[Federal Register Volume 63, Number 1 (Friday, January 2, 1998)]
[Rules and Regulations]
[Page 4]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-34180]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 97-NM-271-AD; Amendment 39-10230; AD 97-25-06]
RIN 2120-AA64
Airworthiness Directives; Boeing Model 747 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule; correction.
-----------------------------------------------------------------------
SUMMARY: This document corrects information that appeared in
airworthiness directive (AD) 97-25-06, amendment 39-10230, that was
published in the Federal Register on December 1, 1997 (62 FR 63622).
The error resulted in an advertent omission in reference to acceptable
replacement components. This AD, applicable to certain Boeing Model 747
series airplanes, requires disconnection of the electrical connector to
the scavenge pump of the center wing tank. This AD also requires a one-
time inspection to identify the part number of the electrical
connector; and replacement of the pump with a new or serviceable pump,
if necessary.
DATES: Effective December 16, 1997.
The incorporation by reference of certain publications listed in
the regulations was previously approved by the Director of the Federal
Register as of December 16, 1997 (62 FR 63622, December 1, 1997).
FOR FURTHER INFORMATION CONTACT: Chris Hartonas, Aerospace Engineer,
Systems and Equipment Branch, ANM-130S; or G. Michael Collins,
Aerospace Engineer, Propulsion Branch, ANM-140S; FAA, Transport
Airplane Directorate, Seattle Aircraft Certification Office, 1601 Lind
Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2864 or
(425) 227-2689; fax (425) 227-1181.
SUPPLEMENTARY INFORMATION: On November 26, 1997, the FAA issued AD 97-
25-06, amendment 39-10230 (62 FR 63622, December 1, 1997). The AD
requires disconnection of the electrical connector to the scavenge pump
of the center wing tank; and a one-time inspection to identify the part
number of the electrical connector, and replacement of the pump with a
new pump, if necessary.
As published, that AD contained an inadvertent omission in
reference to acceptable replacement components. Throughout the preamble
and in paragraph (a)(2) of the AD, the FAA required that a replacement
scavenge pump be new. However, the FAA intended that a serviceable
scavenge pump also be specified as an acceptable replacement component.
In all other respects, the original document is correct.
Since no other part of the regulatory information has been changed,
the entire final rule is not being republished.
The effective date of the AD remains December 16, 1997.
Sec. 39.13 [Corrected]
On page 63623, in the second column, paragraph (a)(2) of AD 97-25-
06 is corrected to read as follows:
* * * * *
(2) If an electrical connector having a part number other than the
correct part number (as specified in the alert service bulletin) is
installed: Prior to further flight, replace the scavenge pump with a
new or serviceable scavenge pump with an electrical connector having
the correct part number (as specified in the alert service bulletin) in
accordance with the Accomplishment Instructions of the alert service
bulletin.
* * * * *
Issued in Renton, Washington, on December 24, 1997.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 97-34180 Filed 12-31-97; 8:45 am]
BILLING CODE 4910-13-P