[Federal Register Volume 70, Number 237 (Monday, December 12, 2005)]
[Proposed Rules]
[Pages 73391-73392]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 05-23898]


 ========================================================================
 Proposed Rules
                                                 Federal Register
 ________________________________________________________________________
 
 This section of the FEDERAL REGISTER contains notices to the public of 
 the proposed issuance of rules and regulations. The purpose of these 
 notices is to give interested persons an opportunity to participate in 
 the rule making prior to the adoption of the final rules.
 
 ========================================================================
 

  Federal Register / Vol. 70, No. 237 / Monday, December 12, 2005 / 
Proposed Rules  

[[Page 73391]]



DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 95-ANE-10-AD]
RIN 2120-AA64


Airworthiness Directives; General Electric Company CF6 Series 
Turbofan Engines

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: The FAA proposes to supersede an existing airworthiness 
directive (AD) for General Electric Company (GE) CF6-45/-50 series 
turbofan engines. That AD currently requires an initial and repetitive 
on-wing visual inspection of the side links of the five-link forward 
mount assembly for cracks, and replacement of the side links and pylon 
attachment bolts and inspection of the fail-safe bolt and platform lug 
if the side links are cracked. That AD also requires a shop-level 
refurbishment of the side links as a terminating action to the on-wing 
inspection program. This proposed AD would require inspecting and 
refurbishing the side link at every exposure of the side link. This 
proposed AD would also require the same actions on certain part number 
side links installed on CF6-80A turbofan engines. This proposed AD 
results from a report of a cracked side link. We are proposing this AD 
to prevent failure of the side links and possible engine separation 
from the airplane.

DATES: We must receive any comments on this proposed AD by February 10, 
2006.

ADDRESSES: Use one of the following addresses to comment on this 
proposed AD:
     By mail: Federal Aviation Administration (FAA), New 
England Region, Office of the Regional Counsel, Attention: Rules Docket 
No. 95-ANE-10-AD, 12 New England Executive Park, Burlington, MA 01803-
5299.
     By fax: (781) 238-7055.
     By e-mail: [email protected].
    You can get the service information identified in this proposed AD 
from General Electric Aircraft Engines, CF6 Distribution Clerk, Room 
132, 111 Merchant Street, Cincinnati, OH 45246.
    You may examine the AD docket at the FAA, New England Region, 
Office of the Regional Counsel, 12 New England Executive Park, 
Burlington, MA.

FOR FURTHER INFORMATION CONTACT: Karen Curtis, Aerospace Engineer, 
Engine Certification Office, FAA, Engine and Propeller Directorate, 12 
New England Executive Park, Burlington, MA 01803-5299; telephone (617) 
238-7192; fax (617) 238-7199.

SUPPLEMENTARY INFORMATION:

Comments Invited

    We invite you to send any written relevant data, views, or 
arguments regarding this proposal. Send your comments to an address 
listed under ADDRESSES. Include ``AD Docket No. 95-ANE-10-AD'' in the 
subject line of your comments. If you want us to acknowledge receipt of 
your mailed comments, send us a self-addressed, stamped postcard with 
the docket number written on it; we will date-stamp your postcard and 
mail it back to you. We specifically invite comments on the overall 
regulatory, economic, environmental, and energy aspects of the proposed 
AD. If a person contacts us verbally, and that contact relates to a 
substantive part of this proposed AD, we will summarize the contact and 
place the summary in the docket. We will consider all comments received 
by the closing date and may amend the proposed AD in light of those 
comments.

Examining the AD Docket

    You may examine the AD Docket (including any comments and service 
information), by appointment, between 8:00 a.m. and 4:30 p.m., Monday 
through Friday, except Federal holidays. See ADDRESSES for the 
location.

Discussion

    On August 15, 1995, the FAA issued AD 95-17-15, Amendment 39-9346 
(60 FR 46758, September 8, 1995). That AD requires an initial and 
repetitive on-wing visual inspection of the side links of the five-link 
forward mount assembly for cracks, and replacement of the side links 
and pylon attachment bolts and inspection of the fail-safe bolt and 
platform lug, if side links are found cracked. That AD also requires a 
shop-level refurbishment of the side links as a terminating action to 
the on-wing inspection program. That AD was the result of six reports 
of cracked side links detected during routine engine shop visits. That 
condition, if not corrected, could result in failure of the side links 
and possible engine separation from the airplane.

Actions Since We Issued AD 95-17-15

    Since we issued AD 95-17-15, a routine inspection at a shop visit 
found a cracked side link. A review of the records of the cracked part 
showed that it was previously refurbished and was in compliance with AD 
95-17-15. That AD required initial and repetitive on-wing inspection of 
the CF6-45/50 side links until refurbished using GE Service Bulletin 
72-1092, dated November 18, 1994. Refurbishment includes reapplication 
of the protective Sermetel W coating. That AD didn't specify any 
repetitive refurbishment. That AD also didn't include initial or 
repetitive inspections of the side links installed on CF6-80A series 
engines, even though some P/Ns are common to both engine series. The 
manufacturer previously issued several documents including Commercial 
Engine Services Memoranda (CESM) 201, All Operator Wires, and service 
bulletins recommending inspecting and refurbishing the side links per 
the engine manual at each piece part exposure for both the CF6-45/-50 
and the CF6-80A series engines. The manufacturer recently issued 
temporary revisions to Chapter 5 of the Airworthiness Limitations 
sections of the CF6-45/-50 and CF6-80A engine manuals to require 
inspecting and refurbishing the side links every time one or more of 
the bolts attaching the side link to the fan frame-front high pressure 
compressor case or the bolt attaching the side link to the mount 
platform are removed.

Relevant Service Information

    We have reviewed and approved the technical contents of GE Aircraft

[[Page 73392]]

Engines (GEAE) Service Bulletins CF6-50 S/B 72-1255, dated January 26, 
2005, and CF6-80A S/B 72-0797, dated January 26, 2005, that describe 
procedures for inspecting and refurbishing the side links.

FAA's Determination and Requirements of the Proposed AD

    We have evaluated all pertinent information and identified an 
unsafe condition that is likely to exist or develop on other products 
of this same type design. We are proposing this AD, which would require 
inspecting and refurbishing the side links at each exposure of the side 
link. The proposed AD would require that you do these actions using the 
service information described previously.

Costs of Compliance

    We estimate that this proposed AD would affect 195 engines 
installed on U.S. registered airplanes per year. We also estimate that 
it would take 8.0 work hours per engine to perform the proposed 
actions, and that the average labor rate is $65 per work hour. This AD 
does not require parts. Based on these figures, we estimate the total 
cost of the proposed AD to U.S. operators to be $101,400 per year.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, Section 106, describes the 
authority of the FAA Administrator. Subtitle VII, Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
Subtitle VII, Part A, Subpart III, Section 44701, ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We have determined that this proposed AD would not have federalism 
implications under Executive Order 13132. This proposed AD would not 
have a substantial direct effect on the States, on the relationship 
between the national Government and the States, or on the distribution 
of power and responsibilities among the various levels of government.
    For the reasons discussed above, I certify that the proposed 
regulation:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Would not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a summary of the costs to comply with this proposal and 
placed it in the AD Docket. You may get a copy of this summary by 
sending a request to us at the address listed under ADDRESSES. Include 
``AD Docket No. 95-ANE-10-AD'' in your request.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 14 
CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

    2. The FAA amends Sec.  39.13 by removing Amendment 39-9346 (60 FR 
46758, September 8, 1995) and by adding a new airworthiness directive 
to read as follows:

General Electric Company: Docket No. 95-ANE-10-AD.

Comments Due Date

    (a) The Federal Aviation Administration (FAA) must receive 
comments on this airworthiness directive (AD) action by February 10, 
2006.

Affected ADs

    (b) This AD supersedes AD 95-17-15, Amendment 39-9346.

Applicability

    (c) This AD applies to General Electric (GE) CF6-45/-50 and CF6-
80A turbofan engines with left-hand side links part numbers (P/Ns) 
9204M94P01, 9204M94P03, and 9346M99P01, and right-hand side links, 
P/Ns 9204M94P02, 9204M94P04, and 9346M99P02, installed on the five-
link forward engine mount assembly (also known as Configuration 2). 
These engines are installed on, but not limited to, Boeing DC10-15, 
DC10-30, 767, and 747 series airplanes and Airbus Industrie A300 and 
A310 series airplanes.

Unsafe Condition

    (d) This AD results from a report of a cracked side link. We are 
issuing this AD to prevent failure of the side links and possible 
engine separation from the airplane.

Compliance

    (e) You are responsible for having the actions required by this 
AD performed at every exposure of the side link.

Inspecting and Refurbishing the Side Links

    (f) Inspect and refurbish each side link at every exposure of 
the side links. Use the following GE Aircraft Engines (GEAE) service 
bulletins (SBs):
    (1) For CF6-45/-50 series engines, use 3.A. through 3.E. of the 
Accomplishment Instructions of GEAE SB CF6-50 S/B 72-1255, dated 
January 26, 2005.
    (2) For CF6-80A series engines, use 3.A. through 3.E. of the 
Accomplishment Instructions of GEAE SB CF6-80A S/B 72-0797, dated 
January 26, 2005.

Definition of Exposure of Side Link

    (g) A side link is exposed when one or more bolts that attach 
the side links to the fan frame--front high pressure compressor case 
are removed, or when the bolt attaching the side link to the mount 
platform is removed.

Alternative Methods of Compliance

    (h) The Manager, Engine Certification Office, has the authority 
to approve alternative methods of compliance for this AD if 
requested using the procedures found in 14 CFR 39.19.

Related Information

    (i) None.

    Issued in Burlington, Massachusetts, on December 1, 2005.
Peter A. White,
Acting Manager, Engine and Propeller Directorate, Aircraft 
Certification Service.
[FR Doc. 05-23898 Filed 12-9-05; 8:45 am]
BILLING CODE 4910-13-P