[Federal Register Volume 62, Number 216 (Friday, November 7, 1997)]
[Proposed Rules]
[Pages 60193-60195]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-29420]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 97-NM-179-AD]
RIN 2120-AA64
Airworthiness Directives; Airbus Model A320 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: This document proposes the adoption of a new airworthiness
directive (AD) that is applicable to certain Airbus Model A320 series
airplanes. This proposal would require replacement of a capacitor of
the main landing gear (MLG) circuitry with a new electrolytic capacitor
having a tantalum casing. This proposal is prompted by the issuance of
mandatory continuing airworthiness information by a foreign civil
airworthiness authority. The actions specified by the proposed AD are
intended to prevent the failure of the landing gear to retract properly
as a result of failure of a capacitor in the MLG circuitry and
subsequent power interruption.
DATES: Comments must be received by December 8, 1997.
ADDRESSES: Submit comments in triplicate to the Federal Aviation
Administration (FAA), Transport Airplane Directorate, ANM-103,
Attention: Rules Docket No. 97-NM-179-AD, 1601 Lind Avenue, SW.,
Renton, Washington 98055-4056. Comments may be inspected at this
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except
Federal holidays.
The service information referenced in the proposed rule may be
obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707
Blagnac Cedex, France. This information may be examined at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington.
FOR FURTHER INFORMATION CONTACT: International Branch, ANM-116, FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the
proposed rule by submitting such written data, views, or arguments as
they may desire. Communications shall identify the Rules Docket number
and be submitted in triplicate to the address specified above. All
communications received on or before the closing date for comments,
specified above, will be considered before taking action on the
proposed rule.
The proposals contained in this notice may be changed in light of
the comments received.
Comments are specifically invited on the overall regulatory,
economic, environmental, and energy aspects of the proposed rule. All
comments submitted will be available, both before and after the closing
date for comments, in the Rules Docket for examination by interested
persons. A report summarizing each FAA-public contact
[[Page 60194]]
concerned with the substance of this proposal will be filed in the
Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments
submitted in response to this notice must submit a self-addressed,
stamped postcard on which the following statement is made: ``Comments
to Docket Number 97-NM-179-AD.'' The postcard will be date stamped and
returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request
to the FAA, Transport Airplane Directorate, ANM-103, Attention: Rules
Docket No. 97-NM-179-AD, 1601 Lind Avenue, SW., Renton, Washington
98055-4056.
Discussion
The Direction Generale de l'Aviation Civile (DGAC), which is the
airworthiness authority for France, notified the FAA that an unsafe
condition may exist on certain Airbus Model A320 series airplanes. The
DGAC advises that it has received reports that, during functional tests
of the landing gear safety valve, the main landing gear (MLG)
retraction cycle was interrupted. Investigation revealed that the
interruption was attributed to the rupture of a capacitor; this
capacitor normally enables the continuation of the gear retraction
cycle in the event of power interruption. Failure of this capacitor in
the MLG circuitry combined with electrical power interruption, if not
corrected, could result in failure of the MLG to retract properly.
Explanation of Relevant Service Information
Airbus has issued Service Bulletin A320-32-1139, Revision 1, dated
December 30, 1994, which describes procedures for replacement of a
capacitor of the MLG circuitry with a new electrolytic capacitor having
a tantalum casing. Replacement with the new capacitor would eliminate
the possibility and consequences of its rupture. The DGAC classified
this service bulletin as mandatory and issued French airworthiness
directive 96-187-085(B)R2, dated January 29, 1997, in order to assure
the continued airworthiness of these airplanes in France.
FAA's Conclusions
This airplane model is manufactured in France and is type
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, the DGAC has kept the FAA informed
of the situation described above. The FAA has examined the findings of
the DGAC, reviewed all available information, and determined that AD
action is necessary for products of this type design that are
certificated for operation in the United States.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to
exist or develop on other airplanes of the same type design registered
in the United States, the proposed AD would require accomplishment of
the actions specified in the service bulletin described previously.
Cost Impact
The FAA estimates that 31 Airbus Model A320 series airplanes of
U.S. registry would be affected by this proposed AD, that it would take
approximately 2 work hours per airplane to accomplish the proposed
actions, and that the average labor rate is $60 per work hour. The cost
for required parts would be minimal. Based on these figures, the cost
impact of the proposed AD on U.S. operators is estimated to be $3,720,
or $120 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the proposed requirements of
this AD action, and that no operator would accomplish those actions in
the future if this AD were not adopted.
Regulatory Impact
The regulations proposed herein would not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this
proposal would not have sufficient federalism implications to warrant
the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this proposed
regulation (1) is not a ``significant regulatory action'' under
Executive Order 12866; (2) is not a ``significant rule'' under the DOT
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
and (3) if promulgated, will not have a significant economic impact,
positive or negative, on a substantial number of small entities under
the criteria of the Regulatory Flexibility Act. A copy of the draft
regulatory evaluation prepared for this action is contained in the
Rules Docket. A copy of it may be obtained by contacting the Rules
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration proposes to amend
part 39 of the Federal Aviation Regulations (14 CFR part 39) as
follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
Airbus Industrie: Docket 97-NM-179-AD.
Applicability: Model A320 series airplanes on which Airbus
Modification 21574 (Airbus Service Bulletin A320-32-1139, Revision
1, dated December 30, 1994) or 21999 has not been installed,
certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (c) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent failure of the main landing gear (MLG) to retract
properly as a result of failure of a capacitor in the landing gear
circuitry and subsequent electrical power interruption, accomplish
the following:
(a) Within 8 months after the effective date of this AD, replace
capacitor 57GA installed in electronic rack 90VU with a new
electrolytic capacitor having a tantalum casing, in accordance with
Airbus Service Bulletin A320-32-1139, Revision 1, dated December 30,
1994.
(b) As of the effective date of this AD, no person shall install
a capacitor having part number 57GA (without a tantalum casing) in
the main landing gear circuitry on any airplane.
[[Page 60195]]
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116, FAA,
Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Note 3: The subject of this AD is addressed in French
airworthiness directive 96-187-085(B)R2, dated January 29, 1997.
Issued in Renton, Washington, on October 31, 1997.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 97-29420 Filed 11-6-97; 8:45 am]
BILLING CODE 4910-13-U