[Federal Register Volume 61, Number 29 (Monday, February 12, 1996)]
[Proposed Rules]
[Pages 5358-5359]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 96-2970]



-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY
40 CFR Part 52
[CA 33-3-7130b; FRL-5339-8]


Approval and Promulgation of State Implementation Plans; 
California State Implementation Plan Revision, Santa Barbara County, 
Ventura County, Monterey Bay Unified, and Placer County Air Pollution 
Control District; and Yolo Solano Air Quality Management District
AGENCY: Environmental Protection Agency (EPA).

ACTION: Proposed rule.

-----------------------------------------------------------------------

SUMMARY: EPA is proposing to approve revisions to the California State 
Implementation Plan (SIP) which concern the control of volatile organic 
compound (VOC) emissions from the following: the coating or assembly of 


[[Page 5359]]

aircraft or aerospace vehicle parts and products, the use of organic 
solvents and organic solvent cleaners, the coating of miscellaneous 
metal parts and products, the application of adhesives, and the coating 
of flat wood paneling.
    The intended effect of proposing approval of these rules is to 
regulate emissions of VOCs in accordance with the requirements of the 
Clean Air Act, as amended in 1990 (CAA or the Act). In the Final Rules 
Section of this Federal Register, the EPA is approving the state's SIP 
revision as a direct final rule without prior proposal because the 
Agency views this as a noncontroversial revision amendment and 
anticipates no adverse comments. A detailed rationale for this approval 
is set forth in the direct final rule. If no adverse comments are 
received in response to this proposed rule, no further activity is 
contemplated in relation to this rule. If EPA receives adverse 
comments, the direct final rule will be withdrawn and all public 
comments received will be addressed in a subsequent final rule based on 
this proposed rule. The EPA will not institute a second comment period 
on this document. Any parties interested in commenting on this action 
should do so at this time.

DATES: Comments on this proposed rule must be received in writing by 
March 13, 1996.

ADDRESSES: Written comments on this action should be addressed to: 
Daniel A. Meer, Rulemaking Section (A-5-3), Air and Toxics Division, 
U.S. Environmental Protection Agency, Region 9, 75 Hawthorne Street, 
San Francisco, CA 94105-3901.
    Copies of the rule revisions and EPA's evaluation report of each 
rule are available for public inspection at EPA's Region 9 office 
during normal business hours. Copies of the submitted rule revisions 
are also available for inspection at the following locations:

Rulemaking Section (A-5-3), Air and Toxics Division, U.S. 
Environmental Protection Agency, Region IX, 75 Hawthorne Street, San 
Francisco, CA 94105.
Environmental Protection Agency, Air Docket (6102), 401 ``M'' 
Street, S.W., Washington, D.C. 20460.
California Air Resources Board, Stationary Source Division, Rule 
Evaluation Section, 2020 ``L'' Street, Sacramento, CA 92123-1095.
Placer County Air Pollution Control District, 11464 B Avenue, 
Auburn, CA 95603.
Monterey Bay Unified Air Pollution Control District, 24580 Silver 
Cloud Court, Monterey, CA 93940.
Santa Barbara County Air Pollution Control District, 26 Castilian 
Drive B-23, Goleta, CA 93117.
Ventura County Air Pollution Control District, 669 County Square 
Drive, Ventura, CA 93003.
Yolo-Solano Air Quality Management District, 1947 Galileo Court, 
Suite 103, Davis, CA 95616.

FOR FURTHER INFORMATION CONTACT: Helen Liu, Air and Toxics Division, 
Rulemaking (A-5-3), U.S. Environmental Protection Agency, Region IX, 75 
Hawthorne Street, San Francisco, CA 94105-3901, Telephone: (415) 744-
1199.

SUPPLEMENTARY INFORMATION: This document concerns SBCAPCD Rule 337--
Surface Coating of Aircraft or Aerospace Vehicle Parts and Products, 
VCAPCD Rule 74.13--Aerospace Assembly and Component Manufacturing 
Operations, MBUAPCD Rule 416--Organic Solvents, MBUAPCD Rule 433--
Organic Solvent Cleaning, MBUAPCD Rule 434--Coating of Metal Parts and 
Products, YSAQMD Rule 2.25--Metal Parts and Products Coating 
Operations, YSAQMD Rule 2.33--Adhesives Operations, PCAPCD Rule 238--
Factory Coating of Flat Wood Paneling, submitted to EPA on January 24, 
1995, April 5, 1991, July 13, 1994, September 28, 1994, September 28, 
1994, November 30, 1994, November 30, 1994, and October 13, 1995, 
respectively, by the California Air Resources Board. For further 
information, please see the information provided in the Direct Final 
action which is located in the Rules Section of this Federal Register.

    Authority: 42 U.S.C. 7401-7671q.

    Dated: November 8, 1995.
Felicia Marcus,
Regional Administrator.
[FR Doc. 96-2970 Filed 2-9-96; 8:45 am]
BILLING CODE 6560-50-P