[Federal Register Volume 63, Number 98 (Thursday, May 21, 1998)]
[Rules and Regulations]
[Pages 27834-27835]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-13312]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 98-NM-40-AD; Amendment 39-10534; AD 98-11-07]
RIN 2120-AA64
Airworthiness Directives; Dornier Model 328-100 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Dornier Model 328-100 series airplanes, that
requires a one-time inspection of the double shuttle valve in the upper
fuselage fairing for incorrectly labeled part numbers, and corrective
actions, if necessary. This amendment is prompted by issuance of
mandatory continuing airworthiness information by a foreign civil
airworthiness authority. The actions specified by this AD are intended
to ensure replacement of the double shuttle valves when they have
reached their maximum life limit; incorrectly labeled part numbers of
the double shuttle valves that are not replaced could result in the
failure of the roll control spoilers, and, consequently, lead to
reduced controllability of the airplane.
DATES: Effective June 25, 1998.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of June 25, 1998.
ADDRESSES: The service information referenced in this AD may be
obtained from FAIRCHILD DORNIER, DORNIER Luftfahrt GmbH, P.O. Box 1103,
D-82230 Wessling, Germany. This information may be examined at the
Federal Aviation Administration (FAA), Transport Airplane Directorate,
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the
Office of the Federal Register, 800 North Capitol Street, NW., suite
700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Dornier Model 328-100
series airplanes was published in the Federal Register on March 20,
1998 (63 FR 13577). That action proposed to require a one-time
inspection of the double shuttle valve in the upper fuselage fairing
for incorrectly labeled part numbers, and corrective actions, if
necessary.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 50 airplanes of U.S. registry will be
affected by this AD. It will take approximately 1 work hour per
airplane to accomplish the required inspection at an average labor rate
of $60 per work hour. Based on this figure, the cost impact of the
inspection required by this AD on U.S. operators is estimated to be
$3,000, or $60 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted.
Regulatory Impact
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does
[[Page 27835]]
not have sufficient federalism implications to warrant the preparation
of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
98-11-07 Dornier Luftfahrt GmbH: Amendment 39-10534. Docket 98-NM-
40-AD.
Applicability: Model 328-100 series airplanes, serial numbers
3005 through 3086 inclusive; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To ensure replacement of the double shuttle valves when they
have reached their maximum life limit, accomplish the following:
(a) Within 30 days after the effective date of this AD, perform
a one-time visual inspection of the double shuttle valve in the
upper fuselage fairing to determine if the part number of the valve
is labeled correctly, in accordance with Dornier Service Bulletin
SB-328-27-236, Revision 1, dated November 5, 1997.
(b) If the inspection required by paragraph (a) of this AD
reveals that the installed double shuttle valve is labeled
incorrectly, prior to further flight, accomplish paragraphs (b)(1)
and (b)(2) of this AD, in accordance with Dornier Service Bulletin
SB-328-27-236, Revision 1, dated November 5, 1997.
(1) Revise the valve identification label to correctly identify
the part number of the double shuttle valve, and delete any
reference to operating pressure (i.e., BAR 205).
(2) Verify that the installed valve is within the limits
specified for that particular part number in accordance with the
service bulletin. If the installed double shuttle valve is outside
the limits, prior to further flight, replace the double shuttle
valve with a new part.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
(e) The actions shall be done in accordance with Dornier Service
Bulletin SB-328-27-236, Revision 1, dated November 5, 1997. This
incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from FAIRCHILD DORNIER, DORNIER Luftfahrt
GmbH, P.O. Box 1103, D-82230 Wessling, Germany. Copies may be
inspected at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the Office of the Federal
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in German
airworthiness directive 1997-321/2, dated January 15, 1998.
(f) This amendment becomes effective on June 25, 1998.
Issued in Renton, Washington, on May 13, 1998.
John J. Hickey,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 98-13312 Filed 5-20-98; 8:45 am]
BILLING CODE 4910-13-P