[Federal Register Volume 63, Number 139 (Tuesday, July 21, 1998)]
[Notices]
[Pages 39069-39070]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-19399]


-----------------------------------------------------------------------

DEPARTMENT OF COMMERCE

Foreign--Trade Zones Board
[Order No. 993 ]


Grant of Authority for Subzone Status; Bollinger Shipyards, Inc. 
(Shipbuilding), Lockport, Louisiana

    Pursuant to its authority under the Foreign-Trade Zones Act of June 
18, 1934, as amended (19 U.S.C. 81a-81u), the Foreign-Trade Zones Board 
(the Board) adopts the following Order:
    Whereas, by an Act of Congress approved June 18, 1934, an Act ``To 
provide for the establishment * * * of foreign-trade zones in ports of 
entry of the United States, to expedite and encourage foreign commerce, 
and for other purposes,'' as amended (19 U.S.C. 81a-81u) (the FTZ Act), 
the Foreign-Trade Zones Board (the Board) is authorized to grant to 
qualified corporations the privilege of establishing foreign-trade 
zones in or adjacent to U.S. Customs ports of entry;
    Whereas, the Board's regulations (15 CFR Part 400) provide for the 
establishment of special-purpose subzones when existing zone facilities 
cannot serve the specific use involved;
    Whereas, an application from the South Louisiana Port Commission, 
grantee of FTZ 124, for authority to establish special-purpose subzone 
status for the shipbuilding facility of Bollinger Shipyards, Inc., in 
Lockport, Louisiana, was filed by the Board on August 11, 1997, and 
notice inviting public comment was given in the Federal Register (FTZ 
Docket 64-97, 62 FR 44642, 8/22/97); and,
    Whereas, the Board adopts the findings and recommendations of the 
examiner's report, and finds that the requirements of the FTZ Act and 
Board's regulations would be satisfied, and that approval of the 
application would be in the public interest if approval were given 
subject to the standard shipyard restriction on foreign steel mill 
products;
    Now, Therefore, the Board hereby grants authority for subzone 
status at the shipbuilding facility of Bollinger Shipyards, Inc., in 
Lockport, Louisiana (Subzone 124H), at the location described in the 
application, subject to the FTZ Act and the Board's regulations, 
including Sec. 400.28, and subject to the following special conditions:

[[Page 39070]]

    1. Any foreign steel mill products admitted to the subzone, 
including plate, angles, shapes, channels, rolled steel stock, bars, 
pipes and tubes, not incorporated into merchandise otherwise 
classified, and which is used in manufacturing, shall be subject to 
Customs duties in accordance with applicable law, unless the Executive 
Secretary determines that the same item is not then being produced by a 
domestic steel mill; and,
    2. In addition to the annual report, Bollinger Shipyards, Inc., 
shall advise the Board's Executive Secretary (Sec. 400.28(a)(3)) as to 
significant new contracts with appropriate information concerning 
foreign purchases otherwise dutiable, so that the Board may consider 
whether any foreign dutiable items are being imported for manufacturing 
in the subzone primarily because of subzone status and whether the 
Board should consider requiring Customs duties to be paid on such 
items.

    Signed at Washington, DC, this 10th day of July 1998.
Richard W. Moreland,
Acting Assistant Secretary of Commerce for Import Administration, 
Alternate Chairman, Foreign-Trade Zones Board.

Dennis Puccinelli,
Acting Executive Secretary.
[FR Doc. 98-19399 Filed 7-20-98; 8:45 am]
BILLING CODE 3510-DS-P