[Federal Register Volume 65, Number 8 (Wednesday, January 12, 2000)]
[Rules and Regulations]
[Pages 1763-1765]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 00-500]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-NM-177-AD; Amendment 39-11505; AD 2000-01-08]
RIN 2120-AA64


Airworthiness Directives; British Aerospace BAe Model ATP 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all British Aerospace BAe Model ATP airplanes, that 
requires a one-time inspection of the orientation of certain bolts of 
the rudder standby control system (SCS), and reinstallation of the 
bolts, if necessary. This amendment is prompted by issuance of 
mandatory continuing airworthiness information by a foreign civil 
airworthiness authority. The actions specified by this AD are intended 
to prevent uncommanded engagement of the rudder SCS, which could result 
in reduced controllability of the airplane.

DATES: Effective February 16, 2000.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of February 16, 2000.

ADDRESSES: The service information referenced in this AD may be 
obtained from British Aerospace Regional Aircraft American Support, 
13850 Mclearen Road, Herndon, Virginia

[[Page 1764]]

20171. This information may be examined at the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, Rules Docket, 
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, Washington, 
DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all British Aerospace BAe Model 
ATP airplanes was published in the Federal Register on November 8, 1999 
(64 FR 60748). That action proposed to require a one-time inspection of 
the orientation of certain bolts of the rudder standby control system 
(SCS), and reinstallation of the bolts, if necessary.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 10 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 3 work hours per 
airplane to accomplish the required inspection, and that the average 
labor rate is $60 per work hour. Based on these figures, the cost 
impact of the AD on U.S. operators is estimated to be $1,800, or $180 
per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2000-01-08 British Aerospace Regional Aircraft [Formerly Jetstream 
Aircraft Limited; British Aerospace (Commercial Aircraft) Limited]: 
Amendment 39-11505. Docket 99-NM-177-AD.

    Applicability: All BAe Model ATP airplanes, certificated in any 
category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.
    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent uncommanded engagement of the rudder standby control 
system (SCS), accomplish the following:
    (a) Within one year after the effective date of this AD, perform 
a one-time general visual inspection of the orientation of the bolts 
in the rudder SCS, in accordance with British Aerospace Service 
Bulletin ATP-27-86, dated May 15, 1999. If any bolt is incorrectly 
installed, as specified by Figure 1 of the service bulletin, prior 
to further flight, remove and reinstall the bolt in accordance with 
the service bulletin.

    Note 2: For the purposes of this AD, a general visual inspection 
is defined as: ``A visual examination of an interior or exterior 
area, installation, or assembly to detect obvious damage, failure, 
or irregularity. This level of inspection is made under normally 
available lighting conditions such as daylight, hangar lighting, 
flashlight, or drop-light, and may require removal or opening of 
access panels or doors. Stands, ladders, or platforms may be 
required to gain proximity to the area being checked.''

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with British 
Aerospace Service Bulletin ATP-27-86, dated May 15, 1999. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from British Aerospace Regional Aircraft 
American Support, 13850 Mclearen Road, Herndon, Virginia 20171. 
Copies may be inspected at the FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

    Note 4: The subject of this AD is addressed in British 
airworthiness directive 005-05-99.

    (e) This amendment becomes effective on February 16, 2000.


[[Page 1765]]


    Issued in Renton, Washington, on January 4, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-500 Filed 1-11-00; 8:45 am]
BILLING CODE 4910-13-U