[Federal Register Volume 66, Number 76 (Thursday, April 19, 2001)]
[Proposed Rules]
[Page 20122]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-9591]


-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

40 CFR Part 52

[CA191-0278b; FRL-6963-2]


Revisions to the California State Implementation Plan, Ventura 
County Air Pollution Control District

AGENCY: Environmental Protection Agency (EPA).

ACTION: Proposed rule.

-----------------------------------------------------------------------

SUMMARY: EPA is proposing to approve revisions to the Ventura County 
Air Pollution Control District's (VCAPCD) portion of the California 
State Implementation Plan (SIP). These revisions concern volatile 
organic compound (VOC) emissions from the following source categories: 
metal parts and products coating, aerospace assembly and component 
manufacturing, motor vehicle and mobile equipment coating, graphic 
arts, marine coatings, and wood products coatings. We are proposing to 
approve local rules to regulate these emission sources under the Clean 
Air Act as amended in 1990 (CAA or the Act).

DATES: Any comments on this proposal must arrive by May 21, 2001.

ADDRESSES: Mail comments to Andy Steckel, Rulemaking Office Chief (AIR-
4), U.S. Environmental Protection Agency, Region IX, 75 Hawthorne 
Street, San Francisco, CA 94105-3901.
    You can inspect copies of the submitted SIP revisions and EPA's 
technical support documents (TSDs) at our Region IX office during 
normal business hours. You may also see copies of the submitted SIP 
revisions at the following locations:

California Air Resources Board, Stationary Source Division, Rule 
Evaluation Section, 1001 ``I'' Street, Sacramento, CA 95814; and,
Ventura County Air Pollution Control District, 669 County Square Drive, 
Ventura, CA 93003.

FOR FURTHER INFORMATION CONTACT: Jerald S. Wamsley, Rulemaking Office 
(AIR-4), U.S. Environmental Protection Agency, Region IX, (415) 744-
1226.

SUPPLEMENTARY INFORMATION: This proposal concerns the following VCAPCD 
rules: Rule 74.12--Surface Coating of Metal Parts & Products; Rule 
74.13--Aerospace Assembly & Component Manufacturing; Rule 74.18--Motor 
Vehicle and Mobile Equipment Coating; Rule 74.19--Graphic Arts; Rule 
74.24--Marine Coatings; and, Rule 74.30--Wood Products Coatings. In the 
Rules and Regulations section of this Federal Register, we are 
approving these local rules in a direct final action without prior 
proposal because we believe these SIP revisions are not controversial. 
However, if we receive adverse comments, we will publish a timely 
withdrawal of the direct final rule and address the comments in 
subsequent action based on this proposed rule. We do not plan to open a 
second comment period, so anyone interested in commenting should do so 
at this time. If we do not receive adverse comments, no further 
activity is planned. For further information, please see the direct 
final action.

    Dated: March 19, 2001.
Mike Schulz,
Acting Regional Administrator, Region IX.
[FR Doc. 01-9591 Filed 4-18-01; 8:45 am]
BILLING CODE 6560-50-U