[Federal Register Volume 62, Number 8 (Monday, January 13, 1997)]
[Rules and Regulations]
[Pages 1681-1682]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 97-413]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
40 CFR Part 435
[FRL-5673-8]
RIN 2040-AB72
Final Effluent Limitations Guidelines and Standards for the
Coastal Subcategory of the Oil and Gas Extraction Point Source
Category; Correction
AGENCY: Environmental Protection Agency (EPA).
ACTION: Final rule; correction.
-----------------------------------------------------------------------
SUMMARY: EPA is correcting minor errors in the preamble and effluent
limitations guidelines and standards for the coastal subcategory of the
oil and gas extraction point source category, which appeared in the
Federal Register on December 16, 1996 (61 FR 66086).
EFFECTIVE DATE: these corrections shall become effective January 15,
1997, except for Sec. 435.45 (NSPS), which becomes effective January
13, 1997.
FOR FURTHER INFORMATION CONTACT: Charles E. White, Office of Water,
Engineering and Analysis Division (4303), U.S. Environmental Protection
Agency, 401 M Street, SW, Washington, DC, 20460, (202) 260-5411,
[email protected].
SUPPLEMENTARY INFORMATION: In a final rule published December 16, 1996
(61 FR 66086), EPA established final effluent limitations guidelines
and standards for the control of wastewater pollutants. The final rule
contained some minor errors that are discussed briefly below and are
corrected by this document. The effective dates and date of issuance
for purposes of judicial review are stated in the December 16, 1996
final rule.
Under Executive Order 12866 (58 FR 51735, October 4, 1993), this
action is not a ``significant regulatory action'' and, is therefore not
subject to review by the Office of Management and Budget. In addition,
this action does not impose any enforceable duty or contain any
unfunded mandate as described in the Unfunded Mandates Reform Act of
1995 (Pub. L. 104-4), or require prior consultation with State
officials as specified by Executive Order 12875 (58 FR 58093, October
28, 1993), or involve special consideration of environmental justice
related issuess as required by Executive Order 12898 (59 FR 7629,
February 16, 1994).
Because this action is not subject to notice-and-comment
requirements under the Administrative Procedure Act or any other
statute, it is not subject to the provisions of the Regulatory
Flexibility Act (5 U.S.C. 601 et seq.).
Under 5 U.S.C. 801(a)(1)(A) as added by the Small Business
Regulatory Enforcement Fairness Act of 1996, EPA submitted a report
containing this rule and other required information to the U.S. Senate,
the U.S. House of Representatives and the Comptroller General of the
General Accounting Office prior to publication of this rule in today's
Federal Register. This rule is not a ``major rule'' as defined by 5
U.S.C. 804(2).
List of Subjects in 40 CFR Part 435
Environmental protection, Incorporation by reference, Oil and gas
extraction, Pollution prevention, Waste treatment and disposal, Water
pollution control.
Dated: December 27, 1996.
Robert Perciasepe,
Assistant Administrator for Water.
The following corrections are made in FRL-5648-4, Final Effluent
Limitations Guidelines and Standards for the Coastal Subcategory of the
Oil and Gas Extraction Point Source Category, which was published in
the Federal Register on December 16, 1996 (61 FR 66086).
1. On page 66111, columns two, line 24, the reference to ``Table 10
is corrected to read ``Table 11''.
2. and 3. On page 66111, column two and three, the second Table 10
is correctly designated as Table 11.
4. On page 66111, column three, line 4 of Paragraph B, the
reference to ``Table 11'' is corrected to read ``Table 12''.
5. On page 66112, column one, the Table 11 is correctly designated
as Table 12.
6. On page 66113, the Table is correctly designated as Table 13.
7. On page 66113, column three, line 13, the reference to ``Table
12'' is corrected to read ``Table 13''.
Sec. 435.41 [Amended]
8. Sec. 435.41 on page 66127, column one, line 24, the second
paragraph (y) is correctly designated (z).
9. Sec. 435.41 on page 66127, paragraph (z) is correctly designated
(aa).
10. Sec. 435.41 on page 66127, paragraph (aa) is correctly
designated (bb).
11. Sec. 435.41 on page 66127, paragraph (bb) is correctly
designated (cc).
12. Sec. 435.41 on page 66127, paragraph (cc) is correctly
designated (dd).
13. Sec. 435.41 on page 66127, paragraph (dd) is correctly
designated (ee).
14. Sec. 435.41 on page 66127, paragraph (ee) is correctly
designated (ff).
15. and 16. On page 66128, Sec. 435.43 includes a table of BAT
effluent limitations. The table is corrected to read as follows:
Sec. 435.43 Effluent limitations guidelines representing the degree
of effluent reduction attainable by the application of the best
available technology economically achievable (BAT).
* * * * *
BAT Effluent Limitations
----------------------------------------------------------------------------------------------------------------
Stream Pollutant parameter BAT effluent limitations
----------------------------------------------------------------------------------------------------------------
Produced Water:
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Oil & Grease......................... The maximum for any one day
shall not exceed 42 mg/l, and
the 30-day average shall not
exceed 29 mg/l.
Drilling Fluids, Drill Cuttings, and
Dewatering Effluent: \1\
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Free Oil \2\......................... No discharge.
Diesel Oil........................... No discharge.
Mercury.............................. 1 mg/kg dry weight maximum in
the stock barite.
Cadmium.............................. 3 mg/kg dry weight maximum in
the stock barite.
Toxicity............................. Minimum 96-hour LC50 of the SPP
shall be 3 percent by
volume.\4\
Well Treatment, Workover and Completion
Fluids:
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Oil & Grease......................... The maximum for any one day
shall not exceed 42 mg/l, and
the 30-day average shall not
exceed 29 mg/l.
[[Page 1682]]
Produced Sand........................... ..................................... No discharge.
Deck Drainage........................... Free Oil \3\......................... No discharge.
Domestic Waste.......................... Foam................................. No discharge.
----------------------------------------------------------------------------------------------------------------
\1\ BAT limitations for dewatering effluent are applicable prospectively, BAT limitations in this rule are not
applicable to discharges of dewatering effluent from reserve pits which as of the effective date of this rule
no longer receive drilling fluids and drill cuttings. Limitations on such discharges shall be determined by
the NPDES permit issuing authority.
\2\ As determined by the static sheen test (see appendix 1 to 40 CFR Part 435, subpart A).
\3\ As determined by the presence of a film or sheen upon or a discoloration of the surface of the receiving
water (visual sheen).
\4\ As determined by the toxicity test (see appendix 2 of 40 CFR Part 435, subpart A).
Sec. 435.44 [Amended]
17. On page 66128, Sec. 435.44 includes a table of BCT effluent
limitations. Footnote 4 on that table should be removed.
18., 19., 20., 21., 22., 23., 24. and 25. On page 66129,
Sec. 435.45 includes a table of NSPS effluent limitations. The table is
corrected to read as follows:
Sec. 435.45 Standards of performance for new sources (NSPS).
* * * * *
NSPS Effluent Limitations
----------------------------------------------------------------------------------------------------------------
Stream Pollutant parameter NSPS effluent limitations
----------------------------------------------------------------------------------------------------------------
Produced Water:
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Oil & Grease......................... The maximum for any one day
shall not exceed 42 mg/l, and
the 30-day average shall not
exceed 29 mg/l.
Drilling Fluids, Drill Cuttings, and
Dewatering Effluent: \1\
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Free Oil \2\......................... No discharge.
Diesel Oil........................... No discharge.
Mercury.............................. 1 mg/kg dry weight maximum in
the stock barite.
Cadmium.............................. 3 mg/kg dry weight maximum in
the stock barite.
Toxicity............................. Minimum 96-hour LC50 of the SPP
shall be 3 percent by
volume.\4\
Well Treatment, Workover and Completion
Fluids:
(A) All coastal areas except Cook ..................................... No discharge.
Inlet.
(B) Cook Inlet...................... Oil & Grease......................... The maximum for any one day
shall not exceed 42 mg/l, and
the 30-day average shall not
exceed 29 mg/l.
Produced Sand........................... ..................................... No discharge.
Deck Drainage........................... Free Oil \3\......................... No discharge.
Sanitary Waste
Sanitary M10........................ Residual Chlorine.................... Minimum of 1 mg/l and
maintained as close to this
concentration as possible.
Sanitary M9IM....................... Floating Solids...................... No discharge.
Domestic Waste.......................... Floating Solids, Garbage and Foam.... No discharge of floating solids
or garbage or foam.
----------------------------------------------------------------------------------------------------------------
\1\ NSPS limitations for dewatering effluent are applicable prospectively. NSPS limitations in this rule are not
applicable to discharges of dewatering effluent from reserve pits which as of the effective date of this rule
no longer receive drilling fluids and drill cuttings. Limitations on such discharges shall be determined by
the NPDES permit issuing authority.
\2\ As determined by the static sheen test (see appendix 1 to 40 CFR Part 435, subpart A).
\3\ As determined by the presence of a film or sheen upon or a discoloration of the surface of the receiving
water (visual sheen).
\4\ As determined by the toxicity test (see appendix 2 of 40 CFR Part 435, subpart A).
Sec. 435.10 [Corrected]
26. On page 66129, the section under subpart G currently reads
Sec. 435.10. The section number is corrected to read ``Sec. 435.70''.
[FR Doc. 97-413 Filed 1-10-97; 8:45 am]
BILLING CODE 6560-50-P