[Federal Register Volume 60, Number 83 (Monday, May 1, 1995)]
[Notices]
[Pages 21236-21238]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-10641]



-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION
[Docket No. 95-29; Notice 1]


Receipt of Petition for Decision That Nonconforming 1984 and 1985 
Rolls Royce Camargue Passenger Cars Are Eligible for Importation

AGENCY: National Highway Traffic Safety Administration, DOT

ACTION: Notice of receipt of petition for decision that nonconforming 
1984 and 1985 Rolls Royce Camargue passenger cars are eligible for 
importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces receipt by the National Highway Traffic 
Safety Administration (NHTSA) of a petition for a decision that 1984 
and 1985 Rolls Royce Camargues that were not originally manufactured to 
comply with all applicable Federal motor vehicle safety standards are 
eligible for importation into the United States because (1) They are 
substantially similar to vehicles that were originally manufactured for 
importation into and sale in the United States and that were certified 
by their manufacturer as complying with the safety standards, and (2) 
they are capable of being readily altered to conform to the standards.

[[Page 21237]] DATES: The closing date for comments on the petition is 
May 31, 1995.

ADDRESSES: Comments should refer to the docket number and notice 
number, and be submitted to: Docket Section, Room 5109, National 
Highway Traffic Safety Administration, 400 Seventh St., SW., 
Washington, DC 20590. [Docket hours are from 9:30 am to 4 pm].

FOR FURTHER INFORMATION CONTACT: George Entwistle, Office of Vehicle 
Safety Compliance, NHTSA (202-366-5306).

SUPPLEMENTARY INFORMATION:

Background

    Under 49 U.S.C. 30141(a)(1)(A) (formerly section 108(c)(3)(A)(i)(I) 
of the National Traffic and Motor Vehicle Safety Act (the Act)), a 
motor vehicle that was not originally manufactured to conform to all 
applicable Federal motor vehicle safety standards shall be refused 
admission into the United States unless NHTSA has decided that the 
motor vehicle is substantially similar to a motor vehicle originally 
manufactured for importation into and sale in the United States, 
certified under 49 U.S.C. 30115 (formerly section 114 of the Act), and 
of the same model year as the model of the motor vehicle to be 
compared, and is capable of being readily altered to conform to all 
applicable Federal motor vehicle safety standards.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    G&K Automotive Conversion, Inc. of Santa Ana, California (``G&K'') 
(Registered Importer 90-007) has petitioned NHTSA to decide whether 
1984 and 1985 Rolls Royce Camargue passenger cars are eligible for 
importation into the United States. The vehicles which G&K believes are 
substantially similar are the 1984 and 1985 Rolls Royce Camargues that 
were manufactured for importation into, and sale in, the United States 
and certified by its manufacturer, Rolls Royce Motors, Ltd., as 
conforming to all applicable Federal motor vehicle safety standards.
    The petitioner claims that it carefully compared the non-U.S. 
certified 1984 and 1985 Rolls Royce Camargues to their U.S. certified 
counterparts, and found the vehicles to be substantially similar with 
respect to compliance with most Federal motor vehicle safety standards.
    G&K submitted information with its petition intended to demonstrate 
that the non-U.S. certified 1984 and 1985 Rolls Royce Camargues, as 
originally manufactured, conform to many Federal motor vehicle safety 
standards in the same manner as their U.S. certified counterparts, or 
are capable of being readily altered to conform to those standards.
    Specifically, the petitioner claims that the non-U.S. certified 
1984 and 1985 Rolls Royce Camargues are identical to their U.S. 
certified counterparts with respect to compliance with Standard Nos. 
102 Transmission Shift Lever Sequence * * *., 103 Defrosting and 
Defogging Systems, 104 Windshield Wiping and Washing Systems, 105 
Hydraulic Brake Systems, 106 Brake Hoses, 107 Reflecting Surfaces, 109 
New Pneumatic Tires, 113 Hood Latch Systems, 124 Accelerator Control 
Systems, 201 Occupant Protection in Interior Impact, 202 Head 
Restraints, 203 Impact Protection for the Driver From the Steering 
Control System, 204 Steering Control Rearward Displacement, 205 Glazing 
Materials, 206 Door Locks and Door Retention Components, 207 Seating 
Systems, 209 Seat Belt Assemblies, 210 Seat Belt Assembly Anchorages, 
211 Wheel Nuts, Wheel Discs and Hubcaps, 212 Windshield Retention, 216 
Roof Crush Resistance, 219 Windshield Zone Intrusion, and 302 
Flammability of Interior Materials.
    Petitioner also contends that the vehicle is capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: (a) Substitution of a lens 
marked ``Brake'' for a lens with an ECE symbol on the brake failure 
indicator lamp; (b) installation of a seat belt warning lamp; (c) 
recalibration of the speedometer/odometer from kilometers to miles per 
hour.
    Standard No. 108 Lamps, Reflective Devices and Associated 
Equipment: (a) Installation of U.S.- model headlamps and yellow 
illuminated sidemarkers; (b) installation of U.S.- model taillamp 
lenses which incorporate sidemarkers.
    Standard No. 110 Tire Selection and Rims: installation of a tire 
information placard.
    Standard No. 111 Rearview Mirror: Replacement of the passenger side 
rearview mirror with a U.S.-model component.
    Standard No. 114 Theft Protection: Installation of a warning buzzer 
microswitch and a warning buzzer in the steering assembly.
    Standard No. 115 Vehicle Identification Number: Installation of a 
VIN plate that can be read from outside the left windshield pillar, and 
a VIN reference label on the edge of the door or latch post nearest the 
driver.
    Standard No. 116 Brake Fluid: Molding the required statement into 
the brake fluid reservoir cap.
    Standard No. 118 Power Window Systems: Rewiring of the power window 
system so that the window transport is inoperative when the ignition is 
switched off.
    Standard No. 208 Occupant Crash Protection: Installation of a seat 
belt warning buzzer. The petitioner states that Type 2 seat belts are 
installed in the vehicle's front and rear outboard seating positions, 
and that a Type 1 seat belt is installed in the vehicles rear center 
seating position.
    Standard No. 214 Side Impact Protection: Installation of 
reinforcing beams.
    Standard No. 301 Fuel System Integrity: Installation of a rollover 
valve in the fuel tank vent line between the fuel tank and the 
evaporative emissions collection canister.
    Additionally, the petitioner states that the bumpers on the non-
U.S. certified 1984 and 1985 Rolls Royce Camargues must be reinforced 
to comply with the Bumper Standard found in 49 CFR part 581.
    Interested persons are invited to submit comments on the petition 
described above. Comments should refer to the docket number and be 
submitted to: Docket Section, National Highway Traffic Safety 
Administration, Room 5109, 400 Seventh Street SW., Washington, DC 
20590. It is requested but not required that 10 copies be submitted.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above address both before and after 
that date. To the extent possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8.

    [[Page 21238]] Issued on: April 26, 1995.
Marilynne E. Jacobs,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 95-10641 Filed 4-28-95; 8:45 am]
BILLING CODE 4910-59-P