[Federal Register Volume 68, Number 188 (Monday, September 29, 2003)]
[Notices]
[Page 56037]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 03-24545]


-----------------------------------------------------------------------

SMALL BUSINESS ADMINISTRATION


Small Business Size Standards; Waiver of the Nonmanufacturer Rule

AGENCY: Small Business Administration.

ACTION: Notice of intent to grant the Nonmanufacturer Rule for 
Ammunition (Except Small Arms).

-----------------------------------------------------------------------

SUMMARY: The U.S. Small Business Administration (SBA) is considering 
granting a waiver of the Nonmanufacturer Rule for Ammunition (Except 
Small Arms). The basis for waivers is that no small business 
manufacturers are supplying these classes of products to the Federal 
government. The effect of a waiver would be to allow otherwise 
qualified regular dealers to supply the products of any domestic 
manufacturer on a Federal contract set aside for small businesses or 
awarded through the SBA 8(a) Program. The purpose of this notice is to 
solicit comments and potential source information from interested 
parties.

DATES: Comments and sources must be submitted on or before October 10, 
2003.

ADDRESSES: Edith Butler, Program Analyst, U.S. Small Business 
Administration, 409 3rd Street, SW., Washington DC, 20416, Tel: (202) 
619-0422.

FOR FURTHER INFORMATI0N CONTACT: Edith Butler, Program Analyst, (202) 
619-0422, Fax (202) 205-7280.

SUPPLEMENTARY INFORMATION: Pub. L. 100-656, enacted on November 15, 
1988, incorporated into the Small Business Act the previously existing 
regulation that recipients of Federal contracts set aside for small 
businesses or SBA 8(a) Program procurement must provide the product of 
a small business manufacturer or processor, if the recipient is other 
than the actual manufacturer or processor. This requirement is commonly 
referred to as the Nonmanufacturer Rule. The SBA regulations imposing 
this requirement are found at 13 CFR 121.406 (b). Section 303(h) of the 
law provides for waiver of this requirement by SBA for any ``class of 
products'' for which there are no small business manufacturers or 
processors in the Federal market.
    To be considered available to participate in the Federal market on 
these classes of products, a small business manufacturer must have 
submitted a proposal for a contract solicitation or received a contract 
from the Federal government within the last 24 months. The SBA defines 
``class of products'' based on six digit North American Industry 
Classification System (NAICS) and the four digit Product and Service 
Code established by the Federal Procurement Data System.
    The U.S. Small Business Administration is currently processing a 
request to waive the Nonmanufacturer Rule for Ammunition (Except Small 
Arms), North American Industry Classification System (NAICS) 332993. 
The public is invited to comment or provide source information to SBA 
on the proposed waiver of the nonmanufacturer rule for this NAICS code.

Luz Hopewell,
Associate Administrator for Government Contracting.
[FR Doc. 03-24545 Filed 9-26-03; 8:45 am]
BILLING CODE 8025-01-P