[Federal Register Volume 59, Number 247 (Tuesday, December 27, 1994)]
[Unknown Section]
[Page 0]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 94-30398]
[[Page Unknown]]
[Federal Register: December 27, 1994]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
14 CFR Part 39
[Docket No. 94-NM-67-AD; Amendment 39-9096; AD 94-25-12]
Airworthiness Directives; Raytheon Corporate Jets Model BAe 125-
1000A Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Raytheon Corporate Jets Model BAe 125-1000A
series airplanes, that requires modification of the galley feeder
cables and toilet services fuse. This amendment is prompted by a report
that the gauge size of the existing galley feeder cable is not
compatible with the rating of the currently used toilet services fuse.
The actions specified by this AD are intended to ensure that the
subject cables are compatible with the toilet services fuse in order to
prevent overheating of the cables, which could result in smoke and fire
in the cabin.
DATES: Effective on January 26, 1995.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of January 26, 1995.
ADDRESSES: The service information references in this AD may be
obtained from Raytheon Corporate Jets, Inc., 3 Bishops Square Street,
Albans Road West, Hatfield, Hertfordshire, AL109NE, United Kingdom.
This information may be examined at the Federal Aviation Administration
(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue,
SW., Renton, Washington; or at the Office of the Federal Register, 800
North Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: William Schroeder, Aerospace Engineer,
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206)
227-2148; fax (206) 227-1320.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Raytheon Corporate Jets
Model BAe 125-1000A series airplanes was published in the Federal
Register on July 5, 1994 (59 FR 34396). That action proposed to require
modification of the galley feeder cables and toilet services fuse.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
The FAA has recently reviewed the figures it has used over the past
several years in calculating the economic impact of AD activity. In
order to account for various inflationary costs in the airline
industry, the FAA has determined that it is necessary to increase the
labor rate used in these calculations from $55 per work hour to $60 per
work hour. The economic impact information, below has been revised to
reflect this increase in the specified hourly labor rate.
As a result of recent communications with the Air Transport
Association (ATA) of America, the FAA has learned that, in general,
some operators may misunderstand the legal effect of AD's on airplanes
that are identified in the applicability provision of the AD, but that
have been altered or repaired in the area addressed by the AD. Under
these circumstances, at least one operator appears to have incorrectly
assumed that its airplane was not subject to an AD. On the contrary,
all airplanes identified in the applicability provision of an AD are
legally subject to the AD. If an airplane has been altered or repaired
in the affected area in such a way as to affect compliance with the AD,
the owner or operator is required to obtain FAA approval for an
alternative method of compliance with the AD, in accordance with the
paragraph of each AD that provides for such approvals. A note has been
added to this final rule to clarify this requirement. The FAA has
determined that this addition will neither increase the economic burden
on any operator nor increase the scope of the AD.
The FAA estimates that 4 airplanes of U.S. registry will be
affected by this AD, that it will take approximately 16 work hours per
airplane to accomplish the required actions, and that the average labor
rate is $60 per work hour. Required parts will cost approximately $500
per airplane. Based on these figures, the total cost impact of the AD
on U.S. operators is estimated to be $5,840, or $1,460 per airplane.
The total cost impact figure discussed above is based on
assumptions that no operator has yet accomplished any of the
requirements of this AD action, and that no operator would accomplish
those actions in the future if this AD were not adopted.
The regulations adopted herein will not have substantial direct
effects on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, in
accordance with Executive Order 12612, it is determined that this final
rule does not have sufficient federalism implications to warrant the
preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant impact, positive or negative, on a substantial number of
small entities under the criteria of the Regulatory Flexibility Act. A
final evaluation has been prepared for this action and it is contained
in the Rules Docket. A copy of it may be obtained from the Rules Docket
at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C.
106(g); and 14 CFR 11.89.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
94-25-12 Raytheon Corporate Jets, Inc.: Amendment 39-9096. Docket
94-NM-67-AD.
Applicability: Model BAe 125-1000A series airplanes; as listed
in Hawker-Raytheon Corporate Jets Service Bulletin SB.25-76-
25A698A&B, dated February 10, 1994, and Hawker-Raytheon Corporate
Jets Service Bulletin SB.25-75-25A699A, dated February 10, 1994;
certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must use the authority
provided in paragraph (c) to request approval from the FAA. This
approval may address either no action, if the current configuration
eliminates the unsafe condition; or different actions necessary to
address the unsafe condition described in this AD. Such a request
should include an assessment of the effect of the changed
configuration on the unsafe condition addressed by this AD. In no
case does the presence of any modification, alteration, or repair
remove any airplane from the applicability of this AD.
Compliance: Required as indicated, unless accomplished
previously.
To prevent smoke and fire in the cabin due to overheating of
galley cables, accomplish the following:
(a) For airplanes listed in Hawker-Raytheon Corporate Jets
Service Bulletin SB.25-76-25A698A&B, dated February 10, 1994: With
100 hours time-in-service after the effective date of this AD,
install Modification 25A698A&B in accordance with that service
bulletin.
(b) For airplanes listed in Hawker-Raytheon Corporate Jets
Service Bulletin SB.25-75-25A699A, dated February 10, 1994: Within
100 hours time-in-service after the effective date of this AD,
install Modification 25A699A in accordance with that service
bulletin.
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Standardization Branch, AMS-113,
FAA, Transport Airplane Directorate. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager,
Standardization Branch, ANM-113.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Standardization Branch, ANM-113.
(d) Special flight permits may be issued in accordance with
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR
21.197 and 21.199) to operate the airplane to a location where the
requirements of this AD can be accomplished.
(e) The installation shall be done in accordance with Hawker-
Raytheon Corporate Jets Service Bulletin SB.25-76-25A698A&B, dated
February 10, 1994, or Hawker-Raytheon Corporate Jets Service
Bulletin SB.25-75-25A699A, dated February 10, 1994, as applicable.
This incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from Raytheon Corporate Jets, Inc.,
Customer Support Department, Adams Field, P.O. Box 3356, Little
Rock, Arkansas 72203. Copies may be inspected at the FAA, Transport
Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or
at the Office of the Federal Register, 800 North Capitol Street,
NW., suite 700, Washington, DC.
(f) This amendment becomes effective on January 26, 1995.
Issued in Renton, Washington, on December 5, 1994.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 94-30398 Filed 12-23-94; 8:45 am]
BILLING CODE 4910-13-M