[Congressional Record Volume 167, Number 88 (Thursday, May 20, 2021)]
[Senate]
[Page S3295]
From the Congressional Record Online through the Government Publishing Office [www.gpo.gov]

  SA 1885. Mr. HAGERTY (for himself, Mr. Inhofe, Mr. Shelby, Mr. Scott 
of Florida, Mr. Tuberville, Mr. Tillis, Mr. Cornyn, and Mrs. Blackburn) 
submitted an amendment intended to be proposed to amendment SA 1502 
proposed by Mr. Schumer to the bill S. 1260, to establish a new 
Directorate for Technology and Innovation in the National Science 
Foundation, to establish a regional technology hub program, to require 
a strategy and report on economic security, science, research, 
innovation, manufacturing, and job creation, to establish a critical 
supply chain resiliency program, and for other purposes; which was 
ordered to lie on the table; as follows:

       In section 4111, strike paragraph (5).
       In section 4112(2), strike subparagraphs (A) through (C) 
     and insert the following:
       (A) all iron and steel used in the project are produced in 
     the United States; or
       (B) the manufactured products used in the project are 
     produced in the United States.
       In section 4112(6), strike subparagraphs (A) through (C) 
     and insert the following:
       (A) in the case of iron or steel products, that all 
     manufacturing processes, from the initial melting stage 
     through the application of coatings, occurred in the United 
     States; and
       (B) in the case of manufactured products, that--
       (i) the manufactured product was manufactured in the United 
     States; and
       (ii) the cost of the components of the manufactured product 
     that are mined, produced, or manufactured in the United 
     States is greater than 55 percent of the total cost of all 
     components of the manufactured product, unless another 
     standard for determining the minimum amount of domestic 
     content of the manufactured product has been established 
     under applicable law or regulation.
       In section 4114(a), strike ``manufactured products, and 
     construction materials'' and insert ``and manufactured 
     products''.
       In section 4114(b)(2), strike ``manufactured products, or 
     construction materials'' and insert ``or manufactured 
     products''.
       In section 4114(b)(3), strike ``manufactured products, or 
     construction materials'' and insert ``or manufactured 
     products''.
       In section 4115, strike subsection (b).
       In section 4116(c), strike ``manufactured product, or 
     construction material'' and insert ``or manufactured 
     product''.
       In section 4117(a), strike ``manufactured products, and 
     construction materials'' and insert ``and manufactured 
     products''.
                                 ______