[Federal Register Volume 60, Number 109 (Wednesday, June 7, 1995)]
[Rules and Regulations]
[Pages 29981-29982]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-13502]



-----------------------------------------------------------------------


DEPARTMENT OF TRANSPORTATION
14 CFR Part 39

[Docket No. 94-NM-241-AD; Amendment 39-9253; AD 95-12-03]


Airworthiness Directives; Fokker Model F28 Mark 0100 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Fokker Model F28 Mark 0100 series airplanes, that 
requires installation of reinforcement plates at certain fuselage 
stations. This amendment is prompted by a report indicating that cracks 
were found in the frame strips at certain fuselage stations on a Model 
F28 Mark 0100 series airplane test article due to fatigue-related 
stress. The actions specified by this AD are intended to prevent such 
fatigue-related cracking, which could result in reduced structural 
integrity of the fuselage pressure vessel.

DATES: Effective July 7, 1995.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 7, 1995.

ADDRESSES: The service information referenced in this AD may be 
obtained from Fokker Aircraft USA, Inc., 1199 North Fairfax Street, 
Alexandria, Virginia 22314. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer, 
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 
227-2141; fax (206) 227-1320.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Fokker Model F28 Mark 0100 
series airplanes was published in the Federal Register on March 3, 1995 
(60 FR 11944). That action proposed to require installation of 
reinforcement plates at left and right fuselage stations 14911 and 
17011.
    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.
    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.
    The FAA estimates that 45 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 160 work hours per 
airplane to accomplish the required actions, and that the average labor 
rate is $60 per work hour. Required parts will cost approximately 
$3,800 per airplane. Based on these figures, the total cost impact of 
the AD on U.S. operators is estimated to be $603,000, or $13,400 per 
airplane.
    The total cost impact figure discussed above is based on 
assumptions that no operator has yet accomplished any of the 
requirements of this AD action, and that no operator would accomplish 
those actions in the future if this AD were not adopted.
    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 
106(g); and 14 CFR 11.89.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

95-12-03  Fokker: Amendment 39-9253. Docket 94-NM-241-AD.

    Applicability: Model F28 Mark 0100 series airplanes, serial 
numbers 11244 through 11371 inclusive, certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must use the authority 
provided in paragraph (b) to request approval from the FAA. This 
approval may address either no action, if the current configuration 
eliminates the unsafe condition; or different actions necessary to 
address the unsafe condition described in this AD. Such a request 
should include an assessment of the effect of the changed 
configuration on the unsafe condition addressed by this AD. In no 
case does the presence of any modification, alteration, or repair 
remove any airplane from the applicability of this AD.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent cracking in the frame strips at fuselage stations 
14911 and 17011, which could result in reduced structural integrity 
of the fuselage pressure vessel, accomplish the following:
    (a) Prior to the accumulation of 24,000 total flight cycles, or 
within 6 months after the effective date of this AD, whichever 
occurs [[Page 29982]] later, install reinforcement plates at left 
and right fuselage stations 14911 and 17011, in accordance with 
Fokker Service Bulletin SBF100-53-072, dated March 12, 1993.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Standardization Branch, ANM-113, 
FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, 
Standardization Branch, ANM-113.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Standardization Branch, ANM-113.
    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this 0AD can be accomplished.
    (d) The installation shall be done in accordance with Fokker 
Service Bulletin SBF100-53-072, dated March 12, 1993. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from Fokker Aircraft USA, Inc., 1199 
North Fairfax Street, Alexandria, Virginia 22314. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
    (e) This amendment becomes effective on July 7, 1995.

    Issued in Renton, Washington, on May 26, 1995.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 95-13502 Filed 6-6-95; 8:45 am]
BILLING CODE 4910-13-U