[Federal Register Volume 66, Number 168 (Wednesday, August 29, 2001)]
[Proposed Rules]
[Pages 45655-45656]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-21751]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2001-NM-130-AD]
RIN 2120-AA64


Airworthiness Directives; McDonnell Douglas Model MD-90-30 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to certain McDonnell Douglas Model 
MD-90-30 series airplanes. This proposal would require installation of 
two arcing protection brackets below and behind the circuit breakers 
located in the generator control rack in the electrical/electronics 
compartment. This action is necessary to prevent arcing between circuit 
breaker terminals and adjacent equipment and structure located in the 
generator control rack in the electrical/electronics compartment, 
which, if not corrected, could result in possible electrical shock to 
maintenance personnel during maintenance operations. This action is 
intended to address the identified unsafe condition.

DATES: Comments must be received by October 15, 2001.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 2001-NM-130-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except 
Federal holidays. Comments may be submitted via fax to (425) 227-1232. 
Comments may also be sent via the Internet using the following 
address:[email protected]. Comments sent via fax or the 
Internet must contain ``Docket No. 2001-NM-130-AD'' in the subject line 
and need not be submitted in triplicate. Comments sent via the Internet 
as attached electronic files must be formatted in Microsoft Word 97 for 
Windows or ASCII text.
    The service information referenced in the proposed rule may be 
obtained from Boeing Commercial Aircraft Group, Long Beach Division, 
3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data 
and Service Management, Dept. C1-L5A (D800-0024). This information may 
be examined at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at FAA, Los Angeles Aircraft 
Certification Office, 3960 Paramount Boulevard, Lakewood, California.

FOR FURTHER INFORMATION CONTACT: George Y. Mabuni, Aerospace Engineer, 
Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft 
Certification Office, 3960 Paramount Boulevard, Lakewood, California 
90712-4137; telephone (562) 627-5341; fax (562) 627-5210.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule. The proposals contained in this action may be changed in 
light of the comments received.
    Submit comments using the following format:
     Organize comments issue-by-issue. For example, discuss a 
request to change the compliance time and a request to change the 
service bulletin reference as two separate issues.
     For each issue, state what specific change to the proposed 
AD is being requested.
     Include justification (e.g., reasons or data) for each 
request.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this action must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 2001-NM-130-AD.'' The postcard will be date stamped 
and returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the

[[Page 45656]]

FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket 
No. 2001-NM-130-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-
4056.

Discussion

    The FAA has received a report indicating that evidence of arcing 
was found between circuit breaker terminals and adjacent equipment and 
structure located on the generator control rack in the electrical/
electronics compartment. Investigation revealed that arcing occurred 
due to open access to circuit breaker terminals. Such arcing, if not 
corrected, could result in possible electrical shock to maintenance 
personnel during maintenance operations.

Explanation of Relevant Service Information

    The FAA has reviewed and approved McDonnell Douglas Service 
Bulletin MD90-24-007, dated February 7, 1996, which describes 
procedures for installation of two arcing protection brackets below and 
behind the circuit breakers located in the generator control rack in 
the electrical/electronics compartment. Accomplishment of the actions 
specified in the service bulletin is intended to adequately address the 
identified unsafe condition.

Explanation of Requirements of Proposed Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other products of this same type design, the 
proposed AD would require accomplishment of the actions specified in 
the service bulletin described previously.

Cost Impact

    There are approximately 26 Model MD-90-30 series airplanes of the 
affected design in the worldwide fleet. The FAA estimates that 14 
airplanes of U.S. registry would be affected by this proposed AD, that 
it would take approximately 2 work hours per airplane to accomplish the 
proposed actions, and that the average labor rate is $60 per work hour. 
Required parts would cost approximately $200 per airplane. Based on 
these figures, the cost impact of the proposed AD on U.S. operators is 
estimated to be $4,480, or $320 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this proposed AD were not adopted. The cost impact 
figures discussed in AD rulemaking actions represent only the time 
necessary to perform the specific actions actually required by the AD. 
These figures typically do not include incidental costs, such as the 
time required to gain access and close up, planning time, or time 
necessitated by other administrative actions.

Regulatory Impact

    The regulations proposed herein would not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this proposal would not have federalism implications 
under Executive Order 13132.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

McDonnell Douglas: Docket 2001-NM-130-AD.

    Applicability: Model MD-90-30 series airplanes, certificated in 
any category; as identified in McDonnell Douglas Service Bulletin 
MD90-24-007, dated February 7, 1996.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent arcing between circuit breaker terminals and adjacent 
equipment and structure located on the generator control rack in the 
electrical/electronics compartment, and consequent electrical shock 
to maintenance personnel during maintenance operations, accomplish 
the following:

Installation

    (a) Within one year after the effective date of this AD, install 
two arcing protection brackets below and behind the circuit breakers 
located in the generator control rack in the electrical/electronics 
compartment per the Accomplishment Instructions of McDonnell Douglas 
Service Bulletin MD90-24-007, dated February 7, 1996.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO), FAA. Operators shall submit their requests through an 
appropriate FAA Principal Maintenance Inspector, who may add 
comments and then send it to the Manager, Los Angeles ACO.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

Special Flight Permit

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

    Issued in Renton, Washington, on August 22, 2001.
Ali Bahrami,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-21751 Filed 8-28-01; 8:45 am]
BILLING CODE 4910-13-U