[Federal Register Volume 66, Number 14 (Monday, January 22, 2001)]
[Proposed Rules]
[Pages 6497-6499]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 01-1664]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-263-AD]
RIN 2120-AA64


Airworthiness Directives; Construcciones Aeronauticas, S.A. 
(CASA), Model CN-235 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to all CASA Model CN-235 series 
airplanes. This proposal would require installing a second electrical 
connector in the electrical Master Central Unit. This action is 
necessary to prevent the loss of electrical power, other than that 
provided by the emergency system, in the event of disconnection of the 
single electrical connector within the electrical Master Central Unit. 
This action is intended to address the identified unsafe condition.

DATES: Comments must be received by February 21, 2001.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 2000-NM-263-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except 
Federal holidays. Comments may be submitted via fax to (425) 227-1232. 
Comments may also be sent via the Internet using the following address: 
[email protected]. Comments sent via fax or the Internet must 
contain ``Docket No. 2000-NM-263-AD'' in the subject line and need not 
be submitted in triplicate. Comments sent via the Internet as attached 
electronic files must be formatted in Microsoft Word 97 for Windows or 
ASCII text.
    The service information referenced in the proposed rule may be 
obtained from Construcciones Aeronauticas, S.A., Getafe, Madrid, Spain. 
This information may be examined at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington.

FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, ANM-
116, FAA, 1601 Lind Avenue, SW., Renton,

[[Page 6498]]

Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule. The proposals contained in this action may be changed in 
light of the comments received.
    Submit comments using the following format:
     Organize comments issue-by-issue. For example, discuss a 
request to change the compliance time and a request to change the 
service bulletin reference as two separate issues.
     For each issue, state what specific change to the proposed 
AD is being requested.
     Include justification (e.g., reasons or data) for each 
request.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this action must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 2000-NM-263-AD.'' The postcard will be date stamped 
and returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules 
Docket No. 2000-NM-263-AD, 1601 Lind Avenue, SW., Renton, Washington 
98055-4056.

Discussion

    The Direccion General de Aviacion Civil (DGAC), which is the 
airworthiness authority for Spain, notified the FAA that an unsafe 
condition may exist on all CASA Model CN-235 series airplanes. The DGAC 
advises that an incorrect assembly of the electrical connector of the 
Master Central Unit could lead to a disconnection of the connector. 
This condition, if not corrected, could result in the loss of 
electrical power, other than that provided by the emergency system, in 
the event of disconnection of the single electrical connector within 
the electrical Master Central Unit.

Explanation of Relevant Service Information

    CASA has issued Service Bulletin SB-235-24-14, dated June 27, 2000, 
which describes procedures for installing a second connector in the 
Master Central Unit. This second connector would allow the electrical 
connections to the generator and the battery on each side of the 
electrical Master Central Unit to be independent. The accomplishment of 
the actions specified in the service bulletin is intended to adequately 
address the identified unsafe condition. The DGAC classified this 
service bulletin as mandatory and issued Spanish airworthiness 
directive 06/00, dated June 27, 2000, in order to assure the continued 
airworthiness of these airplanes in Spain.

FAA's Conclusions

    These airplane models are manufactured in Spain and are type 
certificated for operation in the United States under the provisions of 
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and 
the applicable bilateral airworthiness agreement. Pursuant to this 
bilateral airworthiness agreement, the DGAC has kept the FAA informed 
of the situation described above. The FAA has examined the findings of 
the DGAC, reviewed all available information, and determined that AD 
action is necessary for products of this type design that are 
certificated for operation in the United States.

Explanation of Requirements of Proposed Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, the proposed AD would require accomplishment of 
the actions specified in the service bulletin described previously.

Cost Impact

    The FAA estimates that 1 airplane of U.S. registry would be 
affected by this proposed AD, that it would take approximately 8 work 
hours to accomplish the proposed installation, and that the average 
labor rate is $60 per work hour. Required parts would cost 
approximately $877. Based on these figures, the cost impact of the 
proposed AD on U.S. operators is estimated to be $1,357.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this proposed AD were not adopted. The cost impact 
figures discussed in AD rulemaking actions represent only the time 
necessary to perform the specific actions actually required by the AD. 
These figures typically do not include incidental costs, such as the 
time required to gain access and close up, planning time, or time 
necessitated by other administrative actions.

Regulatory Impact

    The regulations proposed herein would not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this proposal would not have federalism implications 
under Executive Order 13132.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.

[[Page 6499]]

Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

Construcciones Aeronauticas, S.A. (CASA): Docket 2000-NM-263-AD.

    Applicability: All Model CN-235 series airplanes, certificated 
in any category.

    Note 1:
    This AD applies to each airplane identified in the preceding 
applicability provision, regardless of whether it has been modified, 
altered, or repaired in the area subject to the requirements of this 
AD. For airplanes that have been modified, altered, or repaired so 
that the performance of the requirements of this AD is affected, the 
owner/operator must request approval for an alternative method of 
compliance in accordance with paragraph (b) of this AD. The request 
should include an assessment of the effect of the modification, 
alteration, or repair on the unsafe condition addressed by this AD; 
and, if the unsafe condition has not been eliminated, the request 
should include specific proposed actions to address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent the loss of electrical power, other than that 
provided by the emergency system, in the event of disconnection of 
the single electrical connector within the electrical Master Central 
Unit, accomplish the following:

Installation

    (a) Within 6 months after the effective date of this AD: Install 
a second electrical connector in the Master Central Unit, in 
accordance with CASA Service Bulletin SB-235-24-14, dated June 27, 
2000.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate, FAA. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2:
    Information concerning the existence of approved alternative 
methods of compliance with this AD, if any, may be obtained from the 
International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

    Note 3:
    The subject of this AD is addressed in Spanish airworthiness 
directive 06/00, dated June 27, 2000.


    Issued in Renton, Washington, on January 12, 2001.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-1664 Filed 1-19-01; 8:45 am]
BILLING CODE 4910-13-P