[Federal Register Volume 68, Number 144 (Monday, July 28, 2003)]
[Rules and Regulations]
[Pages 44196-44197]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 03-18790]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2002-NM-62-AD; Amendment 39-13246; AD 2003-15-04]
RIN 2120-AA64


Airworthiness Directives; BAE Systems (Operations) Limited 
(Jetstream) Model 4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all BAE Systems (Operations) Limited (Jetstream) Model 
4101 airplanes, that requires inspection of the drive trunnion pins for 
the main landing gear (MLG) doors to determine the part number of the 
pins and corrective action if necessary. The actions specified by this 
AD are intended to prevent failure of the MLG and consequent reduced 
controllability of the airplane during takeoff or landing.

DATES: Effective September 2, 2003.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of September 2, 2003.

ADDRESSES: The service information referenced in this AD may be 
obtained from British Aerospace Regional Aircraft American Support, 
13850 Mclearen Road, Herndon, Virginia 20171. This information may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., Suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Todd Thompson, Aerospace Engineer, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-1175, fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all BAE Systems (Operations) 
Limited (Jetstream) Model 4101 airplanes was published in the Federal 
Register on April 15, 2003 (68 FR 18168). That action proposed to 
require inspection of the drive trunnion pins for the main landing gear 
(MLG) doors to determine the part number of the pins, and corrective 
action if necessary.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Changes to 14 CFR Part 39/Effect on the AD

    On July 10, 2002, the FAA issued a new version of 14 CFR part 39 
(67 FR 47997, July 22, 2002), which governs the FAA's airworthiness 
directives system. The regulation now includes material that relates to 
altered products, special flight permits, and alternative methods of 
compliance. However, for clarity and consistency in this final rule, we 
have retained the language of the NPRM regarding that material.

Change to Labor Rate Estimate

    After the proposed AD was issued, we reviewed the figures we use to 
calculate the labor rate to do the required actions. To account for 
various inflationary costs in the airline industry, we find it 
appropriate to increase the labor rate used in these calculations from 
$60 to $65 per work hour. The economic impact information below has 
been revised to reflect this increase in the specified hourly labor 
rate.

Cost Impact

    The FAA estimates that 57 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 2 work hours per 
airplane to accomplish the required actions, and that the average labor 
rate is $65 per work hour. Based on these figures, the cost impact of 
the AD on U.S. operators is estimated to be $7,410, or $130 per 
airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration

[[Page 44197]]

amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. Section 39.13 is amended by adding the following new airworthiness 
directive:

2003-15-04 BAE Systems (Operations) Limited (Formerly British 
Aerospace Regional Aircraft): Amendment 39-13246. Docket 2002-NM-62-
AD.

    Applicability: All Model Jetstream 4101 airplanes, certificated 
in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the main landing gear (MLG) and consequent 
reduced controllability of the airplane during takeoff or landing, 
accomplish the following:

Inspection, and Replacement if Necessary

    (a) Within 60 days after the effective date of this AD, perform 
a general visual inspection of the drive trunnion pins for the MLG 
doors to determine the part number (P/N) of the pins, per ``Part 1--
Inspection'' of the Accomplishment Instructions of BAE Systems 
(Operations) Limited Service Bulletin J41-32-080, dated January 24, 
2002.

    Note 2: For the purposes of this AD, a general visual inspection 
is defined as: ``A visual examination of an interior or exterior 
area, installation, or assembly to detect obvious damage, failure, 
or irregularity. This level of inspection is made from within 
touching distance unless otherwise specified. A mirror may be 
necessary to enhance visual access to all exposed surfaces in the 
inspection area. This level of inspection is made under normally 
available lighting conditions such as daylight, hangar lighting, 
flashlight, or droplight and may require removal or opening of 
access panels or doors. Stands, ladders, or platforms may be 
required to gain proximity to the area being checked.''

    (1) If P/N AIR135154 is found on both pins: No further action is 
required by this paragraph.
    (2) If any pin having P/N AIR134402 is found, or if any pin 
having no P/N is found: Within 90 days after accomplishing the 
inspection, replace the pin having P/N AIR134402 or the pin having 
no P/N, with a new, improved pin, per ``Part 2--Rectification'' of 
the Accomplishment Instructions of the service bulletin.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, 
Transport Airplane Directorate, FAA. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with BAE Systems 
(Operations) Limited Service Bulletin J41-32-080, dated January 24, 
2002. This incorporation by reference was approved by the Director 
of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR 
part 51. Copies may be obtained from British Aerospace Regional 
Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 
20171. Copies may be inspected at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., Suite 
700, Washington, DC.

    Note 4: The subject of this AD is addressed in British 
airworthiness directive 007-01-2002.

Effective Date

    (e) This amendment becomes effective on September 2, 2003.

    Issued in Renton, Washington, on July 18, 2003.
Ali Bahrami,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 03-18790 Filed 7-25-03; 8:45 am]
BILLING CODE 4910-13-P