[Federal Register Volume 60, Number 105 (Thursday, June 1, 1995)]
[Notices]
[Pages 28587-28588]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-13289]



-----------------------------------------------------------------------


DEPARTMENT OF DEFENSE

MTMC's Re-engineering Personal Property Program Bulletin Board

AGENCY: Military Traffic Management Command (MTMC), DOD.

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: Notice is given that effective April 28, 1995, MTMC will begin 
publishing a weekly update providing information and progress reports 
regarding the Department of Defense Personal Property Program on its 
EasyLink Bulletin Board.

DATES: This action is effectively immediately.

ADDRESSES: Mail comments to Headquarters, Military Traffic Management 
Command, ATTN: MTOP-QE, 5611 Columbia Pike, Falls Church, VA 22041-
5050.

FOR FURTHER INFORMATION CONTACT: Joe DeLucia, MTOP-QE, (703) 756-1292.

SUPPLEMENTARY INFORMATION: MTMC is currently working an initiative to 
re-engineer the DOD Personal Property Program. one concept under 
consideration is competitively acquiring personal property services 
through the use of long-term, full service contracts under the Federal 
Acquisition Regulation. MTMC wishes to keep all interested parties 
informed as to the progress and scope of this effort by publishing a 
weekly update in its EASYLINK bulletin board. Types of 
[[Page 28588]] information addressed will include summaries of 
interested parties' concerns, suggestions, and positions as well as the 
DOD position when applicable. It will also include contemplated service 
requirements for inclusion in a solicitation, notifications and status 
reports, and other relevant information.
    To subscribe to AT&T EasyLink services, carriers may contact AT&T 
EasyLink representative Lynn Phelps at 1-800-346-1557. Procedures to 
access the bulletin board system are as follows:

MTMC BBS Access

    To access the MTMC BBS, a communication software is required. The 
software could be EasyLink's Office Access, Procomm Plus, or some other 
type of off the shelf communication software. Also required is an 
account on the EasyLink network.

Office Access Software

     At the Main Menu type C for the On-line Communication Menu
     At the On-line Communication Menu type F for FYI. The 
software will dial the network and exit into FYI.
     The network will ask for CATEGORY NAME, type MTMC. This 
will place you in the MTMC BBS.
     To maneuver within the BBS to ADCSOPS for Quality.
    a. From the main menu TYPE 2 for the ADSCOPS for Quality.
    b. TYPE 1 for the Re-Engineered Personal Property Program.
    c. TYPE 1 for Contacts.
    d. TYPE 2 for Information.
    As information scrolls across the screen, the information is 
automatically downloaded to the hard drive on your computer.
     Press END key to disconnect from EasyLink.
     Press ESC key and return to the Main Menu.
     Type I to access the Inbound Journal.
     High light the message and Press ENTER to view the BBS 
categories that were scanned.

Procomm Plus Software

     At the Dialing Directory press R to Revise Entry. Type in 
the entry name.
     The remaining setup entries are as follows:
     Number=1-800-325-4112 or 1-800-445-7523.
     BAUD=2400.
     PARITY=Even.
     DATA BITS=7.
     STOP BITS=1.
     DUPLEX=HALF.
     SCRIPT=BLANK.
     PROTOCOL=ASCII.
     TERMINAL=ANSI.
     Press ENTER to dial the network.
     At the EASYLINK ID prompt type your USERID AND PASSWORD.
     At the PTS prompt type EXIT. This will exit the EasyLink 
network and provide an EasyLink Service Menu.
     Press 2 to select FYI.
     Hold down the ALT key and press F1 and type a log name. 
This will open the log and allow the capture of the BBS data as it is 
scanned.
     The network will ask for CATEGORY NAME, type MTMC. This 
will place you in the MTMC BBS.
     To maneuver within the BBS to ADCSOPS for Quality.
    a. From the main menu TYPE 2 for the ADCSOPS for Quality.
    b. TYPE 1 for the Re-Engineered Personal Property Program.
    c. TYPE 1 for Contacts.
    d. TYPE 2 for information.
     The software will automatically capture the categories 
that are typed. After the category scan is completed, press ALT and the 
H keys to logoff.
     Hold down the ALT key and press F1 to close the log.
     Hold down the ALT key and press V. Type the log name to 
view it. This will allow the captured BBS data to be viewed.
Greogry D. Showalter,
Army Federal Register Liaison Officer.
[FR Doc. 95-13289 Filed 5-31-95; 8:45 am]
BILLING CODE 3710-08-M