[Federal Register Volume 60, Number 134 (Thursday, July 13, 1995)]
[Notices]
[Page 36110]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-17180]



-----------------------------------------------------------------------


DEPARTMENT OF DEFENSE

MTMC's Requirements Document Concerning the Department of Defense 
(DOD) Personal Property Program

AGENCY: Military Traffic Management Command (MTMC), DOD.

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: MTMC is engaged in re-engineering the existing DOD Personal 
Property Program in an effort to simplify the process, control program 
costs, and ensure quality of service. The re-engineering effort will 
adopt, to the fullest extent possible, proven commercial business 
practices and relieve carriers of DOD unique terms and conditions. The 
objective of this re-engineering effort is to enhance the quality of 
life for our service members and their families. As a result of this on 
going effort, MTMC has published a draft requirements document that 
provides details to industry concerning the anticipated requirements to 
participate in the movement of personal property for DOD. The initial 
draft of the requirements documents is provided with the intent to give 
industry the opportunity to comment on the feasibility of the proposal. 
MTMC requests that industry provide their input, suggestions, and 
constructive criticism concerning the draft requirement document. 
Additionally, MTMC intends to hold regional meetings with any 
interested carriers in August 1995 at various locations throughout the 
United States. More information on dates and places will be 
forthcoming.

DATES: Comments must be received by 20 September 1995.

ADDRESSES: Mail comments to Headquarters, Military Traffic Management 
Command, ATTN: MTOP-Q, 5611 Columbia Pike, Falls Church, VA 22041-5050.

FOR FURTHER INFORMATION CONTACT:
Joe DeLucia, MTOP-QE, (703) 681-6753.

SUPPLEMENTARY INFORMATION: The draft of the requirements document can 
be obtained by accessing MTMC's re-engineering update from the EasyLink 
Bulletin Board. To subscribe to AT&T EasyLink services carriers may 
contact AT&T EasyLink representative Lynn Phelps at 1-800-346-1557. 
Procedures to access the bulletin board system are as follows:

MTMC BBS Access

    To access the MTMC BBS a communication software is required. The 
software could be EasyLink's Office Access, Procomm Plus, or some other 
type of off the shelf communication software. Also required is an 
account on the EasyLink network.

Office Access Software

     At the Main Menu type C for the On-line Communication 
Menu
     At the On-line Communication Menu type F for FYI. The 
software will dial the network and exit into FYI.
     The network will ask for CATEGORY NAME, type MTMC. This 
will place you in the MTMC BBS.
     To maneuver within the BBS to ADCSOPS for Quality.
    a. From the main menu TYPE 2 for the ADCSOPS for Quality.
    b. TYPE 1 for the Re-Engineered Personal Property Program.
    c. TYPE 1 for Contacts.
    d. TYPE 2 for Information.
    As information scrolls across the screen, the information is 
automatically downloaded to the hard drive on your computer.
     Press END key to disconnect from EasyLink.
     Press ESC key and return to the Main Menu.
     Type I to access the Inbound Journal.
     High light the message and Press ENTER to view the BBS 
categories that were scanned.

Procomm Plus Software

     At the Dialing Directory press R to Revise Entry. Type 
in the entry name.
     The remaining setup entries are as follows:
     Number=1-800-325-4112 or 1-800-445-7523
     BAUD=2400
     PARITY=Even
     DATA BITS=7
     STOP BITS=1
     DUPLEX=HALF
     SCRIPT=BLANK
     PROTOCOL=ASCII
     TERMINAL=ANSI
     Press ENTER to dial the network.
     At the EASYLINK ID prompt type your USERID AND PASSWORD
     At the PTS prompt type EXIT. This will exit the 
EasyLink network and provide an EasyLink Service Menu.
     Press 2 to select FYI.
     Hold down the ALT key and press F1 and type a log name. 
This will open the log and allow the capture of the BBS data as it 
is scanned.
     The network will ask for CATEGORY NAME, type MTMC. This 
will place you in the MTMC BBS.
     To maneuver within the BBS to ADCSOPS for Quality.
    a. From the main menu TYPE 2 for the ADCSOPS for Quality.
    b. TYPE 1 for the Re-Engineered Personal Property Program
    c. TYPE 1 for Contacts.
    d. TYPE 2 for Information.
     The software will automatically capture the categories 
that are typed. After the category scan is completed, press ALT and 
the H keys to logoff.
     Hold down the ALT key and press F1 to close the log.
     Hold down the ALT key and press V. Type the log name to 
view it. This will allow the captured BBS data to be viewed.
Gregory D. Showalter,
Army Federal Register Liaison Officer.
[FR Doc. 95-17180 Filed 7-12-95; 8:45 am]
BILLING CODE 3710-08-M