[Congressional Bills 106th Congress]
[From the U.S. Government Publishing Office]
[S. 1736 Introduced in Senate (IS)]







106th CONGRESS
  1st Session
                                S. 1736

 To amend the Fair Labor Standards Act of 1938 to permit certain youth 
              to perform certain work with wood products.


_______________________________________________________________________


                   IN THE SENATE OF THE UNITED STATES

                            October 15, 1999

  Mr. Specter introduced the following bill; which was read twice and 
  referred to the Committee on Health, Education, Labor, and Pensions

_______________________________________________________________________

                                 A BILL


 
 To amend the Fair Labor Standards Act of 1938 to permit certain youth 
              to perform certain work with wood products.

    Be it enacted by the Senate and House of Representatives of the 
United States of America in Congress assembled,

SECTION 1. EXEMPTION.

    Section 13(c) of the Fair Labor Standards Act of 1938 (29 U.S.C. 
213(c)) is amended by adding at the end the following:
    ``(6)(A) Subject to subparagraph (B), in the administration and 
enforcement of the child labor provisions of this Act, it shall not be 
considered oppressive child labor for an individual who--
            ``(i) is under the age of 18 and over the age of 14, and
            ``(ii) by statute or judicial order is exempt from 
        compulsory school attendance beyond the eighth grade,
to be employed inside or outside places of business where machinery is 
used to process wood products.
    ``(B) The employment of an individual under subparagraph (A) shall 
be permitted--
            ``(i) if the individual is supervised by an adult relative 
        of the individual or is supervised by an adult member of the 
        same religious sect or division as the individual;
            ``(ii) if the individual does not operate or assist in the 
        operation of power-driven woodworking machines;
            ``(iii) if the individual is protected from wood particles 
        or other flying debris within the workplace by a barrier 
        appropriate to the potential hazard of such wood particles or 
        flying debris or by maintaining a sufficient distance from 
        machinery in operation; and
            ``(iv) if the individual is required to use personal 
        protective equipment to prevent exposure to excessive levels of 
        noise and saw dust.''.
                                 <all>