[Title 40 CFR 185.1300]
[Code of Federal Regulations (annual edition) - July 1, 1996 Edition]
[Title 40 - PROTECTION OF ENVIRONMENT]
[Chapter I - ENVIRONMENTAL PROTECTION AGENCY--(Continued)]
[Subchapter E - PESTICIDE PROGRAMS]
[Part 185 - TOLERANCES FOR PESTICIDES IN FOOD]
[Subpart B - Food Additives Permitted in Food for Human Consumption]
[Sec. 185.1300 - Cyano(3-phenoxyphenyl)methyl-4-chloro-alpha-(1-methylethyl)benzeneacetate and its S,S isomer.]
[From the U.S. Government Publishing Office]




  40
  PROTECTION OF ENVIRONMENT
  11
  1996-07-01
  1996-07-01
  false
  
  185.1300
  Sec. 185.1300
  
    PROTECTION OF ENVIRONMENT
    ENVIRONMENTAL PROTECTION AGENCY--(Continued)
    PESTICIDE PROGRAMS
    TOLERANCES FOR PESTICIDES IN FOOD
    Food Additives Permitted in Food for Human Consumption
  


Sec. 185.1300  Cyano(3-phenoxyphenyl)methyl-4-chloro-alpha-(1-methylethyl)benzeneacetate and its S,S isomer.

    (a) A food additive tolerance of 0.05 part per million is 
established for residues of the insecticide cyano(3-
phenoxyphenyl)methyl-4-chloro-alpha-(1-methylethyl)benzeneacetate and an 
isomer, (S)-cyano(3-phenoxyphenyl)methyl-(S)-4-chloro-alpha-(1-
methylethyl)-benzeneacetate, as follows:
    (1) In or on all food items (other than those already covered by a 
higher tolerance as a result of use on growing crops) in food-handling 
establishments where food products are held, processed, or prepared.
    (2) Application of cyano(3-phenoxyphenyl)methyl-4-chloro-alpha-(1-
methylethyl)benzeneacetate shall be limited to space treatment with a 
maximum of 0.5 fluid ounce of a 0.05-percent active ingredient solution 
per 1,000 cubic feet of space, or as a contact spray applied as a coarse 
wet spray at a maximum of 1 gallon of a 0.2-percent active ingredient 
solution per 1,000 square feet of surface. Food must be removed or 
covered during treatment. Spray should not be applied directly to 
surfaces or utensils that may come into contact with food. Food-contact 
surfaces and equipment should be thoroughly cleaned with an effective 
cleaning compound and rinsed with potable water before using.
    (3) Application of (S)-cyano(3-phenoxyphenyl) methyl-(S)-4-chloro-
alpha-(1-methylethyl)benzeneacetate shall be limited to space treatment 
with a maximum of 1.0 fluid ounce of a 0.25-percent active ingredient 
solution per 1,000 cubic feet of space, or as a contact spray applied as 
a coarse wet spray at a maximum of 1 gallon of a 0.05-percent active 
ingredient solution per 1,000 square feet of surface, or as a 
pressurized spot/crack and crevice spray of a 0.25-percent solution. 
Food must be removed or covered during treatment. Spray should not be 
applied

[[Page 491]]

directly to surfaces or utensils that may come into contact with food. 
Food-contact surfaces and equipment should be throroughly cleaned with 
an effective cleaning compound and rinsed with potable water before 
using.
    (4) To assure safe use of the additive, its label and labeling shall 
conform to that registered with the U.S. Environmental Protection 
Agency, and it shall be used in accordance with such label and labeling.
    (b) [Reserved]

[55 FR 26442, June 28, 1990]