[Federal Register Volume 71, Number 189 (Friday, September 29, 2006)]
[Rules and Regulations]
[Pages 57403-57405]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 06-8284]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2006-25896; Directorate Identifier 2006-NE-33-AD; 
Amendment 39-14775; AD 2006-20-06]
RIN 2120-AA64


Airworthiness Directives; General Electric Company CF34-10E 
Series Turbofan Engines

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: The FAA is adopting a new airworthiness directive (AD) for 
General Electric Company (GE) CF34-10E series turbofan engines. This AD 
requires removing the main fuel pump (MFP) inlet strainer from certain 
MFPs, installing a certain replacement flange as an interim repair, and 
performing initial and repetitive visual inspections of the main fuel 
filter. This AD results from three reports of release of the tripod 
support legs on the MFP inlet strainer, leading to engine in-flight 
shutdown. We are issuing this AD to prevent engine in-flight shutdown 
due to MFP malfunctions.

DATES: This AD becomes effective October 16, 2006. The Director of the 
Federal Register approved the incorporation by reference of certain 
publications listed in the regulations as of October 16, 2006.
    We must receive any comments on this AD by November 28, 2006.

ADDRESSES: Use one of the following addresses to comment on this AD:
     DOT Docket Web site: Go to http://dms.dot.gov and follow 
the instructions for sending your comments electronically.
     Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your 
comments electronically.
     Mail: Docket Management Facility; U.S. Department of 
Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, 
Washington, DC 20590-0001.
     Fax: (202) 493-2251.
     Hand Delivery: Room PL-401 on the plaza level of the 
Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 
a.m. and 5 p.m., Monday through Friday, except Federal holidays.
    Contact General Electric Company via Lockheed Martin Technology 
Services, 10525 Chester Road, Suite C, Cincinnati, Ohio 45215, 
telephone (513) 672-8400, fax (513) 672-8422.

FOR FURTHER INFORMATION CONTACT: Tara Fitzgerald, Aerospace Engineer, 
Engine Certification Office, FAA, Engine and Propeller Directorate, 12 
New England Executive Park, Burlington, MA 01803; telephone: (781) 238-
7130, fax: (781) 238-7199.

SUPPLEMENTARY INFORMATION: In August 2006, we became aware of one 
report, and in September 2006, two reports of cracking and release of 
the tripod support legs on the MFP inlet strainer, leading to engine 
in-flight shutdown, on GE CF34-10E series turbofan engines. When the 
tripod support legs release, they travel downstream and impact against 
the MFP gear assembly. This causes the MFP to jam, interrupting fuel 
flow, which leads to engine flameout. Investigations are ongoing, and 
our preliminary determination is that the cause of failure is a 
manufacturing quality control problem with the MFP inlet strainers. 
Current field data shows that the failures are an infant mortality type 
of failure. This AD requires removing the low-time strainers first. 
This condition, if not corrected, could result in an engine in-flight 
shutdown due to MFP malfunctions.

Relevant Service Information

    We have reviewed and approved the technical contents of GE Alert 
Service Bulletin (ASB) No. CF34-10E S/B 73-A0011, dated September 15, 
2006. That ASB describes procedures for removing the MFP inlet 
strainer, installing a certain replacement flange as an interim repair, 
and initial and repetitive visual inspections of the main fuel filter.

FAA's Determination and Requirements of This AD

    The unsafe condition described previously is likely to exist or 
develop on other GE CF34-10E series turbofan engines of the same type 
design. For that reason, we are issuing this AD to prevent engine in-
flight shutdown due to MFP malfunctions. This AD requires:
     Within 40 engine flight hours after the effective date of 
this AD, removing the MFP inlet strainer from the affected MFPs listed 
by serial number in GE ASB No. CF34-10E S/B 73-A0011, dated September 
15, 2006; and
     Within 150 engine flight hours after the effective date of 
this AD, removing all other MFP inlet strainers; and
     Installing a certain replacement flange in all MFPs as an 
interim repair; and
     Remarking the MFP part number from 2043M12P03 to 
2043M12P04; and
     Performing initial and repetitive visual inspections of 
the main fuel filter.
    You must use the service information described previously to 
perform the actions required by this AD.

FAA's Determination of the Effective Date

    Since an unsafe condition exists that requires the immediate 
adoption of this AD, we have found that notice and opportunity for 
public comment before issuing this AD are impracticable, and that good 
cause exists for making this amendment effective in less than 30 days.

Interim Action

    These actions are interim actions and we may take further 
rulemaking actions in the future.

Comments Invited

    This AD is a final rule that involves requirements affecting flight 
safety and was not preceded by notice and an opportunity for public 
comment; however, we invite you to send us any written relevant data, 
views, or arguments regarding this AD. Send your comments to an address 
listed under ADDRESSES. Include ``AD Docket No. FAA-2006-25896; 
Directorate Identifier 2006-NE-33-AD'' in the subject line of your 
comments. We specifically invite comments on the overall regulatory, 
economic, environmental, and energy aspects of the rule that might 
suggest a need to modify it.
    We will post all comments we receive, without change, to http://dms.dot.gov, including any personal information you provide. We will 
also post a report summarizing each substantive verbal contact with FAA 
personnel concerning this AD. Using the search function of the DMS Web 
site, anyone can find and read the comments in any of our dockets, 
including the

[[Page 57404]]

name of the individual who sent the comment (or signed the comment on 
behalf of an association, business, labor union, etc.). You may review 
the DOT's complete Privacy Act Statement in the Federal Register 
published on April 11, 2000 (65 FR 19477-78) or you may visit http://dms.dot.gov.

Examining the AD Docket

    You may examine the docket that contains the AD, any comments 
received, and any final disposition in person at the Docket Management 
Facility Docket Office between 9 a.m. and 5 p.m., Monday through 
Friday, except Federal holidays. The Docket Office (telephone (800) 
647-5227) is located on the plaza level of the Department of 
Transportation Nassif Building at the street address stated in 
ADDRESSES. Comments will be available in the AD docket shortly after 
the DMS receives them.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, Section 106, describes the 
authority of the FAA Administrator. Subtitle VII, Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
Subtitle VII, Part A, Subpart III, Section 44701, ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We have determined that this AD will not have federalism 
implications under Executive Order 13132. This AD will not have a 
substantial direct effect on the States, on the relationship between 
the national Government and the States, or on the distribution of power 
and responsibilities among the various levels of government.
    For the reasons discussed above, I certify that the regulation:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a summary of the costs to comply with this AD and 
placed it in the AD Docket. You may get a copy of this summary at the 
address listed under ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Under the authority delegated to me by the Administrator, the Federal 
Aviation Administration amends part 39 of the Federal Aviation 
Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive:

2006-20-06 General Electric Company: Amendment 39-14775. Docket No. 
FAA-2006-25896; Directorate Identifier 2006-NE-33-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective October 
16, 2006.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to General Electric Company (GE) CF34-
10E2A1, -10E5, -10E5A1, -10E6, -10E6A1, and -10E7 turbofan engines. 
These engines are installed on, but not limited to, Embraer ERJ 190-
100-STD, ERJ 190-100-LR, and ERJ 190-100-IGW airplanes.

Unsafe Condition

    (d) This AD results from three reports of release of the tripod 
support legs on the main fuel pump (MFP) fuel inlet strainer, 
leading to engine in-flight shutdown. We are issuing this AD to 
prevent engine in-flight shutdown due to MFP malfunctions.

Compliance

    (e) You are responsible for having the actions required by this 
AD performed within the compliance times specified unless the 
actions have already been done.

Removal of Main Fuel Pump Inlet Strainers

    (f) Within 40 engine flight hours after the effective date of 
this AD, remove the MFP inlet strainer from the affected MFPs listed 
by serial number in paragraph D. of GE Alert Service Bulletin (ASB) 
No. CF34-10E S/B 73-A0011, dated September 15, 2006.
    (g) Within 150 engine flight hours after the effective date of 
this AD, remove all other MFP inlet strainers.
    (h) Install a replacement flange, part number 837683, in all 
MFPs as an interim repair.
    (i) Remark the MFP part number from 2043M12P03 to 2043M12P04.
    (j) When performing the actions in paragraphs (f), (g), (h), and 
(i) of this AD, use paragraphs 3.A. through 3.E.(1)(c) of the 
Accomplishment Instructions of GE ASB No. CF34-10E S/B 73-A0011, 
dated September 15, 2006.

Inspection of Main Fuel Filters

    (k) Perform an initial visual inspection of the main fuel filter 
at the time of MFP inlet strainer removal in paragraphs (f) and (g) 
of this AD.
    (l) Perform repetitive visual inspections of the main fuel 
filter within every additional 160 engine flight hours.
    (m) When performing main fuel filter visual inspections in 
paragraphs (k) and (l) of this AD, use paragraphs 3.F.(1) through 
3.F.(6) of the Accomplishment Instructions of GE ASB No. CF34-10E S/
B 73-A0011, dated September 15, 2006.

Recommended Actions

    (n) We recommend that operators avoid performing the actions in 
this AD on both engines installed on the same airplane at the same 
time, if at all possible.

Alternative Methods of Compliance

    (o) The Manager, Engine Certification Office, has the authority 
to approve alternative methods of compliance for this AD if 
requested using the procedures found in 14 CFR 39.19.

Related Information

    (p) Brazilian emergency airworthiness directive No. 2006-09-04, 
dated September 15, 2006, also addresses the subject of this AD.

Material Incorporated by Reference

    (q) You must use General Electric Company Alert Service Bulletin 
No. CF34-10E S/B 73-A0011, dated September 15, 2006, to perform the 
actions required by this AD. The Director of the Federal Register 
approved the incorporation by reference of this service bulletin in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact General 
Electric Company via Lockheed Martin Technology Services, 10525 
Chester Road, Suite C, Cincinnati, Ohio 45215, telephone (513) 672-
8400, fax (513) 672-8422, for a copy of this service information. 
You may review copies at the FAA, New England Region, Office of the 
Regional Counsel, 12 New England Executive Park, Burlington, MA; or 
at the National Archives and Records Administration (NARA). For 
information on the availability of this material at NARA, call 202-
741-6030, or go

[[Page 57405]]

to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Francis A. Favara,
Manager, Engine and Propeller Directorate, Aircraft Certification 
Service.
[FR Doc. 06-8284 Filed 9-28-06; 8:45 am]
BILLING CODE 4910-13-P