[Federal Register Volume 65, Number 73 (Friday, April 14, 2000)]
[Rules and Regulations]
[Pages 20320-20321]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-8810]



[[Page 20319]]

-----------------------------------------------------------------------

Part V





Department of Transportation





-----------------------------------------------------------------------



Federal Aviation Administration



-----------------------------------------------------------------------



14 CFR Part 39



Airworthiness Directives; McDonnell Douglas Model MD-11; AD 2000-07-14, 
et al.; Final Rules

  Federal Register / Vol. 65, No. 73 / Friday, April 14, 2000 / Rules 
and Regulations  

[[Page 20320]]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-NM-263-AD; Amendment 39-11668; AD 2000-07-14]
RIN 2120-AA64


Airworthiness Directives; McDonnell Douglas Model MD-11 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain McDonnell Douglas Model MD-11 series airplanes, 
that requires a one-time detailed visual inspection of a certain 
passenger seat wire assembly to detect chafed or damaged wires; repair, 
if necessary; and installation of protective sleeving. This amendment 
is prompted by a report of arcing emanating from a certain passenger 
seat wire assembly. The actions specified by this AD are intended to 
prevent chafing of the passenger seat wire assembly against a bracket 
at the lower sidewall panel due to insufficient clearance between the 
bracket and seat wire assembly, which could result in arcing damage to 
the passenger seat wire assembly and consequent smoke and fire in the 
main cabin.

DATES: Effective May 19, 2000.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of May 19, 2000.

ADDRESSES: The service information referenced in this AD may be 
obtained from Boeing Commercial Aircraft Group, Long Beach Division, 
3855 Lakewood Boulevard, Long Beach, California 90846, Attention: 
Technical Publications Business Administration, Dept. C1-L51 (2-60). 
This information may be examined at the Federal Aviation Administration 
(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, 
SW., Renton, Washington; or at the FAA, Transport Airplane Directorate, 
Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, 
Lakewood, California; or at the Office of the Federal Register, 800 
North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Brett Portwood, Aerospace Engineer, 
Systems and Equipment Branch, ANM-130L, FAA, Transport Airplane 
Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount 
Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5350; 
fax (562) 627-5210.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain McDonnell Douglas Model 
MD-11 series airplanes was published in the Federal Register on 
February 1, 2000 (65 FR 4781). That action proposed to require a one-
time detailed visual inspection of a certain passenger seat wire 
assembly to detect chafed or damaged wires; repair, if necessary; and 
installation of protective sleeving.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.

Conclusion

    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    There are approximately 128 airplanes of the affected design in the 
worldwide fleet. The FAA estimates that 32 airplanes of U.S. registry 
will be affected by this AD.
    It will take approximately 2 work hours per airplane to accomplish 
the required inspection, at an average labor rate of $60 per work hour. 
Based on these figures, the cost impact of the inspection required by 
this AD on U.S. operators is estimated to be $3,840, or $120 per 
airplane.
    It will take approximately 2 work hours per airplane to accomplish 
the required installation of protective sleeving, at an average labor 
rate of $60 per work hour. Based on these figures, the cost impact of 
the installation required by this AD on U.S. operators is estimated to 
be $3,840, or $120 per airplane.
    The cost impact figures discussed above are based on assumptions 
that no operator has yet accomplished any of the requirements of this 
AD action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2000-07-14 McDonnell Douglas: Amendment 39-11668. Docket 99-NM-263-
AD.

    Applicability: Model MD-11 series airplanes, as listed in 
McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 
9, 1999; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an

[[Page 20321]]

alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent chafing of the passenger seat wire assembly against a 
bracket at the lower sidewall panel due to insufficient clearance 
between the bracket and seat wire assembly, which could result in 
arcing damage to the passenger seat wire assembly and consequent 
smoke and fire in the main cabin, accomplish the following:

Inspection, Installation, and Repair, If Necessary

    (a) Within 6 months after the effective date of this AD, perform 
a detailed visual inspection of the passenger seat wire assembly to 
detect chafed or damaged wires, and install protective sleeving, in 
accordance with McDonnell Douglas Alert Service Bulletin MD11-
24A152, dated August 9, 1999. If any chafed or damaged wire is 
found, prior to further flight, repair in accordance with the 
service bulletin.

    Note 2: For the purposes of this AD, a detailed visual 
inspection is defined as: ``An intensive visual examination of a 
specific structural area, system, installation, or assembly to 
detect damage, failure, or irregularity. Available lighting is 
normally supplemented with a direct source of good lighting at 
intensity deemed appropriate by the inspector. Inspection aids such 
as mirror, magnifying lenses, etc., may be used. Surface cleaning 
and elaborate access procedures may be required.''

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO), FAA, Transport Airplane Directorate. Operators shall 
submit their requests through an appropriate FAA Principal 
Maintenance Inspector, who may add comments and then send it to the 
Manager, Los Angeles ACO.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 
21.197 and 21.199) to operate the airplane to a location where the 
requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with McDonnell 
Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999. 
This incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from Boeing Commercial Aircraft Group, 
Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 
90846, Attention: Technical Publications Business Administration, 
Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport 
Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or 
at the FAA, Transport Airplane Directorate, Los Angeles Aircraft 
Certification Office, 3960 Paramount Boulevard, Lakewood, 
California; or at the Office of the Federal Register 800 North 
Capitol Street, NW., suite 700, Washington, DC.
    (e) This amendment becomes effective on May 19, 2000.

    Issued in Renton, Washington, on April 4, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-8810 Filed 4-13-00; 8:45 am]
BILLING CODE 4910-13-P