113 HR 4441 IH: American Pipeline Jobs and Safety Act of 2014 U.S. House of Representatives 2014-04-09 text/xml EN Pursuant to Title 17 Section 105 of the United States Code, this file is not subject to copyright protection and is in the public domain.

I 113th CONGRESS 2d Session H. R. 4441 IN THE HOUSE OF REPRESENTATIVES April 9, 2014 Mr. Nolan introduced the following bill; which was referred to the Committee on Transportation and Infrastructure, and in addition to the Committee on Energy and Commerce, for a period to be subsequently determined by the Speaker, in each case for consideration of such provisions as fall within the jurisdiction of the committee concerned A BILL To require pipelines regulated by the Secretary of Transportation to be made of steel that is produced in the United States and originates from iron ore and taconite mined and processed in the United States, for safety, and for other purposes.

1.

Short title

This Act may be cited as the American Pipeline Jobs and Safety Act of 2014.

2.

American steel

Section 60102 of title 49, United States Code, is amended by adding at the end the following new subsection: (q)

American steel

(1)

In general

Not later than 1 year after the date of enactment of this subsection, the Secretary shall prescribe minimum safety standards requiring that any pipeline subject to this chapter that is constructed or replaced after such date of enactment be made of steel that— (A)is produced in the United States; and (B)originates from iron ore and taconite mined and processed in the United States. (2)

Use of recycled materials

For purposes of this subsection, steel that is recycled in the United States shall be considered to be steel described in subparagraphs (A) and (B) of paragraph (1) if the recycled materials are combined with iron ore and taconite mined and processed in the United States. (3)

Waivers

(A)

In general

In prescribing safety standards under this subsection, the Secretary shall permit a waiver of the requirements of paragraph (1) to the extent that the Secretary determines such a waiver is necessary based on the estimate prepared under subparagraph (B). (B)

Annual demand and supply estimate

The Secretary shall prepare annually an estimate of— (i)the amount of steel likely to be needed to be produced to meet the requirements of paragraph (1); and (ii)the production capacity of United States producers of steel described in subparagraphs (A) and (B) of such paragraph. (C)

Approval of sources

The Secretary shall ensure that steel permitted to be used in pipelines pursuant to a waiver under this paragraph meets the same standards as steel described in subparagraphs (A) and (B) of paragraph (1), and shall publish a list of approved sources of steel so permitted. .

3.

Inspection and testing

(a)

Testing

Section 60108(b) of title 49, United States Code, is amended by adding at the end the following new paragraph: (4)Testing under this subsection shall include direct, pre-installation testing by the Secretary of pipelines for quality verification.. (b)

Authorization of appropriations

Section 60125 of title 49, United States Code, is amended by adding at the end the following new subsection: (d)

Inspection and testing

There is authorized to be appropriated $10,000,000 for each fiscal year to carry out direct, pre-installation inspection and testing of pipelines under this chapter, including testing of pipelines under section 60108(b)(4) and testing and inspection of steel pursuant to section 60102(q)..