[Federal Register Volume 63, Number 54 (Friday, March 20, 1998)]
[Proposed Rules]
[Pages 13576-13577]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 98-7213]



[[Page 13576]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-26-AD]
RIN 2120-AA64


Airworthiness Directives; Airbus Model A320 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to certain Airbus Model A320 series 
airplanes. This proposal would require replacement of the existing 
mounting rack for the Digital Flight Data Recorder (DFDR) with a new 
rack having improved damping, and installation of a new bracket for re-
routing the wiring harness. This proposal is prompted by issuance of 
mandatory continuing airworthiness information by a foreign civil 
airworthiness authority. The actions specified by the proposed AD are 
intended to prevent the possible loss of data recorded on the DFDR as a 
result of vibrations and/or accelerations during flight.

DATES: Comments must be received by April 20, 1998.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 98-NM-26-AD, 1601 Lind Avenue, SW., Renton, 
Washington 98055-4056. Comments may be inspected at this location 
between 9:00 a.m. and 3:00 p.m., Monday through Friday, except Federal 
holidays.
    The service information referenced in the proposed rule may be 
obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 
Blagnac Cedex, France. This information may be examined at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule. The proposals contained in this notice may be changed in 
light of the comments received.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this notice must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 98-NM-26-AD.'' The postcard will be date stamped and 
returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules 
Docket No. 98-NM-26-AD, 1601 Lind Avenue, SW., Renton, Washington 
98055-4056.

Discussion

    The Direction Generale de l'Aviation Civile (DGAC), which is the 
airworthiness authority for France, notified the FAA that an unsafe 
condition may exist on certain Airbus Model A320 series airplanes. The 
DGAC advises that, when using the standard LORAL Ground Support 
Equipment (GSE) for data retrieval, the data may not be successfully 
retrieved by the GSE when the data has been recorded under dynamic 
conditions (such as vibrations or accelerations) that may occur during 
airplane operation. This condition, if not corrected, could result in 
the loss of data recorded on the Digital Flight Data Recorder (DFDR).

Explanation of Relevant Service Information

    Airbus has issued Service Bulletin A320-31-1088, Revision 2, dated 
September 16, 1996, which describes procedures for replacement of the 
existing mounting rack for the DFDR with a new rack having improved 
capability for damping of vibration; and installation of a new bracket 
for re-routing the wiring harness of the DFDR. Accomplishment of the 
actions specified in the service bulletin is intended to adequately 
address the identified unsafe condition. The DGAC classified this 
service bulletin as mandatory and issued French airworthiness directive 
96-272-098(B)R1, dated January 2, 1997, in order to assure the 
continued airworthiness of these airplanes in France.

FAA's Conclusions

    This airplane model is manufactured in France and is type 
certificated for operation in the United States under the provisions of 
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and 
the applicable bilateral airworthiness agreement. Pursuant to this 
bilateral airworthiness agreement, the DGAC has kept the FAA informed 
of the situation described above. The FAA has examined the findings of 
the DGAC, reviewed all available information, and determined that AD 
action is necessary for products of this type design that are 
certificated for operation in the United States.

Explanation of Requirements of Proposed Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, the proposed AD would require accomplishment of 
the actions specified in the service bulletin described previously.

Cost Impact

    The FAA estimates that 44 airplanes of U.S. registry would be 
affected by this proposed AD, that it would take approximately 3 work 
hours per airplane to accomplish the proposed actions, and that the 
average labor rate is $60 per work hour. Required parts would be 
furnished by the manufacturer at no cost to the operator. Based on 
these figures, the cost impact of the proposed AD on U.S. operators is 
estimated to be $7,920, or $180 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this AD were not adopted.

Regulatory Impact

    The regulations proposed herein would not have substantial direct 
effects

[[Page 13577]]

on the States, on the relationship between the national government and 
the States, or on the distribution of power and responsibilities among 
the various levels of government. Therefore, in accordance with 
Executive Order 12612, it is determined that this proposal would not 
have sufficient federalism implications to warrant the preparation of a 
Federalism Assessment.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

Airbus Industrie:  Docket 98-NM-26-AD.

    Applicability: Model A320 series airplanes; equipped with a 
LORAL Digital Flight Data Recorder (DFDR), and on which Airbus 
Modification 24959 (Airbus Service Bulletin A320-31-1088, Revision 
1, dated September 16, 1996) has not been accomplished; certificated 
in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (c) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent the possible loss of data recorded on the DFDR as a 
result of vibrations and/or accelerations during flight, accomplish 
the following:
    (a) Within 15 months after the effective date of this AD, remove 
the existing DFDR vibration mounting rack, install a new rack having 
improved damping, and install a new bracket for re-routing of the 
cable harness, in accordance with Airbus Service Bulletin A320-31-
1088, Revision 2, dated September 16, 1996.
    (b) As of the effective date of this AD, no person shall install 
a DFDR rack having part number 404-050L1DPX2-1 or V2E2433L07F, on 
any airplane.
    (c) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (d) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

    Note 3: The subject of this AD is addressed in French 
airworthiness directive 96-272-098(B)R1, dated January 2, 1997.

    Issued in Renton, Washington, on March 13, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-7213 Filed 3-19-98; 8:45 am]
BILLING CODE 4910-13-P