[Federal Register Volume 64, Number 32 (Thursday, February 18, 1999)]
[Proposed Rules]
[Pages 8026-8027]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 99-4015]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-308-AD]
RIN 2120-AA64


Airworthiness Directives; British Aerospace (Jetstream) Model 
4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to all British Aerospace (Jetstream) 
Model 4101 airplanes. This proposal would require modification of the 
pulley assemblies of the elevator and rudder control cables on the rear 
pressure bulkhead. This proposal is prompted by issuance of mandatory 
continuing airworthiness information by a foreign civil airworthiness 
authority. The actions specified by the proposed AD are intended to 
prevent failure of the pulley assemblies of the elevator and rudder 
control cables in the event of an elevator or rudder control cable jam, 
which could result in reduced controllability of the airplane.

DATES: Comments must be received by March 22, 1999.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 98-NM-308-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except 
Federal holidays.
    The service information referenced in the proposed rule may be 
obtained from AI(R) American Support, Inc., 13850 Mclearen Road, 
Herndon, Virginia 20171. This information may be examined at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule. The proposals contained in this notice may be changed in 
light of the comments received.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this notice must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 98-NM-308-AD.'' The postcard will be date stamped and 
returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules 
Docket No. 98-NM-308-AD, 1601 Lind Avenue, SW., Renton, Washington 
98055-4056.

Discussion

    The Civil Aviation Authority (CAA), which is the airworthiness 
authority for the United Kingdom, notified the FAA that an unsafe 
condition may exist on all British Aerospace (Jetstream) Model 4101 
airplanes. The CAA advises that the brackets on the rear pressure 
bulkhead that support the elevator and rudder control cable pulleys, in 
addition to the bolts and sleeves on which the pulleys rotate, have 
been determined to be of inadequate strength to support the pulleys. In 
the event of an elevator or rudder control cable jam, such inadequate 
strength of these parts, combined with input loads from each pilot, 
could result in failure of the pulley assemblies of the elevator and 
rudder control cables. This condition, if not corrected, could result 
in reduced controllability of the airplane.

Explanation of Relevant Service Information

    British Aerospace has issued Jetstream Service Bulletin J41-27-052, 
dated September 11, 1998, which describes procedures for modification 
of the pulley assemblies of the elevator and rudder control cables on 
the rear pressure bulkhead. The modification involves installing 
reinforcing plates on the brackets that support the lower elevator and 
rudder pulley assembly, and replacing the bolts and sleeves of the 
lower and upper elevator and rudder pulley assemblies with new bolts 
and sleeves. Accomplishment of the actions specified in the service 
bulletin is intended to adequately address the identified unsafe 
condition. The CAA classified this service bulletin as mandatory and 
issued British airworthiness directive 006-09-98 in order to assure the 
continued airworthiness of these airplanes in the United Kingdom.

FAA's Conclusions

    This airplane model is manufactured in the United Kingdom and is 
type certificated for operation in the United States under the 
provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 
21.29) and the applicable bilateral airworthiness agreement. Pursuant 
to this bilateral airworthiness agreement, the CAA has kept the FAA 
informed of the situation described above. The FAA has examined the 
findings of the CAA, reviewed all available information, and determined 
that AD action is necessary

[[Page 8027]]

for products of this type design that are certificated for operation in 
the United States.

Explanation of Requirements of Proposed Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, the proposed AD would require accomplishment of 
the actions specified in the service bulletin described previously.

Cost Impact

    The FAA estimates that 60 airplanes of U.S. registry would be 
affected by this proposed AD, that it would take approximately 60 work 
hours per airplane to accomplish the proposed actions, and that the 
average labor rate is $60 per work hour. Required parts would be 
supplied by the manufacturer at no cost to the operators. Based on 
these figures, the cost impact of the proposed AD on U.S. operators is 
estimated to be $216,000, or $3,600 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this AD were not adopted.

Regulatory Impact

    The regulations proposed herein would not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this 
proposal would not have sufficient federalism implications to warrant 
the preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

British Aerospace Regional Aircraft [Formerly Jetstream Aircraft 
Limited; British Aerospace (Commercial Aircraft) Limited]: Docket 
98-NM-308-AD.

    Applicability: All Jetstream Model 4101 airplanes, certificated 
in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the pulley assemblies of the elevator and 
rudder control cables in the event of an elevator or rudder control 
cable jam, which could result in reduced controllability of the 
airplane, accomplish the following:
    (a) Within 12 months after the effective date of this AD, modify 
the pulley assemblies of the elevator and rudder control cables on 
the rear pressure bulkhead, in accordance with Jetstream Service 
Bulletin J41-27-052, dated September 11, 1998.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

    Note 3: The subject of this AD is addressed in British 
airworthiness directive 006-09-98.

    Issued in Renton, Washington, on February 11, 1999.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 99-4015 Filed 2-17-99; 8:45 am]
BILLING CODE 4910-13-U