[Federal Register Volume 59, Number 186 (Tuesday, September 27, 1994)]
[Unknown Section]
[Page 0]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 94-23871]


[[Page Unknown]]

[Federal Register: September 27, 1994]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION
[Docket No. 94-76; Notice 1]

 

Notice of Receipt of Petition for Decision that Nonconforming 
1971 Iso Grifo Lusso Passenger Cars Are Eligible for Importation

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Notice of receipt of petition for decision that nonconforming 
1971 Iso Grifo Lusso passenger cars are eligible for importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces receipt by the National Highway Traffic 
Safety Administration (NHTSA) of a petition for a decision that a 1971 
Iso Grifo Lusso that was not originally manufactured to comply with all 
applicable Federal motor vehicle safety standards is eligible for 
importation into the United States because (1) it is substantially 
similar to a vehicle that was originally manufactured for importation 
into and sale in the United States and that was certified by its 
manufacturer as complying with the safety standards, and (2) it is 
capable of being readily altered to conform to the standards.

DATES: The closing date for comments on the petition is October 27, 
1994.

ADDRESSES: Comments should refer to the docket number and notice 
number, and be submitted to: Docket Section, Room 5109, National 
Highway Traffic Safety Administration, 400 Seventh St., SW., 
Washington, DC 20590. [Docket hours are from 9:30 am to 4 pm].

FOR FURTHER INFORMATION CONTACT: Ted Bayler, Office of Vehicle Safety 
Compliance, NHTSA (202-366-5306).

SUPPLEMENTARY INFORMATION: 

Background

    Under 49 U.S.C. Sec. 30141(a)(1)(A) (formerly section 
108(c)(3)(A)(i)(I) of the National Traffic and Motor Vehicle Safety Act 
(the Act)), a motor vehicle that was not originally manufactured to 
conform to all applicable Federal motor vehicle safety standards shall 
be refused admission into the United States unless NHTSA has decided 
that the motor vehicle is substantially similar to a motor vehicle 
originally manufactured for importation into and sale in the United 
States, certified under 49 U.S.C. Sec. 30115 (formerly section 114 of 
the Act), and of the same model year as the model of the motor vehicle 
to be compared, and is capable of being readily altered to conform to 
all applicable Federal motor vehicle safety standards.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR Part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    G&K Automotive Conversion, Inc. of Santa Ana, California (``G&K'') 
(Registered Importer 90-007) has petitioned NHTSA to decide whether 
1971 Iso Grifo Lusso passenger cars are eligible for importation into 
the United States. The vehicle which G&K believes is substantially 
similar is the 1971 Iso Grifo Lusso that was manufactured for 
importation into, and sale in, the United States and certified by its 
manufacturer, Iso Automotoveicoli, as conforming to all applicable 
Federal motor vehicle safety standards.
    The petitioner claims that it carefully compared the non-U.S. 
certified 1971 Iso Grifo Lusso to its U.S. certified counterpart, and 
found the two vehicles to be substantially similar with respect to 
compliance with most Federal motor vehicle safety standards.
    G&K submitted information with its petition intended to demonstrate 
that the non-U.S. certified 1971 Iso Grifo Lusso, as originally 
manufactured, conforms to many Federal motor vehicle safety standards 
in the same manner as its U.S. certified counterpart, or is capable of 
being readily altered to conform to those standards.
    Specifically, the petitioner claims that the non-U.S. certified 
1971 Iso Grifo Lusso is identical to its U.S. certified counterpart 
with respect to compliance with Standards Nos. 102 Transmission Shift 
Lever Sequence. . . ., 103 Defrosting and Defogging Systems, 105 
Hydraulic Brake Systems, 106 Brake Hoses, 107 Reflecting Surfaces, 108 
Lamps, Reflective Devices and Associated Equipment, 109 New Pneumatic 
Tires, 110 Tire Selection and Rims, 111 Rearview Mirrors, 113 Hood 
Latch Systems, 116 Brake Fluid, 201 Occupant Protection in Interior 
Impact, 202 Head Restraints, 203 Impact Protection for the Driver From 
the Steering Control System, 204 Steering Control Rearward 
Displacement, 205 Glazing Materials, 206 Door Locks and Door Retention 
Components, 207 Seating Systems, 208 Occupant Crash Protection, 209 
Seat Belt Assemblies, 210 Seat Belt Assembly Anchorages, 211 Wheel 
Nuts, Wheel Discs and Hubcaps, 212 Windshield Retention, and 301 Fuel 
System Integrity.
    Petitioner also contends that the vehicle is capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: (a) substitution of a lens 
marked ``Brake'' for a lens with an ECE symbol on the brake failure 
indicator lamp; (b) placement of a hazard symbol on the hazard warning 
signal switch.
    Standard No. 114 Theft Protection: installation of a warning device 
to be activated when the key is left in the steering lock assembly and 
the driver's door is opened.
    Standard No. 115 Vehicle Identification Number: installation of a 
VIN plate that can be read from outside the left windshield pillar, and 
a VIN reference label on the edge of the door or latch post nearest the 
driver.
    Interested persons are invited to submit comments on the petition 
described above. Comments should refer to the docket number and be 
submitted to: Docket Section, National Highway Traffic Safety 
Administration, Room 5109, 400 Seventh Street, S.W., Washington, DC 
20590. It is requested but not required that 10 copies be submitted.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above address both before and after 
that date. To the extend possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141 (a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8.

    Issued on: September 22, 1994.
William A. Boehly,
Associate Administrator for Enforcement.
[FR Doc. 94-23871 Filed 9-26-94; 8:45 am]
BILLING CODE 4910-59-M