[Federal Register Volume 59, Number 247 (Tuesday, December 27, 1994)]
[Unknown Section]
[Page 0]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 94-31750]


[[Page Unknown]]

[Federal Register: December 27, 1994]


-----------------------------------------------------------------------


DEPARTMENT OF TRANSPORTATION
14 CFR Part 39

[Docket No. 94-NM-214-AD]

 

Airworthiness Directives; Fokker Model F28 Mark 0100 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to certain Fokker Model F28 Mark 0100 
series airplanes. This proposal would require replacement of the flight 
control lock (FCL) handle and switch with a modified unit. This 
proposal is prompted by a report of sudden engagement of the FCL system 
during approach for landing. The actions specified by the proposed AD 
are intended to prevent inadvertent engagement of the FCL system during 
flight and subsequent reduced controllability of the airplane.

DATES: Comments must be received by February 6, 1995.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-103, 
Attention: Rules Docket No. 94-NM-214-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except 
Federal holidays.
    The service information referenced in the proposed rule may be 
obtained from Fokker Aircraft USA, Inc., 1199 North Fairfax Street, 
Alexandria, Virginia 22314. This information may be examined at the 
FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer, 
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 
227-2141; fax (206) 227-1320.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule.The proposals contained in this notice may be changed in 
light of the comments received.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this notice must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 94-NM-214-AD.'' The postcard will be date stamped and 
returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the FAA, Transport Airplane Directorate, ANM-103, Attention: Rules 
Docket No. 94-NM-214-AD, 1601 Lind Avenue, SW., Renton, Washington 
98055-4056.

Discussion

    The Rijksluchtvaartdienst (RLD), which is the airworthiness 
authority for the Netherlands, recently notified the FAA that an unsafe 
condition may exist on certain Fokker Model F28 Mark 0100 series 
airplanes. The RLD advises that it received a report that the 
autothrottle system on a Model F28 Mark 0100 series airplane disengaged 
suddenly while the airplane was on approach for landing. The thrust 
levers could not be moved, and the ailerons were blocked in the 
``NEUTRAL'' position. After recycling the flight control lock (FCL) 
system to the ``UNLOCKED'' and ``LATCHED'' position, the thrust levers 
and ailerons were free to move again. The thrust levers are linked to 
the FCL system to prevent takeoff revolutions per minute (RPM) from 
being selected if the FCL system is locked.
    Investigation revealed that a takeoff configuration warning for the 
FCL system may not be generated, despite the fact that the FCL handle 
is not in the ``UNLOCKED'' and ``LATCHED'' position. On some aircraft, 
the operating forces then may be insufficient to drive the handle back 
into the ``UNLOCKED'' and ``LATCHED'' position, and the flight control 
surface could lock unexpectedly during flight. This condition, if not 
corrected, could result in inadvertent engagement of the FCL and 
subsequent reduced controllability of the airplane.
    Fokker has issued Service Bulletin SBF100-27-051, Revision 1, dated 
May 6, 1994, which describes procedures for replacement of the FCL 
handle and switch with a modified unit. Accomplishment of this 
installation will ensure that a takeoff configuration warning for the 
FCL system is generated if the handle is not latched in the 
``UNLOCKED'' position. The RLD classified this service bulletin as 
mandatory and issued Netherlands airworthiness directive BLA No. 93-088 
(A), dated July 12, 1993, in order to assure the continued 
airworthiness of these airplanes in the Netherlands.
    This airplane model is manufactured in the Netherlands and is type 
certificated for operation in the United States under the provisions of 
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and 
the applicable bilateral airworthiness agreement. Pursuant to this 
bilateral airworthiness agreement, the RLD has kept the FAA informed of 
the situation described above. The FAA has examined the findings of the 
RLD, reviewed all available information, and determined that AD action 
is necessary for products of this type design that are certificated for 
operation in the United States.
    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, the proposed AD would require replacement of the 
FCL handle and switch with a modified unit. The actions would be 
required to be accomplished in accordance with the service bulletin 
described previously.
    As a result of recent communications with the Air Transport 
Association (ATA) of America, the FAA has learned that, in general, 
some operators may misunderstand the legal effect of AD's on airplanes 
that are identified in the applicability provision of the AD, but that 
have been altered or repaired in the area addressed by the AD. The FAA 
points out that all airplanes identified in the applicability provision 
of an AD are legally subject to the AD. If an airplane has been altered 
or repaired in the affected area in such a way as to affect compliance 
with the AD, the owner or operator is required to obtain FAA approval 
for an alternative method of compliance with the AD, in accordance with 
the paragraph of each AD that provides for such approvals. A note has 
been included in this notice to clarify this requirement.
    The FAA estimates that 75 airplanes of U.S. registry would be 
affected by this proposed AD, that it would take approximately 3 work 
hours per airplane to accomplish the proposed actions, and that the 
average labor rate is $60 per work hour. Required parts would cost 
approximately $1,000 per airplane. Based on these figures, the total 
cost impact of the proposed AD on U.S. operators is estimated to be 
$88,500, or $1,180 per airplane.
    The total cost impact figure discussed above is based on 
assumptions that no operator has yet accomplished any of the proposed 
requirements of this AD action, and that no operator would accomplish 
those actions in the future if this AD were not adopted.
    The regulations proposed herein would not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this 
proposal would not have sufficient federalism implications to warrant 
the preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 
106(g); and 14 CFR 11.89.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

Fokker: Docket 94-NM-214-AD.

    Applicability: Model F28 Mark 0100 series airplanes, serial 
numbers 11244 through 11419 inclusive, certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must use the authority 
provided in paragraph (b) to request approval from the FAA. This 
approval may address either no action, if the current configuration 
eliminates the unsafe condition; or different actions necessary to 
address the unsafe condition described in this AD. Such a request 
should include an assessment of the effect of the changed 
configuration on the unsafe condition addressed by this AD. In no 
case does the presence of any modification, alteration, or repair 
remove any airplane from the applicability of this AD.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent reduced controllability of the airplane, accomplish 
the following:
    (a) Within one year after the effective date of this AD, remove 
the existing flight control lock (FCL) handle and switch and replace 
it with a modified FLC handle and switch, in accordance with Fokker 
Service Bulletin SBF100-27-051, Revision 1, dated May 6, 1994.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Standardization Branch, ANM-113, 
FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, 
Standardization Branch, ANM-113.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Standardization Branch, ANM-113.

    (c) Special flight permits may be issued in accordance with 
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 
21.197 and 21.199) to operate the airplane to a location where the 
requirements of this AD can be accomplished.

    Issued in Renton, Washington, on December 20, 1994.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 94-31750 Filed 12-23-94; 8:45 am]
BILLING CODE 4910-13-U