement of certain pitot heat
sensor circuit breakers and the addition of a cooling fan circuit.
Comments
We gave the public the opportunity to participate in developing
this AD. We received no comments on the NPRM or on the determination of
the cost to the public.
Conclusion
We reviewed the available data and determined that air safety and
the public interest require adopting the AD as proposed.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have required different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a NOTE within the AD.
Costs of Compliance
We estimate that this AD will affect 7 products of U.S. registry.
We also estimate that it will take about 1.5 work-hours per product to
comply with basic requirements of this AD. The average labor rate is
$80 per work-hour. Required parts will cost about $181 per product.
Based on these figures, we estimate the cost of the proposed AD on
U.S. operators to be $2,107, or $301 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications
under Executive Order 13132. This AD will not have a substantial direct
effect on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government.
For the reasons discussed above, I certify this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866;
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and
(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD Docket.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains the NPRM, the
[[Page 19968]]
regulatory evaluation, any comments received, and other information.
The street address for the Docket Office (telephone (800) 647-5527) is
in the ADDRESSES section. Comments will be available in the AD docket
shortly after receipt.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2008-08-03 Pacific Aerospace Limited: Amendment 39-15455; Docket No.
FAA-2008-0175; Directorate Identifier 2007-CE-105-AD.
Effective Date
(a) This airworthiness directive (AD) becomes effective May 19,
2008.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Pacific Aerospace Limited Model 750XL
airplanes, serial numbers 101 through 107, certificated in any
category.
Subject
(d) Air Transport Association of America (ATA) Code 31:
Instruments.
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states:
To prevent electrical malfunction from causing damage to the
wiring that may result in arcing or fire, accomplish Pacific
Aerospace Service Bulletin PACSB/XL/008.
The MCAI requires the addition and replacement of certain pitot
heat sensor circuit breakers and the addition of a cooling fan
circuit.
Actions and Compliance
(f) Unless already done, within 100 hours time-in-service May
19, 2008 (the effective date of this AD), do the following actions
following Pacific Aerospace Corporation Limited Mandatory Service
Bulletin PACSB/XL/008, dated July 8, 2004:
(1) For airplanes only authorized to operate under visual flight
rules (VFR) flight:
(i) Add a ten-amp circuit breaker supplying the pitot heat
system to the left hand switch panel;
(ii) Replace the switching circuit breaker used as the pitot
heat selector with a switch; and
(iii) Add a three-amp fuse at the power bus at the supply to the
avionics cooling fan connection.
(2) For airplanes with serial numbers 101 through 107 that have
been modified to operate under instrument flight rules (IFR) flight,
contact Pacific Aerospace Corporation Limited at Pacific Aerospace
Limited, Private Bag HN3027, Hamilton, New Zealand, telephone: +(64)
7-843-6144, fax: +(64) 7-843-6134, e-mail: [email protected].,
for FAA-approved procedures to comply with this AD, and follow the
procedures prior to further flight.
FAA AD Differences
Note: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(g) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
Standards Office, FAA, has the authority to approve AMOCs for this
AD, if requested using the procedures found in 14 CFR 39.19. Send
information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA,
Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090.
Before using any approved AMOC on any airplane to which the AMOC
applies, notify your appropriate principal inspector (PI) in the FAA
Flight Standards District Office (FSDO), or lacking a PI, your local
FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the provisions of the Paperwork Reduction Act (44
U.S.C. 3501 et.seq.), the Office of Management and Budget (OMB) has
approved the information collection requirements and has assigned
OMB Control Number 2120-0056.
Related Information
(h) Refer to MCAI Civil Aviation Authority of New Zealand AD
DCA/750XL/2, dated September 30, 2004; and Pacific Aerospace
Corporation Limited Mandatory Service Bulletin PACSB/XL/008, dated
July 8, 2004, for related information.
Material Incorporated by Reference
(h) You must use Pacific Aerospace Corporation Limited Mandatory
Service Bulletin PACSB/XL/008, dated July 8, 2004; Pacific Aerospace
Corporation Ltd 750XL Maintenance Manual Drawing 11-81101, Assembly,
Switch Panel--LH, dated October 15, 2003; and Pacific Aerospace
Corporation Ltd 750XL Maintenance Manual Drawing 11-81519,
Schematics Miscellaneous Circuits, dated October 10, 2003, to do the
actions required by this AD, unless the AD specifies otherwise.
(1) The Director of the Federal Register approved the
incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact
Pacific Aerospace Corporation Limited at Pacific Aerospace Limited,
Private Bag HN3027, Hamilton, New Zealand, telephone: +(64) 7-843-
6144, fax: +(64) 7-843-6134, e-mail: [email protected].
(3) You may review copies at the FAA, Central Region, Office of
the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri
64106; or at the National Archives and Records Administration
(NARA). For information on the availability of this material at
NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
Issued in Kansas City, Missouri, on March 31, 2008.
Kim Smith,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. E8-7167 Filed 4-11-08; 8:45 am]
BILLING CODE 4910-13-P