[Federal Register Volume 61, Number 92 (Friday, May 10, 1996)]
[Notices]
[Pages 21530-21531]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-11785]



-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION
[Docket No. 96-045; Notice 1]


Notice of Receipt of Petition for Decision That Nonconforming 
1992 Jeep Cherokee Multi-Purpose Passenger Vehicles Are Eligible for 
Importation

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Notice of receipt of petition for decision that nonconforming 
1992 Jeep Cherokee multipurpose passenger vehicles (MPVs) manufactured 
for the Venezuelan market are eligible for importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces receipt by the National Highway Traffic 
Safety Administration (NHTSA) of a petition for a decision that a 1992 
Jeep Cherokee that was manufactured for the Venezuelan market and not 
originally manufactured to comply with all applicable Federal motor 
vehicle safety standards is eligible for importation into the United 
States because (1) it is substantially similar to a vehicle that was 
originally manufactured for sale in the United States and that was 
certified by its manufacturer as complying with the safety standards, 
and (2) it is capable of being readily altered to conform to the 
standards.

DATES: The closing date for comments on the petition is June 10, 1996.

ADDRESSES: Comments should refer to the docket number and notice 
number, and be submitted to: Docket Section, Room 5109, National 
Highway Traffic Safety Administration, 400 Seventh St., SW, Washington, 
DC 20590. [Docket hours are from 9:30 am to 4 pm]

FOR FURTHER INFORMATION CONTACT: George Entwistle, Office of Vehicle 
Safety Compliance, NHTSA (202-366-5306).

SUPPLEMENTARY INFORMATION:

Background

    Under 49 U.S.C. Sec. 30141(a)(1)(A) (formerly section 
108(c)(3)(A)(i)(I) of the National Traffic and Motor Vehicle Safety Act 
(the Act)), a motor vehicle that was not originally manufactured to 
conform to all applicable Federal motor vehicle safety standards shall 
be refused admission into the United States unless NHTSA has decided 
that the motor vehicle is substantially similar to a motor vehicle 
originally manufactured for importation into and sale in the United 
States, certified under 49 U.S.C. Sec. 30115 (formerly section 114 of 
the Act), and of the same model year as the model of the motor vehicle 
to be compared, and is capable of being readily altered to conform to 
all applicable Federal motor vehicle safety standards.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR Part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    Champagne Imports, Inc. of Lansdale, Pennsylvania (``Champagne'') 
(Registered Importer 90-009) has petitioned NHTSA to decide whether 
1992 Jeep Cherokee MPVs manufactured for the Venezuelan market are 
eligible for importation into the United States. The vehicle which 
Champagne believes is substantially similar is the 1992 Jeep Cherokee 
that was manufactured for sale in the United States and certified by 
its manufacturer as conforming to all applicable Federal motor vehicle 
safety standards.
    The petitioner claims that it carefully compared the non-U.S. 
certified 1992 Jeep Cherokee to its U.S. certified counterpart, and 
found the two vehicles to be substantially similar with respect to 
compliance with most Federal motor vehicle safety standards.
    Champagne submitted information with its petition intended to 
demonstrate that the non-U.S. certified 1992 Jeep Cherokee, as 
originally manufactured, conforms to many Federal motor vehicle safety 
standards in the same manner as its U.S. certified counterpart, or is 
capable of being readily altered to conform to those standards.
    Specifically, the petitioner claims that the non-U.S. certified 
1992 Jeep Cherokee is identical to its U.S. certified counterpart with 
respect to compliance with Standards Nos. 102 Transmission Shift Lever 
Sequence * * * ., 103 Defrosting and Defogging Systems, 104 Windshield 
Wiping and Washing

[[Page 21531]]

Systems, 105 Hydraulic Brake Systems, 106 Brake Hoses, 107 Reflecting 
Surfaces, 109 New Pneumatic Tires, 113 Hood Latch Systems, 116 Brake 
Fluid, 124 Accelerator Control Systems, 201 Occupant Protection in 
Interior Impact, 202 Head Restraints, 203 Impact Protection for the 
Driver From the Steering Control System, 204 Steering Control Rearward 
Displacement, 205 Glazing Materials, 206 Door Locks and Door Retention 
Components, 207 Seating Systems, 209 Seat Belt Assemblies, 210 Seat 
Belt Assembly Anchorages, 211 Wheel Nuts, Wheel Discs and Hubcaps, 212 
Windshield Retention, 216 Roof Crush Resistance, 219 Windshield Zone 
Intrusion, and 302 Flammability of Interior Materials.
    Additionally, the petitioner states that the non-U.S. certified 
1992 Jeep Cherokee complies with the Bumper Standard found in 49 CFR 
Part 581.
    Petitioner also contends that the vehicle is capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: (a) substitution of a lens 
marked ``Brake'' for a lens with a noncomplying symbol on the brake 
failure indicator lamp; (b) installation of a seat belt warning lamp; 
(c) recalibration of the speedometer/odometer from kilometers to miles 
per hour.
    Standard No. 108 Lamps, Reflective Devices and Associated 
Equipment: (a) installation of U.S.-model headlamp assemblies; (b) 
installation of U.S.-model front and rear sidemarker/reflector 
assemblies; (c) installation of U.S.-model taillamp assemblies.
    Standard No. 110 Tire Selection and Rims: installation of a tire 
information placard.
    Standard No. 111 Rearview Mirror: replacement of the convex 
passenger side rearview mirror.
    Standard No. 114 Theft Protection: installation of a warning buzzer 
microswitch and a warning buzzer in the steering lock assembly.
    Standard No. 115 Vehicle Identification Number: installation of a 
VIN plate that can be read from outside the left windshield pillar, and 
a VIN reference label on the edge of the door or latch post nearest the 
driver.
    Standard No. 118 Power Window Systems: rewiring of the power window 
system so that the window transport is inoperative when the ignition is 
switched off.
    Standard No. 208 Occupant Crash Protection: (a) installation of a 
U.S.- model seat belt in the driver's position, or a belt webbing 
actuated microswitch inside the driver's seat belt retractor; (b) 
installation of an ignition switch actuated seat belt warning lamp and 
buzzer. The petitioner states that the vehicle is equipped with a lap 
and shoulder restraint that adjusts by means of an automatic retractor 
and releases by means of a single push button at each front designated 
seating position, and with a lap and shoulder restraint that releases 
by means of a single push button at each rear outboard seating 
positions.
    Standard No. 301 Fuel System Integrity: installation of a rollover 
valve in the fuel tank vent line between the fuel tank and the 
evaporative emissions collection canister.
    Interested persons are invited to submit comments on the petition 
described above. Comments should refer to the docket number and be 
submitted to: Docket Section, National Highway Traffic Safety 
Administration, Room 5109, 400 Seventh Street, S.W., Washington, DC 
20590. It is requested but not required that 10 copies be submitted.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above address both before and after 
that date. To the extent possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8.

    Issued on: May 7, 1996.
Marilynne Jacobs,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 96-11785 Filed 5-9-96; 8:45 am]
BILLING CODE 4910-59-P