[Federal Register Volume 62, Number 80 (Friday, April 25, 1997)]
[Proposed Rules]
[Page 20147]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-10737]



[[Page 20147]]

=======================================================================
-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

[FRL-5817-7]

40 CFR Parts 64, 70, and 71


Compliance Assurance Monitoring

AGENCY: Environmental Protection Agency (EPA).

ACTION: Notice of Document Availability.

-----------------------------------------------------------------------

SUMMARY: On August 13, 1996, EPA published a notice of availability of 
a draft regulatory package on the Compliance Assurance Monitoring (CAM) 
rulemaking. In that notice, EPA stated that it would make regulatory 
impact analyses available for review and comment (61 FR 41991). On 
September 3, 1996, EPA published a correction notice stating that no 
regulatory impact analyses would be made public until the CAM rule is 
promulgated (61 FR 46418). EPA has reconsidered the release of 
regulatory impact analyses and decided to make public for comment its 
assessment of the impact of the CAM rule on small entities. Further, 
EPA has published the final revisions to parts 51, 52, 60, and 61 
entitled the credible evidence rulemaking (62 FR 8314, February 24, 
1997). The EPA has decided to accept comment on the relationship 
between the final credible evidence rule and the draft (August 2, 1996) 
CAM rule during the same comment period.

DATES: Comments must be submitted by May 27, 1997.

ADDRESSES: Comments: Written comments should be mailed to the docket ( 
address provided above) and to Mr. Peter Westlin, U.S. EPA, Office of 
Air Quality Planning and Standards, MD-19, Research Triangle Park, NC 
27711 (e-mail address: [email protected]). All comments 
should be marked to the attention of Docket No. A-91-52.
    Docket: Supporting information related to this impact analysis is 
contained in Docket No. A-91-52. This docket is available for public 
inspection and copying between 8:00 a.m. and 5:30 p.m. Monday through 
Friday, excluding government holidays, and is located at: EPA Air 
Docket (LE-131), Room M-1500, Waterside Mall, 401 M Street S.W., 
Washington, D.C. 20460. A reasonable fee may be charged for copying. 
Pursuant to section 307(d)(1)(V) of the Clean Air Act, this rulemaking 
is subject to the docketing and other procedural provisions of section 
307(d) of the Act.

Electronic Availability

    A copy of the draft impact analysis documents, as well as the draft 
CAM rule, will also be available via the Emission Measurement Technical 
Information Center Computer Bulletin Board of the EPA's Technology 
Transfer Network (TTN) at (919) 541-5742 or via the Internet at 
``www.epa.gov/oar/ttn__bbs.html'', 24 hours a day, 7 days a week 
(except Monday, 8-12 a.m. EST). A copy of the credible evidence 
rulemaking is available on the Clean Air Act Bulletin Board of the TTN 
under ``Recently Signed Rules''. Contact the system operator at (919) 
541-5384 if you have any questions concerning access to the Technology 
Transfer Network.

FOR FURTHER INFORMATION CONTACT: Peter Westlin, Office of Air Quality 
Planning and Standards, (919) 541-1058.

Supplementary Information: Comments: During the comment period, EPA 
will accept comments on the draft impact analysis and relationship to 
the applicability definitions in the draft CAM rule. EPA will also 
accept comments on the relationship between the draft CAM rule and the 
revisions implementing the credible evidence provisions. Comments on 
the latter issue should be limited to comments stemming from the 
specific language of the final credible evidence rule revisions or the 
preamble and should not include a recapitulation of comments already 
provided to EPA regarding CAM and the credible evidence revisions.

    Dated: April 14, 1997.
John S. Seitz,
Director, Office of Air Quality Planning and Standards.
[FR Doc. 97-10737 Filed 4-24-97; 8:45 am]
BILLING CODE 6560-50-P