[Federal Register Volume 62, Number 34 (Thursday, February 20, 1997)]
[Rules and Regulations]
[Pages 7684-7685]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-4121]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
40 CFR Part 261
[SW-FRL-5690-6]
Hazardous Waste Management System; Identification and Listing of
Hazardous Waste; Amendment
AGENCY: Environmental Protection Agency.
ACTION: Final rule; amendment.
-----------------------------------------------------------------------
SUMMARY: The Environmental Protection Agency (EPA or the Agency) is
amending 40 CFR part 261, appendix IX to reflect changes in ownership
and name for United Technologies Automotive, Inc., Jeffersonville,
Indiana. Today's amendment documents these changes.
EFFECTIVE DATE: February 20, 1997.
FOR FURTHER INFORMATION CONTACT: RCRA Hotline, toll free at (800) 424-
9346 or at (703) 412-9810. For technical information contact Ms. Judy
Kleiman, Waste Management Branch (DRP-8J), Waste, Pesticides and Toxics
Division, U.S. Environmental Protection Agency, 77 W. Jackson Blvd,
Chicago, IL 60604, (312) 886-1482.
SUPPLEMENTARY INFORMATION: In this document EPA is amending appendix IX
to part 261 to reflect changes in the ownership and name for United
Technologies Automotive. The petition process under Secs. 260.20 and
260.22 allows facilities to demonstrate that a specific waste from a
particular generating facility should not be regulated as a hazardous
waste. Based on waste specific information provided by the petitioner,
EPA granted an exclusion to United Technologies Automotive on April 29,
1986, for F019 wastes at its Jeffersonville, Indiana, facility (51 FR
15888). On November 20, 1995, Region 5 received notice that ownership
of the United Technologies Automotive facility in Jeffersonville,
Indiana, was transferred to Profile Extrusion Company. On November 14,
1996, Region 5 received notice that ownership of Profile Extrusion
Company was transferred to Alumnitec, Inc.
In this notification Alumnitec noted that no changes had been made
in the management of the F019 waste excluded by the Agency, and that
all conditions of the exclusion will continue to be met. Today's notice
documents this change by updating Appendix IX to incorporate this
change in name.
This change to 40 CFR Part 261, Appendix IX will be effective
February 20, 1997. The Hazardous and Solid Waste Amendments of 1984
amended section 3010 of RCRA to allow rules to become effective in less
than six months when the regulated community does not need the six-
month period to come into compliance. As described above, Alumnitec
will continue to meet all conditions of United Technologies
Automotive's exclusion. Therefore, a six-month delay in the effective
date is not necessary in this case. This provides a basis for making
this amendment effective immediately upon publication under the
Administrative Procedures Act, pursuant to 5 U.S.C. 5531(d).
List of Subjects in 40 CFR Part 261
Environmental protection, Hazardous waste, Recycling, Reporting and
recordkeeping requirements.
Dated: January 21, 1997.
Jo Lynn Traub,
Acting Regional Administrator, Region 5.
For the reasons set out in the preamble, 40 CFR part 261 is to be
amended as follows:
PART 261--IDENTIFICATION AND LISTING OF HAZARDOUS WASTE
1. The authority citation for part 261 continues to read as
follows:
Authority: 42 U.S.C. 6905, 6912(a), 6921, 6922, 6924(y) and
6938.
2. 40 CFR Part 261, Appendix IX, Table 1, is amended by removing
the entry for ``United Technologies Automotive, Inc.'' and by adding in
alphabetical order the entry for ``Alumnitec, Inc.'' to read as
follows:
Appendix IX to Part 261--Wastes Excluded Under Secs. 260.20 and
260.22
Table 1.--Wastes Excluded From Non-Specific Sources
------------------------------------------------------------------------
Facility Address Waste description
------------------------------------------------------------------------
* * * *
* * *
Alumnitec, Inc. (formerly Jeffersonville, Dewatered wastewater
Profile Extrusion Co., IN. treatment sludge
formerly United Technologies (EPA Hazardous Waste
Automotive, Inc.). No. F019) generated
from the chemical
conversion of
aluminum after April
29, 1986.
* * * *
* * *
------------------------------------------------------------------------
[[Page 7685]]
[FR Doc. 97-4121 Filed 2-19-97; 8:45 am]
BILLING CODE 6560-50-P