[Federal Register Volume 63, Number 243 (Friday, December 18, 1998)]
[Rules and Regulations]
[Pages 70002-70004]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-33392]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-NM-239-AD; Amendment 39-10951; AD 98-26-11]
RIN 2120-AA64
Airworthiness Directives; Saab Model SAAB 2000 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
[[Page 70003]]
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Saab Model SAAB 2000 series airplanes, that
requires replacement of the end-pieces of the expansion chamber
attenuator (ECA) for the standby pump of the Number 2 hydraulic system
with new, improved end-pieces. This amendment is prompted by issuance
of mandatory continuing airworthiness information by a foreign civil
airworthiness authority. The actions specified by this AD are intended
to prevent leakage of hydraulic fluid from the Number 2 hydraulic
system due to failure of the end-pieces of the ECA, which could result
in loss of nose wheel steering, flap operation, normal landing gear
operation, and reduced redundancy in the brake and flight controls
systems.
DATES: Effective January 22, 1999.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of January 22, 1999.
ADDRESSES: The service information referenced in this AD may be
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the
Federal Aviation Administration (FAA), Transport Airplane Directorate,
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the
Office of the Federal Register, 800 North Capitol Street, NW., suite
700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Saab Model SAAB 2000
series airplanes was published in the Federal Register on October 15,
1998 (63 FR 55346). That action proposed to require replacement of the
end-pieces of the expansion chamber attenuator (ECA) for the standby
pump of the Number 2 hydraulic system with new, improved end-pieces.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 3 airplanes of U.S. registry will be
affected by this AD, that it will take approximately 3 work hours per
airplane to accomplish the required replacement, and that the average
labor rate is $60 per work hour. Required parts will cost approximately
$820 per airplane. Based on these figures, the cost impact of the AD on
U.S. operators is estimated to be $3,000, or $1,000 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted.
Regulatory Impact
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does not have sufficient federalism implications to warrant the
preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
98-26-11 Saab Aircraft AB: Amendment 39-10951. Docket 98-NM-239-AD.
Applicability: Model SAAB 2000 series airplanes, serial numbers
-004 through -099 inclusive; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent leakage of hydraulic fluid from the Number 2
hydraulic system due to failure of the end-pieces of the expansion
chamber attenuator (ECA), which could result in loss of nose wheel
steering, flap operation, normal landing gear operation, and reduced
redundancy in the brake and flight controls systems, accomplish the
following:
(a) Within 4 months after the effective date of this AD, replace
the two end-pieces of the ECA of the standby pump for the Number 2
hydraulic system with new, improved end-pieces constructed of steel,
in accordance with Saab Service Bulletin 2000-29-016, dated April
17, 1998.
(b) As of the effective date of this AD, no person shall install
on any airplane any ECA having P/N 7329114-691.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
[[Page 70004]]
(e) The replacement shall be done in accordance with Saab
Service Bulletin 2000-29-016, dated April 17, 1998. This
incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft
Product Support, S-581.88, Linkoping, Sweden. Copies may be
inspected at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the Office of the Federal
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in Swedish
airworthiness directive (SAD) 1-126, dated April 20, 1998.
(f) This amendment becomes effective on January 22, 1999.
Issued in Renton, Washington, on December 11, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 98-33392 Filed 12-17-98; 8:45 am]
BILLING CODE 4910-13-U